Q1: A mass mis tied to a string and made to move in avertical circle of radius rwith constant speed v. For this, caculate the tention in the string at the lowest and highest point of the circle, also findout the minimum speed so that the string never goes slack.

Q1: A mass mis tied to a string and made to move in avertical circle of radius rwith constant speed v. For this, caculate the tention in the string at the lowest and highest point of the circle, also findout the minimum speed so that the string never goes slack.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.48P: Find the smallest distance d for which the hook will remain at rest when acted on by the force P....

See similar textbooks

Related questions

Q: A ball of mass m1 and a block of mass m2 are attached by a lightweight cord that passes over a…

A: Draw a free-body diagram of the given system. Part (a) Apply Newton's second law to the mass m1,…

Q: Problem 4.64 Find u such that the crate's speed at the bottom of the chute (immedi- ately before the…

A: Given: v = 15 ft/s u = 14 ft/s s = 14 ft

Q: The coefficient of kinetic friction under block A in Fig. 24-A is 0.30 and under block B is 0.20.…

Q: (2) LXercise 4: A simple pendulum is formed of a small bob of mass m=200g, suspended to a massless…

A: Since we only answer up to 3 subparts so we will answer up to 3. Please resubmit the question by…

Q: A 10-kg body is pulled upward with an acceleration of 0.40 m/s. Calculate the tension in the cord.

A: Mass (m) = 10 kg Acceleration (a) = 0.4 ms2

Q: Problem 4: A projectile is fired horizontally at a speed of 8 m/s from an 80-m-high cliff. Find (a)…

Q: In the diagram below, a force P of 750 N is applied to the 350 kg block. Find the acceleration of…

Q: In the system shown, a spring is compressed and pushes a mass of 50Kg down the path shown with two…

A: To obtain the required compression of the spring, we must use the concept of energy balance. The…

Q: Given a small disk (4-Kg) sliding on top of a smooth table which is connected to an elastic cord…

Q: The system in the figure is released from a standstill. Using the conservation of energy, Find the…

A: The free-body diagram of the system is shown as the velocity at the starting point will be zero and…

Q: 4 5. A hydraulic piston is exciting force on a platform with radius of /m. She magnitude is F-51" t…

Q: A ball of mass m, and a block of mass m, are attached by a lightweight cord that passes over a…

A: From the Newtons second law on the ball, For the ball to accelerate upwards, the necessary…

Q: Ex. (4): The figure shows a 1-kg collar that slides along the frictionless vertical rod under the…

Q: On a rough inclined plane (inclination angle a, kinetic friction constant u), a block (mass m1) is…

A: (a) Consider the free body diagram for the given system when the mass m1 slides upward, From the…

Q: A block of mass m,= 20kg is attached to a spring with a spring constant k 100N/m and dropped from…

Q: A carton is given a push across a horizontal surface. The carton has a mass m, the push gives it an…

A: Given: The initial speed is v=2.30 m/s. The coefficient of kinetic friction is μk=0.145. (a) As…

Q: Four masses m1, m2, m3 and m4 are 10 kg, 20 kg, 30 kg and 40 kg respectively. The corresponding…

Q: A block of mass m1 is located on an inclined plane θ and attached by a rope passing over a pulley…

A: m1 = mass of body 1 m2 = mass of body 2 m1 > m2 T = tension a = acceleration g = acceleration due…

Q: H.W.1 Honda CR-V is a midsize SUV car with m= 1550 kg, l= 2620mm Assume a, = az, h= 720mm, Hx=0.8…

Q: Show full solution A 400-N body starts up the incline of 30o with the horizontal (fk = 0.2) with a…

Q: The motor M pulls in its attached rope with an acceleration a, = 9 m/s² . The coefficient of kinetic…

A: Given:ap=9 m/s2μk=0.2mass of the crate, m=80 kgangle of plane, θ=30o

Q: Three friends ride a Ferris wheel with a diameter of 79m. Their combined mas with each car of the…

A: Given Data: The Diameter of a Ferris wheel is (d) = 79 m The Radius of a Ferris wheel is (r) =…

Q: In the system shown, a spring is compressed and pushes a mass of 50Kg down the path shown with two…

A: To obtain the compression of the spring, we must use the concept of energy balance as given below-…

Q: 1. Consider the system shown below. Block A weighs 95.0N and block B weighs 55.0N. Once block B is…

A: Weight of block A = 95N Weight of block B = 55N Block B is set to move downward at constant…

Q: Q5: Calculate the vertical acceleration a of the 100lb cylinder for each of the two cases…

Q: A 75-kg man stands on a spring scale in an elevator. During the first 3 seconds of motion from…

Q: Q3: In the system, find the motion equation of the mass (m).

Q: (Figure 1)Block 1, of mass mı, is conn (massless and frictionless) pulley to block 2, of mass m2, as…

Q: (a) Find expressions for the mass's (vertical) velocity v(t) (relative to its equilibrium position)…

Q: A spring is stretched 4 inches by a 4 pound weight. The 2 lb weight is started from the equilibrium…

A: Mass = 4 lb = 1.81437 kg. x = 4 inch = 0.1016 m, kx=mgk=mgxk=1.81437×9.810.1016k=175.2 N/m, m1 =…

Q: Q1. Two boxes are connected by a cord running over a pulley. The coefficient of Kinetic friction…

Q: The pulley in Fig has radius R and a moment of inertia I. The rope does not slip over the pulley,…

A: Consider the Free Body diagram: Initial energy of the system,Ei=mBgd Final energy of the…

Q: Three blocks are connected over two frictionless, massless pulleys by two inextensible, massless…

Q: LO5kg The figure above shows a block rotating in a vertical circle at the end of a string. At P, the…

Q: The 50 kg block shown in the figure is set in motion without an initial velocity when x₀=150 mm and…

A: Given: Mass m=50kg k=200N/m At t=0, X0=150mm or 0.150mm Solution: When c=200Ns/m Natural frequency…

Q: 6. Masses A (2.00 kg) and B (3.00 kg) are connected to each other with string over two pulleys as…

Q: Suppose that the system block plus cart is moving with constant speed v along the inclined plane of…

Q: Block A weight 500N and block B weighs 20ON. The coefficien of friction under B is 0,2. Find the…

A: here I assumed acceleration due to gravity (g) =9.81 m/s^2.for solution refer below images.

Q: A model airplane of mass 0.750 kg flies in a horizontal circle at the end of a 60 cm control wire,…

A: The mass of airplane model m = 0.750 kgLength of control wire l = 60 cm = 0.60 mThe speed of…

Q: In the system in which the first starts to move without speed, the masses of 10, 1 kg each, with the…

Q: Problem 4 A crate of mass M rests on a horizontal plane having a coefficient of kinetic friction Hx.…

A: Velocity of crate after t seconds will be, v=[PM(cosθ+μksinθ)-μkg]t.

Q: 2. kütlelsr durgun halden a Her bir bloaun üZerine diyanrami), her bir blogun le- b) plardeki…

A: 1. friction coefficient between blocks - . 3 2. Horizontal plane and rollers are frictionless 3.…

Question

100%

Q1: A mass mis tied to a string and made to move in avertical circle of radius r with constant speed
v. For this, caculate the tention in the string at the lowest and highest point of the circle, also
findout the minimum speed so that the string never goes slack.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Elastic Constants and Their Relationship

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of the earth.
A block of mass m1 is located on an inclined plane θ and attached by a rope passing over a pulley with a weight of mass m2. If m1 > m2 find the tension and the acceleration.
Engineering dynamics 1. dtermine the speed 2. determine the tension T is the mass is 10lbs
550 g static mass Time to Complete 60 Revolutions 39 sec Radius of Rotation for the Rotating Mass . 144 m Mass of the Rotating Mass . 449 kg % Difference Between the Static ans Centripetal Forces
As seen in the figure, three masses are connected to each other with the system set up on a table. Table friction and kinetic coefficient of friction is 0.35. (g = 10m / s2). b) Find the acceleration of each mass. c) Find the tensile forces on the ropes. d) How many meters will the object of 6kg go down after t = 3s after the system is released?
In a governor of the Hartnell type the arms of the bell-crank leversare equal in length, and those carrying the operating masses arevertical when the governor is rotating at its mean speed of 775rev/min, with the masses moving in a circle of 175 mm diameter -The usual central controlling spring is replaced by two paralleltension springs direetly connecting the operating masses. Find(a) the magnitude of each operating mass if a force of 90 N isrequired at the sleeve to maintain it in the mean speed positionwhen the specd is increased from 775 to 800 rev/m in(b) the stiffness, or rate, of each spring if the ratio of sleevemovement to increase of speed is 1 mm to 10 revImin when inthe mean speed position.
Find the weight suspended from a vertical spring whose modulus is 100 lbs/ft and around 2 seconds as its period of motion.
4. A concrete weight of 125 kg is released from standstill and a log of mass 200 kg is moved along an inclined area of 30° to the horizontal.When the concrete weight is moved down 5 m, find that 1. What is the speed of the log? 2. What is the movement time of the concrete drum?
An object, m1 with a mass of 10.0 kg placed on a frictionless, horizontal table. It is connected to a string that passes over a pulley and then is fastened to a hanging object, m2 with a mass of 14.0 kg. a. The tension in the string is? b. Find the magnitude of the acceleration of the objects
The diagram shows two blocks, one 3 kg and the other 9 kg, hanging connected to the same string that passes over an ideal pulley. What acceleration do the blocks have when released from rest?
In a modified version of the cart and bucket, the angle of the slope is alpha = 34.9∘ and the bucket weighs 295 N. The cart moves up the incline and the bucket moves downward, both at constant speed. The cable has negligible mass, and there is no friction. What is the weight of the cart?What is the tension in the cable?
A spring-based toy gun is used to shoot a ball of mass M straight up.The ball is not attached to the spring. The ball is pushed downward into the spring so that the spring is compressed toa distance S below its relaxation point. After the release, the ball reaches a maximum height 3S,measured from its relaxation position, see Fig. 1(b). (a) Find the constant of the spring. (b) Findthe equilibrium point of the ball when it is on the compressed spring with no forces other than gravity and thespring acting on it. Clearly indicate the point you are using as the origin of your coordinate system and which direction is positive.system and which direction is positive. (c) Now the ball is glued to the spring so that it oscillates up and downinstead of flying off the spring. The spring is again compressed to the same distance S below itsof relaxation. Write an equation for the position of the ball as a function of time after it is released. Indicateclearly which point you are using as the origin…