Q2/ A compound cylinder is formed by shrinking a tube of 250 mm internal diameter and 25 mm wall thickness onto another tube of 250 mm external diameter and 25 mm wall thickness, both tubes being made of the same material. The stress set up at the junction owing to shrinkage is 10 MN/m2. The compound tube is then subjected to an internal pressure of 80 MN/m2 Find the chrinkage allowance

Q2/ A compound cylinder is formed by shrinking a tube of 250 mm internal diameter and 25 mm wall thickness onto another tube of 250 mm external diameter and 25 mm wall thickness, both tubes being made of the same material. The stress set up at the junction owing to shrinkage is 10 MN/m2. The compound tube is then subjected to an internal pressure of 80 MN/m2 Find the chrinkage allowance

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A compound thin cylinder has a common diameter of 100 mm and the inner cylinder has a thickness of 2,5 mm. The radial pressure between the two cylinders is 200 kPa and the difference between the two common diameters before shrinkage was 4,305 X 10~3 mm. Determine the (a) thickness of the outer cylinder; (b) resultant hoop stresses in both cylinders if the compound cylinder is subjected to an internal pressure of 180 kPa (E = 200 GPa).
A compound cylinder is formed by shrinking one cylinder over another, the final dimensions being, inner diameter = 150mm, diameter at the junction = 200mm, outer diameter = 250mm. If the radial pressure at the junction due to shrinkage is 40N/mm2, calculate: (a) Initial stresses in the cross section of the tube. (b) If a fluid pressure of 80N/mm2is admitted in the compound tube calculate the final stresses. Plot the variation of hoop and radial stress across the wall thickness.
How can the theory be applied to find the maximum allowable shear stress for thick walled cylinders?
Part A, B, C Solved below, asking solution for part D, E, F, G
Hi! Can you please answer this problem with step-by-step solution? A pressure tank 5 m long and a mean diameter of 1 m is to be fabricated from a 10mm thick sheet. A 5 m-long 200mm wide, 10mm thick plate is to be used for sealing the gap by using two rows of 100 rivets each. the shear strength the of rivets is 200 MPa and the yield strength of the tank material is 200 MPa. Determine the maximum pressure and the minimum diameter fo the rivets that can be used for a factor of safety of 2.
for the power wouldn't it be desnity x Q x hp / 0.75 ? or did my professor make a mistake
In a hydraulic press a 690-liter volume of oil is subjected to a 6666-psi pressure increase. If the compressibility of oil is 2.0×10−5/atm,, find the bulk strain and the absolute decrease in the volume of oil when the press is operating.
The figure below shows a rectangular OB element made of 0.5 cm thick aluminum sheet, attached to the ground at one end and supported by a coil spring at point A. The spring was measured with a force of 10 kN, a 1 mm shrinkage. Find bending at point B using the Castigliano method.
Calculate the principal stresses to the given state. Calculate the angle of rotation in the x-y plane. Calculate the extreme shear stresses. Are the extreme shear stresses the maximum shear stresses? Explain, Why or why not?
Is the axial stress generally smaller than the stress developed by shear?
What is the strain in an axis-symmetric, unconstrained, thin-walled pressure vessel?
Give example of solid bars behave as springs under the influence of a force.