Q.3/ Complete the following sentences, Select 10 only; - 1. The powder that present on slip surface of fault is called. 2. Contour lines of horizontal beds are always...... 3. Splendid luster is present in ************ ******** 4. The vertical distance between any two adjacent contour lines is nominated 5. Sedimentary rock with more than 80% of fossil tests is defined as 6. The discontinuity that separated sial and sima is. 7. Symmetry is ***** 8. The wave that can pass through all media is ........... 9. ***** ........... means some light can pass through the matter. .......... angle means intersection of three or more crystal faces. 11. The crust and most upper part of mantle is called. 10.

Q.3/ Complete the following sentences, Select 10 only; - 1. The powder that present on slip surface of fault is called. 2. Contour lines of horizontal beds are always...... 3. Splendid luster is present in ****** 4. The vertical distance between any two adjacent contour lines is nominated 5. Sedimentary rock with more than 80% of fossil tests is defined as 6. The discontinuity that separated sial and sima is. 7. Symmetry is * 8. The wave that can pass through all media is ........... 9. *** ........... means some light can pass through the matter. .......... angle means intersection of three or more crystal faces. 11. The crust and most upper part of mantle is called. 10.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Shear Strength Of Soil

Section: Chapter Questions

Problem 10.22P

See similar textbooks

Similar questions

24.A series of consolidated, undrained triaxial tests were carried out on specimens of asaturated clay under no backpressure. The test data at failure are summarized:Confiningpressure (kPa) Deviator stress(kPa) Pore waterpressure (kPa) 150 192 80300 341 154450 504 222 a. Draw the Mohr circles and find the cohesion and friction angles in terms of effectivestresses.b. Compute Skempton’s A- parameter at failure for all three specimens.c. Is the soil normally consolidated or over consolidated? Why?d. Another specimen of the same day that was consolidated under a cell pressure of 250 kPa wassubjected to a consolidated, drained tri axial test. What would be the deviator stress at failure?
Steel plates with mass of 1500 g each were stacked on topof a 75 mm diameter and 150 mm high clay specimen,as shown in Figure P2.22 (attached). If the undrained shear strengthof the specimen is 45.0 kN/m2, how many plates can bestacked before the specimen fails? What is the consistencyterm for this clay?
Determine void ratio If porosity value is 0.66
A consolidated-undrained test on a normally consolidate clay yield the following results: Confining Pressure = 151 KPa; Deviator Stress = 187 KPa; Pore Pressure = 71 KPa. Calculate the consolidated undrained friction angle. Please answer this asap. For upvote. Thank you very much
A rock core sample with a diameter of 47.6 mm and a length of 11.21 cm is loaded in uniaxial compressionThe difference in length and diameter recorded during testing are respectively 0.36 mm and 0.044mm for anaxial stress of 78 MPaCalculate the Elastic modulus (GPa) and Poison's ratio tor that rock snecimen.?
Hand draw the SWCC of sand as a relationship between gravimetric water content, versus suction and degree of saturation, S versus suction.
Define the term critical void ratio.
choose the correct answer with explanation: 1)Which of the following tests aims to know the extent of the soil's ability to be a base layer for the road or sub-base layer: a)California bearing ratio test b) Soil field density test. c) Attereberg limits test d)One - Dimensional Consolidation of Soil test 2)The sides of the drilling shall be reinforced when laying the pipelines : a)before drilling b)in the case of large diameters c)in all cases d) according to the type of soil and the depth 3)The concrete is compacted with shaking: a)by pumping air to compact it b)to expel the air c)only for concrete with a low drop(low slump test value) d)only for concrete with a large drop( high slump test value) 4)The following soil can be used for the purpose of filling a) sand and clay mixture in a ratio of 1: 1 b) sand and clay mixture in a ratio of 1: 2 c) sand and clay mixture in a ratio of 1:3 d) Only coarse sand Please kindly answer all????? help me with all answers.... Do not skip any answers…
A site is underlain by a saturated clay layer with thickness = 5m. A sample extracted from the center of the clay layer was recently tested for consolidation parameters. The results indicate that the compression index is 0.33, the recompression index is 0.09, and the void ratio is 1.2. The results also indicate that the layer is normally consolidated. Calculate the preconsolidation stress of the clay. Express your answer in kPa. Note: this is a short problem; read the problem statement carefully. Use unit water weight = 10 kN/m3.
A soil deposit has three layers having samethickness each but the permeability's ofthe layers are in the ratio of 1:2:4 fromtop to bottom. What is the ratio of averagepermeability in the horizontal direction tothat in the vertical direction?
What is the critical void ratio?
Geotechnical Engineering (UPVOTE WILL BE GIVEN. PLEASE ANSWER THE QUESTION CORRECLTY. NO LONG EXPLANATION NEEDED. FOLLOW THE INSTRUCTIONS CAREFULLY.) Given the laboratory results of the Atterberg limits test in the given figure. Use Logarithmic Interpolation for the value of water content correspond to the required number of blows for the Liquid Limit. Determine the ff: (3 decimal places - Do not round off unless it's the final answer)a. Liquidity Index ___________b. Description/Nature of soil based on LI _____________