Answered: Q1)N voice channel multiplex on a…

Q1)N voice channel multiplex on a PCM/QAM system with quantization level =16. The band width of each cannel =3 KHz, and the Baud rate = 300 ksymbol/sec. Determine the number of input channel (N).

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Related questions

Q: Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (I.e same value of…

A: According to question we have to, (a). Calculate the E/N, in 64-QAM system. Compare the results.…

Q: Draw 5*32 decoder by using only 2*4 and one 3* 8 decoder as enable with proper labelling

A: GIVEN: 2*4 and 3*8 Decoder DRAW: 5*32 Decoder

Q: If 280 kbps is to be sent over a noiseless channel with a bandwidth of 20 kHz, then how many…

A: Given information: Required data rate is r=280 kbps=280×103 bps Channel bandwidth B=20 kHz=20×103 Hz

Q: Q3: A) In a binary PCM system, the output signal -to- quantization ratio is to be hold to a minimum…

A: The SNR ratio has a minimum value of 40 dB. The bit rate is calculated by the SNR ratio formula as…

Q: Question Completion Status: QUESTION 11 What is the number of signal levels required to achieve a…

Q: For a PCM system with the following parameters: Maximum analog input frequency = 4 kHz Maximum…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: a. 'Draw block diagram for AM modulation? b. Draw block diagram for AM demodulation?

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: Q.2) What is the method of arbitration of the PCI bus? Modify the following diagram arbitration,…

A: In order to attenuate the latency of access, PCI's arbitration mechanism relies on access instead of…

Q: Consider that the maximum voltage (Vmax) of the AM modulated carrier is 30V and the minimum voltage…

Q: For a PCM system with the following parameters, Parameters: (i) Maximum analog input frequency = 5…

Q: The primary benefit of PAL is having a programmable AND array and fixed OR array, that it was…

A: For the above given statement we need to justify it's correctness for the given concept PAL.

Q: 01/ Draw block diagram for AM modulation? Q2 / Draw block diagram for AM demodulation? Q3 / What are…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: If a binary sequence of 100000001 is digitally encoded. Which line encoding format will most likely…

A: If a binary sequence of 100000001 is digitally encoded, the line coding format having…

Q: Q1. Design asynchronous (ripple ) binary counter and timing diagram for the following sequence…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 1. What are the advantages of PCM system over other types of modulation systems?

A: Note: As per the guidelines will be solving only the very first question. repost for other question…

Q: The bit rate of a digital communication system is R kbit/s and the modulation used is 32-QAM. What…

A: ISI stands for intersymbol interference. It a distortion which takes place during data transmission…

Q: For a PCM system, if the quantizer has 128 levels, then what will be the minimum transmission…

Q: Assume the baud rate equals bits per second. How long is a bit for a 9600 baud modem? A) 9600 B)…

A: 104 us

Q: The constellation diagram for a modem that is used for transmission via an analogue channel is shown…

A: The constellation diagram for a MODEM that is used for transmission through an analog channel is…

Q: Draw constellation diagram of 8-QAM modulation?

A: CONSTELLATION DIAGRAM: 1. When dealing with multilevel ASK(Amplitude Shift Keying), PSK (Phase…

Q: Determine the efficiency of transmission for QPSK modulation scheme at a .transmission rate of 10…

A: Bandwidth efficiency is the ratio of transmission rate to the minimum bandwidth.

Q: Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (i.e same value of…

A: Given, for 16 QAM system,SNR=10 dB Formula:SN=EbN0×fbBWhere,fb=Data rate of the channel.B=Bandwidth…

Q: Contrast the advantages and disadvantages of digital transmission.

A: Advantages of digital transmission are, It provides immunity towards the noise. These signals are…

Q: How many OC signals are used in a SONET network with a 622.08 Mbps line rate? A. 8064 B. 4 C. 12 D.…

A: The solution is given below

Q: A PCM system has the following parameters: a maximum analog input frequency of 4.5kHz, a maximum…

Q: Q10/To design 7- to-128 decoder must using * 4( 2- to- 4 decoder) with active low enable and 16( 3-…

A: 7 -m128 decoder Firstly determining the 7-to 128 decoder by 3-to-8 decoder 1288=16168=2 Therefore,18…

Q: For a PCM system with the following parameters: Maximum analog input frequency = 4 kHz Maximum…

A: Given data, Maximum analog input frequency fmax=4 kHz Maximum decoded voltage Vmax=±2.55 V Minimum…

Q: b. The output from the quantization process will be coded to generate bit stream to be encoded…

A: The digital data encoding schemes are categorized into five types based on their synchronization…

Q: OS: An analog signal is first encoded in binary PCM before being transformed to a multilevel signal…

A: We need to calculate bit rate and baud rate and bandwidth for given system , we will use for bit…

Q: How many OC signals are combined into a 40 Gbps SONET network

A: D) 516096 From table 39813.12 Mbps i.e 40 Gbps the number of OC signals/channels combined are 516096

Q: Calculate the Eb/No in 64-QAM system. Compare the results. (b) What are the maximum transmission…

Q: Q2] For a PCM system with the following parameters, determine a) Minimum sample rate. b) Minimum…

A: To calculate the a) Minimum sample rate b) No.of bits used in PCM c) Resolution d) Quantization…

Q: In a PCM system, the maximum frequency of the analog input signal is 4 kHz. If the number of…

A: Given that Maximum frequency of the analog input signal (fm) = 4 kHz Quantization level=2 =2n So…

Q: Q2] Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (i.e same value…

A: Given: Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (i.e same…

Q: DESIGN A 3 X8 DECODER CIRCUIT USING THE INTEGRATED CIRCUIT 74139 ( 2x4 DECODER) SO AS TO SATISFY THE…

A: Decoder is a circuit which is used to convert one code set into another code set. a 3-8 decoder is…

Q: (o11 An analog signal with a bandwidth of 4.2kHz is to be converted into binary PCM and transmitted…

Q: Sketch the Manchester format, differential code and polar quaternary signals for the following…

Q: a) Explain with a neat diagram the construction and working of a TRF receiver.

A: The TRF is known as tuned radio frequency receiver and it is used for tuning or selecting the radio…

Q: Explain the operation of a 2 x 4 line decoder with enable and active low output.

Q: Determine the efficiency of transmission for QPSK modulation scheme at a .transmission rate of 10…

Q: three- massage m1 =3cos(t20000t), m2= 10cos(730000t) and m3= 3cos(10007tt)cos(40007tt), Calculate…

Q: Draw constellation diagram of 8-QAM modulation? File upload

A: Modulation is process by which some properties of carrier signal is varied according tomodulating…

Q: 1. BCD to 7-segment Decoder 2. Encoder 3. Decc

A: "Since you have a asked multiple question ,we will solve the first question for you.If you want any…

Q: Q6: Binary channel with bitrate R,=36000 bits/sec is available for PCM voice transmission. Find…

A: "Since you have asked multiple question , we will solve the first question for you if you want any…

Q: Design of Binary 0 ,1, 2, 3 to SEVEN SEGMENT Decoder

Q: Q.3: A binary symmetric channel with probability of error 0.1. Draw the channel model and find…

Q: Q. For an 8-PSK system operating at an information rate of 36 kbps determine, 1. Baud 2. Minimum…

A: The solution is given below

Q: QI: A BPCM system is used to transmit signal of 512 levels, the input signal works in the range…

A: We need to find data rate and signal to noise ratio.

Q: For a PCM system, the value of the minimum transmission bandwidth is 25 kHz and the maximum…

A: For the given PCM system, firstly the word length of the signal is calculated using the…

Question

Q1)N voice channel multiplex on a PCM/QAM system with quantization
level =16. The band width of each cannel =3 KHz, and the Baud
rate = 300 ksymbol/sec. Determine the number of input channel
%3D
(N).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

N voice channel multiplex on a PCM/QAM system

VIEW

no. of input channel

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (I.e same value of Pbe). SNR-13 dB 16-QAM system. Calculate the E/N, in 64-QAM system. Compare the results. What are the maximum transmission rate (free from ISI problem) in both modulation schemes? Assume B=20 kHz.
Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (i.e same value of Pbe). SNR=10 dB in 16-QAM system. (a) Calculate the Eb/No in 64-QAM system. Compare the results. (b) What are the maximum transmission rate (free from ISI problem) in both modulation schemes? Assume B=20 kHz.
Q2] Two M-QAM modulation schemes, 16-QAM and 64-QAM, having equal error performance (i.e same value of Pbe). SNR=10 dB in 16-QAM system. Calculate the Eb/No in 64-QAM system. Compare the results.
15. How many OC signals are used in a SONET network with a 622.08 Mbps line rate?A. 8064B. 4C. 12D. 8
For a PCM system, the value of the minimum transmission bandwidth is 25 kHz and the maximum frequency of the input waveform is 5 kHz. Estimate the total number of levels in the uniform quantizer present.
For a PCM system with the following parameters, Parameters: (i) Maximum analog input frequency = 5 kHz; (ii) Maximum decoded voltage at the receiver = ±5.01 V; (iii) Minimum dynamic range = 54 dB. (Use 2 decimal places) a) What is the coding efficiency in % b) What is the resolution in V? c) Determine the maximum quantization error in V.
Consider that the maximum voltage (Vmax) of the AM modulated carrier is 30V and the minimum voltage (Vmin) is 10V, so the modulation index will be:
What will be the minimum transmission bandwidth of a PCM system if the number of bits per sample is 8 and the maximum frequency of the analog signal is 4.5 kHz?
Design an 8-to-1-line multiplexer using a 3-to-8 line decoder and external gates.
For a PCM system with the following parameters, Parameters: (i) Maximum analog input frequency = 5 kHz; (ii) Maximum decoded voltage at the receiver = ±5.01 V; (iii) Minimum dynamic range = 54 dB. (Use 2 decimal places) a) What is the coding efficiency in % b) What is the resolution in V? c) Determine the maximum quantization error in V. d) Determine the minimum sampling rate in KHz e)Determine minimum number of bits use for the PCM code excluding sign bit.
Find the following: a.) Avs b.) Av c.) Ai The two-port parameters for the fixed-bias configuration are Zi =1.071 K ohms, Zo=3 K ohms, and AvNL= -280.11. Note: 3 decimal places for the answers
If in a PCM system, uniform quantizer having total 256 steps is being used, then what will be the number of transmitted bits per sample?