Q6: Binary channel with bitrate R,=36000 bits/sec is available for PCM voice transmission. Find appropriate values of the sampling rate fs, the quantizing level L, and binary digits n assuming fmax= 3.2 KHz. Ans: 6400 Hz; 32,5 kHz. Q7: An analog signal is quantized and transmitted by using PCM system. If each sample at the receiving end of the system must be within ±0.5 percent of the

Q6: Binary channel with bitrate R,=36000 bits/sec is available for PCM voice transmission. Find appropriate values of the sampling rate fs, the quantizing level L, and binary digits n assuming fmax= 3.2 KHz. Ans: 6400 Hz; 32,5 kHz. Q7: An analog signal is quantized and transmitted by using PCM system. If each sample at the receiving end of the system must be within ±0.5 percent of the

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

ChapterS: Safety, Basic Electricity And Ohm's Law

Section: Chapter Questions

Problem 8RQ: What is an MSDS?

See similar textbooks

Similar questions

Fora standard SSBSC carrier AM, the peak unmodulated carrier peak voltage is 10 V for a load resistance of 10 ohms and modulation index of 1. What will be the total transmitted power?
Exxplain the rellation between BER and E/N_0, where E is the energy per bit,N_0 is the noise spectral density, BER is the bit error rate. What is the reason for usign channel coding?
Discuss how the original signal can be recovered perfectly from the output of the decoder. What are the advantages of PCM system over the other types of modulation systems?
A. If the probability of error of BPSK is 0.85 then Pe of BFSK is? B. What happens to the radio wave propagation when the rouefractive index of ionospheric layer becomes low or high? C. If the number of quantization levels are multiplied by four time them how many numbers of bits are added to the actual number? D. What is the disadvantage of wave tilt? E. What is a bipolar line coding technique with phase encoding, and explain why it is named as phase encoding method? F. What is oblique communication circuit? G. What are the differences between DPCM and Delta Modulation? H. What is the change in bandwidth when channel capacity is doubled and two number of bits are increased?
Consider a bandlimited message signal of 6kHz bandwidth. It is sampled at the rate of 55% higher than the Nyquist rate. The maximum quantization error of the sample amplitude is 0.5% of the peak amplitude? . Assume binary encoding. Calculate the minimum bandwidth ? of the channel to transmit the encoded binary signal.
Type your question here A carrier signal given by 10 cos 10000 ?? ???? is AM/DSB-LC modulated by single-tone signal 4 cos 100 ?? ????. 1- Calculate the modulation index. 2- Sketch the spectrum of the modulated signal. 3- Calculate transmission bandwidth.
There exist several methods to perform AM demodulation, consider a requirement where we intend to design an AM receiver which is characterized by less distortion and high SNR.Identify which type of AM demodulation scheme is mentioned in the above statement and explain one such demodulation with appropriate sketch.Compare and contrast different AM modulation and demodulation schemes in various aspectsExplore one interesting application area involving Amplitude Modulation with explanation and neat sketch.
In a PCM system, an uniform quantizer containing 256 levels is used. What will be the minimum transmission bandwidth if the maximum baseband frequency is 1 kHz?
Define the decoders and the encoders, and what functional differences exist between them?
Explain the application of DSP in communication. *The question from a communication engineering.
Define the following conceptsa. Positive modulation percentageb. Modulation efficiencyc. Signal strengthd. At least one technique for building an AM transmitter.
The output signal from a conventional AM modulator is?(?) = 4 cos(3600??) + 24 cos(4000??) + 4 cos(4400??)1. Determine the modulated signal m(t) and the carrier c(t).2. Determine the modulation index.3. Determine the power in the sidebands and the power of the carrier.