Q2-A] A lossless uniform aperture antenna, operating at 10 GHz, has a gain of 10 dB and overall physical area of 18 cm. (a) What is the aperture efficiency of this antenna (in %)? (b) If the antenna is matched to a lossless transmission line that is connected to a matched load, what is the maximum power that can be delivered to the load if the incident power density at the antenna aperture is 10 x 10 watts/cm2?.

Q2-A] A lossless uniform aperture antenna, operating at 10 GHz, has a gain of 10 dB and overall physical area of 18 cm. (a) What is the aperture efficiency of this antenna (in %)? (b) If the antenna is matched to a lossless transmission line that is connected to a matched load, what is the maximum power that can be delivered to the load if the incident power density at the antenna aperture is 10 x 10 watts/cm2?.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Design a 5-ELEMENT YAGI-UDA antenna for a 545 GHz frequency, with the following contents:a. Operation and its applicationb. Sketch of the actual antenna with its dimensions completelyc. Its computation
A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage source which has an internal resistance of 25 Ω) a) Make a diagram of the above system, b) Is an impedance matching circuit needed? If yes, where should the impedance circuit be inserted and make a diagram of the system with the adjusting circuit, c) How many cm is the length of the dipole antenna above, d) How much power is emitted when not using the adjusting circuit and e) How much power is emitted when using the adjusting circuit. Solve subparts D,E max 20 minutes ASAP
Design a Dolph-Tschebyscheff broadside array of 8 elements, 25-dB sidelobe level, and with a spacing of λ/2 between the elements to operate at 3 GHz. Choose a “rectangular patch” or a "dipole" antenna as the array element that operates at 3 GHz. For the final antenna design, determine the: • Half-power beamwidth (in degrees). How much narrower or wider (in degrees) is thishalf-power beamwidth compared to that of a uniform array of the same number ofelements and spacing?• How much smaller or larger (in dB) is the gain (in dB) compared to that of a uniformarray of the same number of elements and spacing? Justify you answer. Do you expectit? Why?
A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage source which has an internal resistance of 25 Ω) a) Make a diagram of the above system, b) Is an impedance matching circuit needed? If yes, where should the impedance circuit be inserted and make a diagram of the system with the adjusting circuit, c) How many cm is the length of the dipole antenna above, Solve Subparts A,B,C in 25 minutes ASAP
Calculate the geometric factor for a resistivity test with an aperture of L=500 meters using the dipole-dipole arrangement with a factor n=8 with a value of a=50 m
Consider a communication link operating at 15 GHz with the transmitting and receiving antennas gain of 20 dB and 15 dB, respectively. The transmitted power is 15 W and the distance between transmitter and receiver is 12 km. (i) Determine the received signal (in dBm) for the free space condition. (ii) Repeat (i) if plane earth path loss exists and both transmitting and receiving antenna height is 10m. (iii) If there is a 20-meter tall building located at 5 km from the transmitter, determine the minimum height of transmitting and receiving antennas above ground level to ensure unobstructed LOS conditions.
Design a 5-ELEMENT YAGI-UDA antenna for a 641.14 MHz frequency,with the following contents:a. Sketch of the actual antenna with its dimensions completely and computation
Q. Calculate the radiation resistance of a short dipole (with a triangular current distribution) of length 0.3 m operating at 100 MHz. If the total resistance of the antenna is 2.2 Ω, calculate the maximum effective area and the radiation efficiency of the dipole. Calculate the open circuit voltage induced at the terminals of the dipole if it is oriented along the z - direction and the incident electric field at the dipole is Ei = (ax 4 + ay 3 + az 5) V/m.
A pyramidal horn antenna with aperture dimensions of 9 ×8 cm and operating at 5 GHz. What will be the directivity of the antenna?
"If a receiving antenna has a gain of 26 dB, calculate its effective capture area (m^2) if its operating at 1.7 GHz. Enter only the numerical value. No need for the unit. Use four decimal places (if the answer is not an integer)."
A microwave link includes two sites that are 10 km apart and uses a center frequency of 9 GHz. On either transmitter or receiver side, a 100-m transmission line that has an attenuation per unit length of 0.01 dB/m is connected to an amplifier and a parabolic reflector antenna. Other losses caused by connectors and insertions incurred on one side amounts to 3 dB. Antenna has a power gain of 20 dB. If the output of the transmitter amplifier is 30 dBm, what is the received signal level (in dBm) at the input of the receiver amplifier?
For a monopole antenna with linearclinear distribution, if the effective length of the monopole is equal to half of wavelength, then estimate the radiation resistance of the monopole.