Q2 C only thank you

Q: 4ax + Say - zaz dimensions 3 cm by 6 cm lying on y = 5 in the +y-direction. O 56.55 mWb; O 45 kWb; O…

A: We need to find out the flux Passing through the given surface

Q: Determine the equivalent resistance between terminals a and b. a b m www 10 ohms 5 ohms 4.4524 ohms;…

A:

Q: Q10- Design Colpitts oscillator to generate sine wave with frequency equal to 3 KHz, with gains…

A:

Q: Determine the equivalent resistance between terminals a and b. 9.6540 Q 8.2756Q 9.2715Q O 8.3025 Q…

A: In this question we need to find a equivalent resistance between terminal a and b

Q: 4- Consider the system shown in Figure 1. To improve the performance of the system a feedback is…

A:

Q: ANALOG ELECTRONIC (FET) Determine the operating point of the amplifier by finding I(DQ) and V(GSQ)…

A: The required parameters can be calculated by using DC analysis of the amplifier circuit.

Q: a- b r1 5 Ohms V1 15 V www i1 r2 3 Ohms i2 V2 8 V 믐 R_LOAD ww 10 Ohms r3 3 Ohms i3 V3 + 믐 3 V

A:

Q: Find V, in the circuit below ww 4 ΚΩ 4 ΚΩ 6V (2mA 2 mA + (1) 2 ΚΩ 4 mA Σ2 ΚΩ Vo

A: This is a basic problem of circuits. The voltage Vo can be calculated by applying nodal analysis and…

Q: A. Measure the current through and voltage across the load on PR1. Calculate also the complex power…

A: Given V= 25 V rms f= 60 Hz ω=2πf =377 rad/sec V=2 ×25 ∠0  =35.355 ∠0°  V   converting inductance and…

Q: What is a Multiplexer and draw the diagram of 4 x 1 multiplexer?

A:

Q: Question 33 Given the circuit below, determine the magnitude of the current through the 20-volt…

A: Brief description: For the given electrical circuit we need to calculate current flowing through the…

Q: Q3: Determine the Nyquist rate of sampling required for the signal g(t)=e^(-2|t|) (Approximate the…

A:

Q: Table 3: Amplifier device parameters and circuit components hie = 1.4 kΩ; hfe = 90; hoe = 10 x 10-7…

A: The Given data is hie=1.4 kΩ; hfe=90; hoe=10 x 10-7;Cc=6 pF; Cp=46 pF;Lp=150uH; Rw=5 Ω;Ls=80uH; Rs=5…

Q: (b) (i) (ii) (iii) F 47μF 47μ Figure 1.1. Figure 1.1 shows an electrolytic capacitor. What…

A:

Q: Impedances Z1 = 5.83 at angle of -59 deg. and Z2 = 8.94 at an angle of 63.43 deg. are in series and…

A:

Q: *14. For the circuit of Fig. 19.51: a. Find the total number of watts, volt-amperes reactive, and…

A:

Q: Q3: Determine the Nyquist rate of sampling required for the signal g(t)=e^(-2|t|) (Approximate the…

A:

Q: Compute for the voltage vab O-13.7037 V O-12.5784 V -13.3752 V a R5 2 Ohms V3 미다 10V V1 20V R6 ww 9…

A: Given

Q: Determine the Acl of this amplifier configuration if Vin = 15 mV. Rf www 330 ΚΩ R₁ www Vin Va 33 ΚΩ…

A: Given:

Q: A reactor of resistance 50 ohms and inductance of 150 mH is connected in parallel with a capacitor,…

A: Condition for resonance is capacitive reactance should be equal to inductive reactance. So,…

Q: space, a cylinder has base area 9π square meters and height 2 meters. If it carries a total current…

A: We need to find out the magnetic flux density for given current distribution

Q: 7. R G₁ 64 Gs 6₂ H₂ Ga

A:

Q: Y12 is determined using:     I1 / V1     I2 / V1     I1 / V2     I2 / V2

A:

Q: 41. What are the Salient Features of Indian Grid Codes for Wind Power Generation?

A: (41) The salient features of Indian Grid Codes for Wind power generation are: a. IEGC stands for…

Q: Question 6 Consider a closed-loop control with the following loop transfer function: 1 L(s) =…

A:

Q: A long solid conductor with diameter 2 cm carries a current of 32 A uniformly over its cr section.…

A: In this question we will find magnetic field H at given distance due to long solid conductor....

Q: From the figure shown below, find the duty cycle, trigger voltage level, threshold voltage level,…

A:

Q: 40 ΚΩ VB.VG 10 ΚΩ 916 V IB 2.2 ΚΩ # Vs.Vcllc VDs + -OVD VE OLIE VCE 1.2 ΚΩ IDSS = 6 mA Vp = -6 V B:…

A:

Q: An antenna has a loss resistance, Re=10Ω and a radiation resistance of Rr=120Ω. Determine the…

A:

Q: What will be the front and back pitches of the 6-pole dc generator with a simplex 2-layer wave…

A:

Q: Problem 2. A 20-ohm resistor is connected in parallel with a variable resistor R. The parallel…

A:

Q: Define Shift register and draw four-bit shift register using D-Flipflop.

A: Since these are two different questions, in the following section, the first question will be…

Q: By applying the two golden rules of ideal operational amplifier circuits and the superposition…

A: The Given circuit is      It is Ideal op-amp; The Voltage gain V0=R2R1V2-V1

Q: From the circuit below, calculate the resonant frequency. 65 Hz O 32.5 Hz O 16.25 Hz O none the…

A: In this question we need to choose a correct option

Q: A sinusoidal alternating voltage has an RMS value of 440 V and a frequency of 50 hz. It crosses the…

A: It is Given that: Vrms=440 volts Frequency f = 50Hz Therefore, w = 2πf w= 100*3.14 w= 314 rad/sec…

Q: Find the two elements of a series circuit having current i = 4.24cos(5000t + 45°) A, power 180 W and…

A: In this question,  We need to determine the series elements if current flow in the circuit is i =…

Q: iven the circuit below, determine the magnitude of the current through the 20-volt source.

A:

Q: 3. Plot (sketch) x[n] = sinc() -k<n<k, when k = 5,10,15,30

A: Since you have posted multiple questions, we will solve the first question for you. If you require…

Q: An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel…

A:

Q: E = 50 V 260° Load 1 Load 2 5. For the system of Fig. 19.44: a. Find PT. Qr. and ST. b. Find the…

A:

Q: 5% and loss resistance of 21 Ω, what is the radiation

A:

Q: 5. A four wire, three phase system has a balanced supply voltage of 208V. Three wattmeters are…

A: Given data, Line voltage VL=208 V Circuit diagram is given as,

Q: Three purely resistive loads, each of 100 ohms, are connected in wye to a three-phase, 110-V supply.…

A: Given  A three phase supply and the load connected to it.we need to determine the line current and…

Q: Determine V, for the following network using a. Superposition theorem b. Norton's theorem 4 Ω W 12 V…

A: given here a circuit and asked to find VX by using superposition and norton theorem.

Q: Consider a closed-loop control with the following loop transfer function: 1 L(s) = Ge(s)G(s) = s(4s…

A: The Given close loop Transfer function is Ls=GcsGs=1s4s+16s+1 The Phase angle of Ljω=-180°

Q: Example12/ Open write T-L with L=30 m, ZR = Zo = 502, f=50 MHZ Find Z, and Za d = 10 m Use the…

A: We need to find out the impedance on transmission line

Q: Implement Four-to-one-line multiplexer with Logic diagram and Function table.

A:

Q: The computation for the magnetic force due to a current carrying conductor requires the following…

A: We know  Force on a current carrying conductor in the magnetic field is given by F= I.l×B Where B:…

Q: Simplify the following Boolean functions by tracing it on a K  Map, grouping of blocks the best…

A:

Q: 0. Determine the value of capacitor and inductor for given impedance matching circuit in Fi 1.…

A: Impedance matching refers to connecting a load to the generator input inorder to obtain the maximum…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.