Q1Frode wandThe generator in Figure Q1 is rated at 44 480 Vand lo kVAIG TVG480 LOVGeneration1:10 I line2012WmTransmission20:1I loadZ load = 10L30°DistributionFigure Q1i). Convert the system to its perunit equivalent circuit.ii) Find the power supplied to the load in this HasmondsSystem.iii) Find the power lost in the transmission line

Answered: Image /qna-images/answer/26ad8161-2996-4d70-b6d9-231945da4cd1.jpg

Q1 The generator in Figure Q1 is rated at 440 X 480 and lo kVA Flodz IGT VG 480 LOV Generation 1:10 I line 2012 mm Transmission 20:1 System. iii) Find the power lost in the transmission line I load Figure Q1 i). Convert the system to its perunit equivalent circuit. ii) Find the power supplied to the load in this sm z load = 10L30° Distribution

Q1 The generator in Figure Q1 is rated at 440 X 480 and lo kVA Flodz IGT VG 480 LOV Generation 1:10 I line 2012 mm Transmission 20:1 System. iii) Find the power lost in the transmission line I load Figure Q1 i). Convert the system to its perunit equivalent circuit. ii) Find the power supplied to the load in this sm z load = 10L30° Distribution

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
In the system shown in Figure 1, the transformers are connected star-star with both star points grounded and the generators are connected in star with thier star points grounded. The system base is 15 MVA. The transformers all have reactances of 0.04 p.u. on this 15 MVA base. The reactances of all other elements are given in Table 1 (in 2) and the voltage levels are given in Table 2. p.u. G1 p.u. T1 jö Per-Unit Convert all values to p.u. on a 15 MVA base. Xa= p.u. Xc₂= XL = V BABE G1 2 X 9 T3 Figure 1: A section of the distribution system T1 L Table 1: Sequence reactances (2) 3 G1 L G2 0.3 0.59 0.01 4 L 9/10 10 Fault Voltage What is the voltage at bus 3 (in Volts) after the fault has occurred? Vp= V T2 5 T2 34 10/4 Table 2: Voltage bases (kV) G2 4 T3 10/9 | G2 Fault Current A three-phase fault with a fault reactance of 0.01 p.u. occurs at bus 3. Calculate the fault current flowing at the fault point in KA. Ip=-j KA So
Q20. The section bus-bars A and B as shown in Figure B5 are linked by a bus-bar reactors each rated at 5000 kVA with 10% reactance. On bus-bar A, there are two generators each of 10,000 kVA with 10% reactance and on B two generators each of 8000 kVA with 12 % reactance. Find the Current and MVA that fed into a dead short circuit between all phases on B with bus-bar reactor in the circuit. Page 4 of 5 جامعة التقنية والعلومر التطبيقية بإبراء University of Technology and Applied Sciences - Ibra Student ID: Section: Student Name: 8,000 kVA 12% 10,000 kVA 10,000 kVA 10% 8,000 kVA 12% 10% 2 3 5,000 kVA 10% lell 8,000 kVA 10% Figure B5 "End of Question Paper"
The section bus-bars A and B are linked by a bus-bar reactor rated at 6000 kVA with 12% reactance. On bus-bar-A, there are two generators each of 10 MVA with 8% reactance and on bus-bar-B, two generators each of 6000 kVA with 10% reactance. Find the steady MVA fed into a dead short circuit all phases on B with bus-bar reactor in the circuit.
e = 0 Q1: What does happen if we change two currents? a. Q2: What does happen if we have a three-phase four poles machine? Q3: What does happen if we have a two-phase two poles machine? e = 0 Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali Ki. pw --
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
A 400 MVA synchronous machine has H, = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two machines operate in parallel in a power plant. Find out H relative to a 100 MVA base.
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuit
Question#5 Figure below shows a simple single-phase AC power system with three loads. The voltage source is V = 240 < o°v and the impedances of these three loads are z, = 10 < 30°n Z2 = 10 < 45°0 Z3 = 10 < -90°n z,
In transformers, the flux lost in the air is called nd as SKW. If th
moodle.nct.edu.om/mod/quiz/attempt.php?attermpt=6123858&.cmid 63002#question-96 Portal When the load on a series generator is decreased, then the flux produced will be increased. Select one: O True in O False The accelerating anode in CRO is also called as positive electrode. Select one: O True O False MIEE2110M The neutral current in an unbalanced star connected system is not equal to 33°C Sunny hp