Q#1: What are the conditions of equilibrium for floating and submerged bodies
Q: Q2:- A wood cone floats in water in the position shown in fig.2.The specific gravity of the wood is…
A:
Q: A 1.7 ft3 rigid vessel contains 2 lbs of water at 400F. What is the pressure in the vessel?
A:
Q: Calculate the pressure exerted by water on the hull of a submarine that is cruising at a depth of…
A: Depth, h = 500 ft = 152.4 m Density of ocean water = 1025 kg/m3
Q: A cylinder weighs 150 lbf. Its cross-sectional area is 40 in^2. When the cylinder stand vertically…
A: The pressure on the floor exerted by the cylinder is 3.75 psi.
Q: For a partially submerged tank the center of pressure is Select one: a. none b. They both equal for…
A: The center of pressure of partially submerged body is a point where all the pressure force act, the…
Q: (b) Imagine holding two bricks under water. BrickA is just beneath the surface of the water, while…
A: Force needed to hold brick B is same as the force to hold brick A since buoyancy force acting on…
Q: Q2) A cylindrical body of length 0.9 m and of sp.gr = 0.7 is floating in water as shown in fig.2.…
A:
Q: A cone (240 mm diameter, 200 mm height & S=0.7) floats with its vertex downwards in a fluid. Is this…
A: Given data:- diameter of cone, D=240mm ⇒R=120mm height of cone, H=200mm specific gravity of cone,…
Q: Discuss the stability of (a) a submerged and (b) a floating body whose center of gravity is above…
A: The submerged body is a body that is lying fully in water. If the center of gravity of submerged…
Q: A quarter-circular gate of negligible mass separates water and oil. required tension in the cable at…
A:
Q: 9. A block of woo having a volume of 0.034 m³ and weighing 300 N is suspended in the water as shown.…
A:
Q: A solid cylinder of circular section of diameter d is of material with specific gravity S. This…
A: To find: The maximum length of the cylinder if the equilibrium is to be stable with the cylinder…
Q: A beaker of water sits on a balance. A metal block with a mass of 70 g is held suspended in the…
A:
Q: the maximum force, P (in lbs) wit
A:
Q: PROBLEM 2: A rectangular plane, 1.2 m by 1.8 m is submerged in water and makes an angle of 30° with…
A:
Q: 2- An associate triangular plate of base 3 m and altitude 3 m is immersed vertically in an oil of…
A:
Q: 2.4 A homogenous, 1.2 m wide, 2.m long rectangular gate weighing 3.6*10' N is held in place by a…
A: Area of the gate affected by water pressureA=1.8×1.2=2.16m2center of gravity, x¯ = 1.82sin60ο…
Q: 26. A 60-kg rectangular box, open at the top, has base dimensions 1.0 m by 0.8 m and a depth of 0.50…
A: option B is rhe correct option
Q: Please answer in essay: From the figure below, discuss the internal effect of the external forces…
A: EXTERNAL AND INTERNAL FORCES External forces are powers brought about by outside specialist outside…
Q: Q2:- A wood cone floats in water in the position shown in fig.2.The specific gravity of the wood is…
A:
Q: The uniform rod in Fig. is hinged at point B on thewaterline and is in static equilibrium as shown…
A: Given Data: Mass of lead is m = 2 kg. Specific gravity of lead is SGl=11.4. The length of rod is l…
Q: ?What is the total force lifting the tank
A:
Q: Calculate the force required to lift a balloon having a volume of 65.4 m contains helium gas under…
A:
Q: Compute the capillary effect of immersion in mercury of a glass tube of 4mm internal diameter given…
A:
Q: Q2:- A wood cone floats in water in the position shown in fig.2.The specific gravity of the wood is…
A:
Q: 1. What is the relation do you find between the weights of the floating body and the weight of water…
A: NOTE:- As per our company guidelines we are supposed to answer only one question. Kindly repost…
Q: 4. A sliding gate of height 14mand width 28lies in vertical plane that weighs 25AN. Determine the…
A: Given: Height of the gate→h=1.4 m Width of the gate→b=2.8 m And wieght of the plate→W=25 KN because…
Q: Determine pressure due to water at depth of 13 m on a body
A: Given data : Density of water=ρ Depth=h Acceleration due to gravity=g To find : Pressure
Q: A 30-m vertical column of fluid (density = 1878 kg/m*3) is located where g = 9.65 mps^2. Find the…
A:
Q: You have the thin walled pressure vessel shown. Given
A: Given that , Inner radius Ri=3.00ftWall thickness t=0.25in =0.020833 ft Length L=10 ft
Q: What would be the submerged weight (submerged weight = weight – buoyant force) of a 12m³ of steel in…
A:
Q: :Two plungers are installed into a tank filled in with liquid. Plunger diameters are di=40 mm and…
A: Pascal's Law: According to this law, pressure at a point in a fluid system is equally distributed in…
Q: One end of a rod of length L and density p is fixed by a frictionless pivot at a depth d under…
A: GIVEN; *Lenght of Rod=L *Density of Rod=ρ TO FIND; Equillibrium position of the rod in terms of its…
Q: Plunger Cylinder A-5 in? Weight = 10,000 Ibf A- 500 in? 15 t
A: GivenW=10000lbCylinder of area A=500 in2Plunger of area A=5 in2F=?
Q: Discussion: 1-The thrust force increases with increasing depth of immersion, and the relationship…
A: Hydrostatics Law: According to Hydrostatics Law, the pressure in a vertically downward direction in…
Q: A tank with one hinged wall is filled with water. The tank wall is held at a 30° angle by a…
A:
Q: construct the free-body diagram of gate
A: The gate mass is 84 kg and its center of mass located at G the reaction force at point A is in…
Q: (b) One end of a rectangular tank is 1.5 m wide by 2 m deep. The tank is completely filled with oil…
A: given:width, b=1.5 mdepth, d=2 mdensity of oil, ρo=920 kg/m3
Q: A homogeneous, 4m wide, 8m long rectangular gate weighing 300 kg is held in place by a horizontal…
A:
Q: Calculate the weight of 10 kg block, when it is fulley submerged into the water?
A: Given:Mass of block,m=10KgSo,Weight of block,W=(10×9.81)N⇒W=98.1NWe know:Density of water,ρ=1000Kgm3
Q: The specific weight of a system is defined as the weight per unit volume (note that this definition…
A: specific weight γ=Weightvolume=mgV=ρg
Q: Determine pressure due to water at depth of 20 m on a body
A: Given:h=20 m
Q: Q3) A solid wood cylinder of diameter 2 ft and height of 4 ft as shown in Fig.3,the specific gravity…
A: d=2 ft ,H= 4ft and s.gwood=.6 , and s.goil=.85 γwater=62.4 lbft2 Since weight of cylinder =wieght…
Q: Q3) A solid wood cylinder of diameter 2 ft and height of 4 ft as shown in Fig.3,the specific gravity…
A: Given: Diameter of the cylinder (D)=2ft Height of the cylinder (H)=4ft specific gravity of wood…
Q: Q2) A cylindrical body of length 0.9 m and of sp.gr = 0.7 is floating in water as shown in fig.2.…
A: Write the given data. L=0.9 mSG=0.7MG=-0.03 m In this problem, the distance between meta-centre M to…
Q: (b) One end of a rectangular tank is 1.5 m wide by 2 m deep. The tank is completely filled with oil…
A:
Q#1: What are the conditions of equilibrium for floating and submerged bodies
Step by step
Solved in 2 steps
- The high-pressure water cock is rigidly attached to the support at D. Neglecting the weights of the members, draw the FBD of the entire assembly and count the unknowns.Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.A block with specific gravity of SG= 1.45 and volume V= 0.75m3, is attached to a spring scale. The block is hung vertically such that it is fully submerged in oil ρoil= 0.85kg/m3 . a) Draw a free body diagram for the block. b) What is the apparent weight of the block?
- In the set-up shown, a rectangular gate, ABCD, is used to store layers of oil and water. Theweight of the gate is 4 kN and the force exerted by the stopper on the gate is measured tobe 30 kN.Draw the free body diagram of the rectangular gate.Plunger (weightless) Area is 0.003 m² piston mass 1000 kg , area of piston is 0.3 m² density of oil is 750 kg/m³ determine force on Plunger required for equilibriumFigure shows a set-up with a vessel containing a plunger and a cylinder. What force, F is required to balance the weight of the cylinder. If the weight of the plunger is negligible?
- For the three-liquid system shown, compute h 1 and h 2 .Neglect the air density.An open cubic tank of side length 2 m is completely filled with water. If the surface of the water and the outside of the tank are subject to atmospheric pressure, what are the hydrostatic forces acting on: Each side of the tank? The base of the tank?The uniform rod in Fig. is hinged at point B on thewaterline and is in static equilibrium as shown when 2 kgof lead (SG = 11.4) are attached to its end. What is thespecifi c gravity of the rod material? What is peculiar aboutthe rest angle θ = 30 ° ?