Q1) Air enters a converging-diverging nozzle as shown in the Figure. 1 . Determine : The conditions(M, P,T) upstream and downstream ifthe normal shock which is located at the nozzle exit. Also calculate entropy across the shock. Ae-0.0724m? At-0,025 m To=30°C Po=101 kPa

Q1) Air enters a converging-diverging nozzle as shown in the Figure. 1 . Determine : The conditions(M, P,T) upstream and downstream ifthe normal shock which is located at the nozzle exit. Also calculate entropy across the shock. Ae-0.0724m? At-0,025 m To=30°C Po=101 kPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A constant area adiabatic wind tunnel is to be designed to provide a test section of air flowing at…

A: Given Data The mach number is: M=3 The pressure is: 7 kPa The temperature is: 255 K The stagnation…

Q: Air flows through a converging-diverging nozzle. The air has total head density of 1.23 Kg/m3. For…

A: Given data as per the question Air density =1.23 kg/m3 Throat diameter =5 cm M =0.8 V =300 m/s

Q: Q.4. Air is fed from a large reservoir, where the temperature and pressure are 280 K and 300 kPa…

Q: Air expands from a storage tank through a converging-diverging nozzle. (See Figure P4.4.) Under…

Q: 5-Which of the following is true for a Fanno flow (a) The Mach number always increases as one moves…

A: Which of the following is true for Fanno flow. Answer: (c) The maximum length of the duct is the…

Q: Q2: The large compressed-air tank shown in the figure bellow exhausts from a nozzle at an exit…

Q: Q5: A converging-diverging nozzle, which is shown in the figure, is supplied with air from a large…

Q: Q3/ An air nozzle has an exit area 2 times the throat area. If a normal shock occurs at a plane…

Q: The entropy increase across a normal shock wave is 199.5 J/(kg · K). Whatis the upstream Mach…

Q: Air enters a compressor at a stagnation state of 100 kPa and 27 ∘C. If it has to be compressed to a…

A: Data given- P1 = 100 kPa T1 = 27°C = 300 K P2 = 900 KPa m = 0.02 kg/s Process is isentropic {…

Q: 7. An initial expansion of air occurs through a nozzle from 828 KPaa and 71°C to 138 KPaa. The…

A: Given data: The initial pressure, P1=828 kPa. The initial temperature, T1=71°C. The final pressure,…

Q: The flow just upstream of a normal shock wave is given byp1 = 1800 lb/ft2, T1 = 480 ◦R, and M1 =…

A: Given data: *The pressure of the upstream flow is p1 = 1800 lb/ft2. *The temperature of the upstream…

Q: 4- Air at stagnation pressure of 600 kpa and stagnation temperature of 530 K enters a frictionless…

Q: If the exit Mach number in Fig. is 2.2, what is theexit area?(a) 0.10 m2, (b) 0.12 m2, (c) 0.15 m2,…

A: Write the given data.

Q: Shock waves are treated as discontinuities here, but theyactually have a very small fi nite…

A: The variation of the velocity, temperature, pressure and entropy of the before and after the shock…

Q: In the figure below, M1 = 3.0 and A1 = 2.0ft?. If the fluid is carbon monoxide and the shock occurs…

Q: 6) For supersonic Fanno flow: A. The total enthalpy increases with friction. B. The total enthalpy…

A: Fanno flow is defined as the steady one dimensional through constant area duct where friction…

Q: A gas at a specified stagnation temperature and pressure is accelerated to Ma = 2 in a…

A: The relation between pressure and the Mach number is expressed as, Here, P = Static pressure at…

Q: The stagnation pressure after the normal shock wave in a diverging nozzle (pi= 170 kPa, Mi= 2.4, Ax…

A: given; pressure(Pi)=170KPamack number(M)=2.4stagnation pressure(Po)=?specific heat ratio of air…

Q: It is required to expand 3 kg/s of air from stagnation conditions of 200kPa, 500K through a…

A: Giveen data It is required to expand 3 kg/s of air from stagnation conditions of 200kPa, 500K…

Q: An air nozzle has an exit area 1.6 times the throat area. If à nörmål shock at a plane where the…

A: The step by step is solution given below

Q: Air flows at the rate of 1 kg/s through a convergent-divergent nozzle. The entrance area is 2x10 3…

Q: Heat is rejected from the air flowing in a constant area duct. At the duct entrance, the air is…

A: Rayleigh flow and isentropic relations are used to arrive the solution.

Q: An air nozzle has an exit area 1.6 times the throat area. If a normal shock occurs at a plane where…

A: It will be assumed that the supply tank is large enough to be able to assume that the tank pressure…

Q: The back pressure if the flow were isentropic throughout is ....... Air at stagnation pressure of…

Q: )Air is supplied to a converging nozzle from a large reservoir where the temperature and pressure…

A: Stagnation point: The point at which the velocity of the fluid becomes zero. When the fluid is…

Q: Air enters a convergent-divergent nozzle from a reservoir having a pressure and temperature of 200…

Q: The flow just upstream of a normal shock wave is given by p1 = 1 atm,T1 = 288 K, and M1 = 2.6.…

A: Given: properties at upstream of a normal shock p1=1 atmT1=288 kM1=2.6 To find The properties just…

Q: Ten kilograms per second of air is flowing in an adiabatic system. At one section the pressure is…

A: a) To determine the general shape of the systemm˙=ρ1A1c1 c1=m˙ρ1A1 =m˙p1RT1A1…

Q: At the exit of Converging nazzle theair velocitywas 273m1s Find mach bumber at this section and the…

A: At the exit of converging nozzle the air velocity was 273m/s ,Find Mach number a this section…

Q: The stagnation pressure after the normal shock wave in a diverging nozzle (pi= 170 kPa, ,Mi= 2.4,…

Q: A jet engine at 7000m altitude takes in 45 kg/s of air and adds 550 kJ/kg in the combustion chamber.…

Q: a-) Stop temperature at first point, stop pressure, stop density, Mach number, maximum speed and…

A: For solution refer below images.

Q: Air enters a converging–diverging nozzle at a pressure of 1200 kPa with negligible velocity. What is…

A: Given: The pressure at the nozzle is P=1200 kPa. The lowest pressure where velocity is negligible…

Q: Nitrogen is expanded isentropically in a nozzle from a pressure of 2000 kPa, at a temperature of…

Q: 4- Air at stagnation pressure of 600 kpa and stagnation temperature of 530 K enters a frictionless…

Q: Q.5 A supersonic wind tunnel, which is shown in the figure, is fed from a large tank. The air is…

A: Given: M2 = 2.65 P3 = 100 kPa

Q: Air flows steadily from a tank through the pipe inFig. . There is a converging nozzle on the end.…

A: For the given mass flow rate of 3 kg/sec determine a) Mach number at section 1b) The pressure…

Q: Air is flowing in a converging-diverging nozzle with an expansion ratio of 10. The inlet stagnation…

Q: A large tank supplies helium through a converging-diverging nozzle to the atmosphere. Pressure in…

Q: Air flows from a reservoir through a convergent-divergent nozzle and then a Fanno flow in the…

A: To find: The range of the reservoir pressures.

Q: Q6: Air following through constant area duct encounters stationary shock as shown in figure. Find…

A: Given data as per question v1 =500 m/s P1 =50 kpa T1 = 250 K Calculations Taking difference of…

Q: Q.1. A uniform supersonic air flow travelling at a Mach number of 2.5 passes over a wedge which…

A: Write the expression of oblique shock angle. tanθ=2Ma12sin2β-1/tanβMa12k+cos2β+2

Q: Q 6. A truncated nozzle with a 10 cm2 exit area is supplied from a helium reservoir in which the…

Q: What will happen to the entropy of a flow across a shock? O It will stay the same O It will decrease…

Q: Air enters a converging–diverging nozzle with low velocity at 2.4 MPa and 120°C. If the exit area of…

A: Given Data⇒At EntranceP1=2.4 MPaT1=120°CProblem definition⇒Problem says estimate backpressure.

Question

Q1) Air enters a converging-diverging nozzle as shown in the Figure. 1
.Determine :
The conditions( M, P,T) upstream and downstream ifthe normal shock
which is located at the nozzle exit. Also calculate entropy across the
shock.
Ae-0.0724m?
At-0,025 m?
To=30°C
Po=101 kPa
Figure. 1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Given Data in question

VIEW

Step 2 Entropy across the shock

VIEW

Step 3 calculate entropy change

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider an oblique shock generated at a compression corner with adeflection angle θ = 18.2◦. A straight horizontal wall is present above thecorner, as shown . If the upstream flow has the propertiesM1 = 3.2, p1 = 1 atm and T1 = 520◦R, calculate M3, p3, and T3 behindthe reflected shock from the upper wall. Also, obtain the angle whichthe reflected shock makes with the upper wall.
If there are no shock waves and the pressure at one ductsection in Fig. is 55.5 kPa, what is the velocity atthat section?(a) 166 m/s, (b) 232 m/s, (c) 554 m/s, (d ) 706 m/s,(e) 774 m/s
An air nozzle has an exit area 1.6 times the throat area. If a normal shock occurs at a plane where the area is 1.2 times the throat area, find the pressure, temperature, and Mach number at the exit. The stagnation temperature and pressure before the shock are 310 K and 700 kPa, 4.3.
The stagnation pressure after the normal shock wave in a diverging nozzle (pi= 170 kPa, Mi= 2.4, Ax ⁄ Ai = 2.0)
Atmospheric air at 101kPa and 20OC is drawn isentropically through a convergent–divergent nozzle of exit area 0.033m2. If the pressure at the nozzle exit is 32kPa, the maximum mass flow rate through the nozzle is ________
Air enters a converging- diverging nozzle at a pressure of 830 kPa abs and a temperature of 32°C. Neglecting the entrance velocity and assuming a frictionless process, find the Mach number at the cross-section where the pressure is 240 kPa abs.( for air: k = 1.4 R=287J/kgK)
The reservoir pressure and temperature for a convergent-divergent nozzleare 5 atm and 520◦R, respectively. The flow is expanded isentropically tosupersonic speed at the nozzle exit. If the exit-to-throat area ratio is 2.193,calculate the following properties at the exit: Me, pe, Te, ρe, ue, p0,e, T0,e.
Shock waves are treated as discontinuities here, but theyactually have a very small fi nite thickness. After giving itsome thought, sketch your idea of the distribution of gasvelocity, pressure, temperature, and entropy through theinside of a shock wave.
A normal shock produced by an explosion propagate at a constant velocity of 450 m/s into still air of 100 kPa and 23 °C. The ratio of stagnation pressure upstream the shock to stagnation pressure of the gas flow behind the wave is
The air temperature is 288K and the pressure is 1 atm upstream of a shock wave; After the passing through the shock wave, the temperature of the air is 690K and the pressure is 8.656 atm. Calculate the change in a) enthalpy b) internal energy, and c) entropy across the wave. Assume R = 0.287 kJ/kg⋅K and ? = 1.4
Air flows isentropically through a duct. At section 1, thepressure and temperature are 250 kPa and 125°C, andthe velocity is 200 m/s. At section 2, the area is 0.25 m2 andthe Mach number is 2.0. Determine (a) Ma1; (b) T2; (c) V2;and (d ) the mass fl ow.
Q2/ Air flows isentropically in a converging-diverging nozzle with initial Ma = 0.2, pressure = 1 MPa and temperature 27 C. Find the exit temperature, pressure and velocity at Ma = 1.8