2.1) A parabolic reflector antenna used for radio astronomy to observe a certain patch in the sky, has a diameter of D1 m and operates at a frequency of F1 GHz. If the aperture efficiency is E1%, find the: A) The gain of the antenna and express it in dBd. (Show all the calculations). B) The far field distance for this antenna in meters and explain why this region is important. D1 = 3 F1 = 72 E1= 63

2.1) A parabolic reflector antenna used for radio astronomy to observe a certain patch in the sky, has a diameter of D1 m and operates at a frequency of F1 GHz. If the aperture efficiency is E1%, find the: A) The gain of the antenna and express it in dBd. (Show all the calculations). B) The far field distance for this antenna in meters and explain why this region is important. D1 = 3 F1 = 72 E1= 63

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1.) If the far field distance of a pyramidal horn antenna at 200 MHz is 3.5 m, what is the width of the antenna, in meters? 2. The near-earth range equation is used by the cell phone industry to determine the maximum range between a cell phone and a repeater. Determine the change in maximum range if the repeater antenna height is increased by a factor of two. step by step and clear thanks.
The PCB monopole antenna shown in figure below is required to be designed for Bluetooth Low Energy wireless mouse operating at 2.45 GHz. What should be the length of the antenna trace in mm. Assume the substrate of the PCB is foam (dielectric constant = 1)
Design a 5-ELEMENT YAGI-UDA antenna for a 641.14 MHz frequency,with the following contents:a. Sketch of the actual antenna with its dimensions completely and computation
A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage source which has an internal resistance of 25 Ω) a) Make a diagram of the above system, b) Is an impedance matching circuit needed? If yes, where should the impedance circuit be inserted and make a diagram of the system with the adjusting circuit, c) How many cm is the length of the dipole antenna above, Solve Subparts A,B,C in 25 minutes ASAP
A microwave link includes two sites that are 10 km apart and uses a center frequency of 9 GHz. On either transmitter or receiver side, a 100-m transmission line that has an attenuation per unit length of 0.01 dB/m is connected to an amplifier and a parabolic reflector antenna. Other losses caused by connectors and insertions incurred on one side amounts to 3 dB. Antenna has a power gain of 20 dB. If the output of the transmitter amplifier is 30 dBm, what is the received signal level (in dBm) at the input of the receiver amplifier?
Please show all steps A parabolic dish antenna has a diameter of 5 meter, operating at 30 GHz frequency.a) What is the effective area Ae of the antenna? b) What is the antenna power gain in ratio and in dBi?
The far-field ranges of the wire antenna given in the figure at 5 GHz Find where it started . .
A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage source which has an internal resistance of 25 Ω) a) Make a diagram of the above system, b) Is an impedance matching circuit needed? If yes, where should the impedance circuit be inserted and make a diagram of the system with the adjusting circuit, c) How many cm is the length of the dipole antenna above, d) How much power is emitted when not using the adjusting circuit and e) How much power is emitted when using the adjusting circuit. Solve subparts D,E max 20 minutes ASAP
An antenna has a radiation resistance of 150ohm and is fed with an RMS current of 5A. If the antenna gain is 6 dB in a given direction, determine the power density and electric field strength at a receiving antenna 60 km away in this direction. Given that the effective area of the receiving antenna is 1.5m2, calculate the received power.
.Antennas and Propagation The audio power of the human voice is concentrated at about 300 Hz. Antennas of the appropriate size for this frequency are impracticably large, so that to send voice by radio the voice signal must be used to modulate a higher (carrier) frequency for which the natural antenna size is smaller. a)What is the length of an antenna one-half wavelength long for sending radio at 300 Hz? b)Suppose we would like a half-wave antenna to have a length of 2 m. What carrier frequency would we use? c)Suppose a transmitter produces 100W of power. Express the transmit power in units of dBm and dBW. d)If the transmitter's power is applied to a unity gain antenna with a 900-MHz carrier frequency, what is the received power in dBm at a free space distance of 100 m?
2.) The power density is 4 mW/m² at some distance R from an isotropic antenna. The isotropic antenna is replaced with a different antenna and the power density measured is now 60 mW/m² at the same distance R. What is the gain (in dB) of the second antenna? 3.) The received power at an airplane is calculated as Pr=-43 dBm at a range of 13 miles using free-space propagation. Determine the received power (in dBm) at a range of 52 miles.
AGILA satellite is located 36000 km above the earth’s surface. Assuming free space condition, what is the path loss in dB of the signal if the operating frequency is 3 GHz. (Use two decimal places for the final answer)