Answered: Q2: Gata AB Fig, below, 6m wide and…

Name: Q2: Gata AB Fig. below, 6m wide and weight 5 kN, it is hinged at B,de
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Q2: Gata AB Fig. below, 6m wide and weight 5 kN, it is hinged at B,determine the water level h, which will just cause the gateto open.5 mWater8mWaterв6 m

Engineering

Mechanical Engineering

Q2: Gata AB Fig, below, 6m wide and weight 5 kN, it is hinged at B, determine the water level h, which will just cause the gate to open. 5 m Water Water B o E

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
Hydrostatic: A 2-m-wide, 3-m-high vertical rectangular gate has its top edge 2 m below the water level. It is hinged along its lower edge. What force, acting on the top edge, is necessary to hold the gate shut?
A triangular gate having horizontal base of 1.0m and an altitude of 1.5m is inclined 45° from the vertical with the vertex pointing upward. The vertex of the gate is 2.4m vertically below the surface of the water. What normal force , in KN, must be applied at the vertex of the gate to open it's hinged at the base?
Q2/A rectangular plate of AB 1.2 meter by 5-meter size is immersed in water. The plane of the plate is inclined at 45° with free water surface and the end of plate at(B) a depth of 5 meters from water surface. Find the total pressure on the plate and the position of center of pressure.
A rectangular car is 3 m. long by 1.5 m wide and 1.5 m deep. If friction is neglected and the car rolls down a plane with an inclination of 20 degrees, what is the inclination of the water surface if the car contained 0.60 m depth of water when the car was horizontal?
In Fig., gate AB is 5 ft wide into the paper, and stopB will break if the water force on it equals 9200 lbf. Forwhat water depth h is this condition reached?
Gate AB in the figure below is a 5-ft wide, vertical, rectangular gate, hinged at A and restrained by a stop at B. The water depth, h = 9.5 ft. Determine: a) the hydrostatic force acting on the gate and the location of the center of pressure b) The vertical and horizontal reactions at the hinge at A.
An open cylindrical tank has a base diameter of 1.2 meter and contains 3.86 meter deep water. the tank is rotated about its vertical axis at 80 rpma. What is the maximum height of the tank so that no water will spill at 80 rpm? b. If ω = 140 MPa, what will be the pressure at the center bottom of the tank?
A door in the side of a tank is 3.1 m wide and 5.2 m high, the tank is filled to the top of the door with water of density 1000kg/m3. What is the force on the door in N?
The inverted U-tube manometer of Fig. contains oil (SG 0.9) and water as shown. Find The pressure differential between pipes A and B. If a =1.5 m , h= 90 cm and b=2 m.
For the inverted manometer shown in the figure, all the fluid are at 20 0C. If PB - PA = 687 kPa, What must the height H be in cm. Take water density = 1000kg/m3 Mercury density = 13600kg/m3
A tank of water (SG = 1.0) has a gate in its vertical wall 5 mhigh and 3 m wide. The top edge of the gate is 2 m below thesurface. What is the hydrostatic force on the gate?( a ) 147 kN, ( b ) 367 kN, ( c ) 490 kN, ( d ) 661 kN,( e ) 1028 kN