11. A beaker of water sits on a balance. A metal blockwith a mass of 70 g is held suspended in the waterby a spring scale in position 1, as shown. In thisposition, the reading on the balance is 1260 g, andthe spring scale reads 120 g. When the block is liftedfrom the water to position 2, what are the readings onthe balance and spring scale?Balance reading Spring scale reading1190 g1190 g1260 g1330 g120 g(A)(В)(C)(D)190 g120 g120 g

Name: 11. A beaker of water sits on a balance. A metal blockwith a mass of
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 11. A beaker of water sits on a balance. A metal blockwith a mass of 70 g is held suspended in the waterby a spring scale in position 1, as shown. In thisposition, the reading on the balance is 1260 g, andthe spring scale reads 120 g. When the block

Answered: Image /qna-images/answer/3c7e781d-3847-434a-ad32-b9fc1bf77795.jpg

Answered: A beaker of water sits on a balance. A…

Engineering

Mechanical Engineering

A beaker of water sits on a balance. A metal block with a mass of 70 g is held suspended in the water by a spring scale in position 1, as shown. In this

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter10: Virtual Work And Potential Energy

Section: Chapter Questions

Problem 10.62P: The bar ABC is supported by three identical, ideal springs. Note that the springs are always...

See similar textbooks

Similar questions

The high-pressure water cock is rigidly attached to the support at D. Neglecting the weights of the members, draw the FBD of the entire assembly and count the unknowns.
The weight of the cylindrical tank is negligible in comparison to the weight of water it contains (water weighs 62.4lb/ft3). The coefficient of static friction between the tank and the horizontal surface is s. (a) Assuming a full tank, find the smallest force P required to tip the tank, and the smallest s that would allow tipping to take place. (b) If the force P = 200 lb initiates tipping, determine the depth of water in the tank.
The bar ABC is supported by three identical, ideal springs. Note that the springs are always vertical because the collars to which they are attached are free to slide on the horizontal rail. Find the angle at equilibrium if W = kL. Neglect the weight of the bar.
5.) A lO-kN car and 5-kN hoist are supported 1.8 m above the floor by a cylinder with a 300-mm bore . What pressure will this develop in the system?
Plunger (weightless) Area is 0.003 m² piston mass 1000 kg , area of piston is 0.3 m² density of oil is 750 kg/m³ determine force on Plunger required for equilibrium
If the maximum length of the spring is 40 cm, what average friction force opposes the motion of the mass?
what is the effect of 1- gravity (g), 2- (m/l) on the value of the rate or spring constant (K)
Q#1: What are the conditions of equilibrium for floating and submerged bodies
Two spheres, one heavier and weighing12000 N and of diameter 1.2 m and the other lighter and weighing 4000 N, are tied with a rope and placed in seawater. The density of sea water is 1025 kg/m^3. It was found that the spheres floated vertically with the lighter sphere just under the water surface. Illustrate the problem before answering the following questions: (a) Determine the diameter of the lighter sphere in meters. (b) Determine the tension in the rope in Newtons. Please answer this with diagram PLEASE. ASAP po.
A former student of mechanics wishes to weigh himself but has access only to a scale A with capacity limited to 100 lb and a small 20-lb spring dynamometer B. With the rig shown he discovers that when he exerts a pull on the rope so that B registers 19 lb, the scale A reads 67 lb. What is his correct weight?
A gas is contained in a cylinder behind a frictionless piston of diameter 0.1 m and mass 25 kg. When an additional mass M is placed on the piston the gage pressure of the gas becomes 2.0 bar. The local barometric pressure is 775 mm of mercury. (a) Calculate (i) the mass of M and (ii) the absolute pressure of the gas in the cylinder. (b) The piston is held in this position with the aid of a lock on the outside while heat is supplied to the gas until its absolute pressure becomes 4 bar. Calculate the force on the lock in the final equilibrium state.
The hanging mobile pictured above consists of two masses, m1 and m2, suspended from a uniform 10 cm long rod, which is in turn suspended from the ceiling at an angle of 70 as pictured above. The mass m1 is 0.02 kg, while the mass of the rod is mr = 0.01 kg. Assuming the mobile is in a state of static equilibrium, find the value of mass m2.