Q3:B) A rectangular gate (length 3m, wide 1m) inclined at 50⁰ with the horizontal level and hinged at point to the bottom of the tank. The weight of the gate is 9000N; calculate the minimum height of the water (h) in the left side of the gate, which cause to open the gate automatically? WATER प 1.2m.

Q3:B) A rectangular gate (length 3m, wide 1m) inclined at 50⁰ with the horizontal level and hinged at point to the bottom of the tank. The weight of the gate is 9000N; calculate the minimum height of the water (h) in the left side of the gate, which cause to open the gate automatically? WATER प 1.2m.

Name: Q3:A) List the devises that used to measure the velocity, pressure,vo
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Q3:A) List the devises that used to measure the velocity, pressure,volume flow rate and sketch each of them with equations.Q3:B) A rectangular gate (length 3m, wide 1m) inclined at 50⁰with the horizontal level and hinged at point to the bottom of th

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

If the rectangular tank full of water in Fig. P3.37 has itsright-hand wall lowered by an amount δ , as shown, waterwill fl ow out as it would over a weir or dam. we deduced that the outfl ow Q would be given byQ = C b g1/2δ3/2where b is the tank width into the paper, g is the accelerationof gravity, and C is a dimensionless constant. Assumethat the water surface is horizontal, not slightly curved as inthe fi gure. Let the initial excess water level be δ o . Derive aformula for the time required to reduce the excess waterlevel to ( a ) δ o /10 and ( b ) zero.
can you please solve this for me thanks,The increase in flow energy of a 10 ft3 of fluid passing a boundary of a system is 80,000 ft-lb. Determine the exit pressure if the inlet pressure is 100 psi.
A two storey building has two faucets, one in the basement and one in the firstfloor. The maximum water (ρ = 1000 kg/m3) velocity at the basement faucet, when the first floor faucet is closed, is 13 m/s. The faucet diameter is 1.5 cm.Neglect all losses. What would be a maximum height (from the basement floor) for a faucet,to still get a maximum exit velocity of 6 m/s?
Torricelli’s idealization of effl ux from a hole in the side ofa tank is V = √2 gh, as shown in Fig. P3.81. The cylindricaltank weighs 150 N when empty and contains water at20 °C. The tank bottom is on very smooth ice (static frictioncoeffi cient ζ ≈ 0.01). The hole diameter is 9 cm. For whatwater depth h will the tank just begin to move to the right?
Consider a geyser that shoots water to a height of 28 m into the air.Density of water, rho = 1000 kg m-3, acceleration due to gravity, g = 9.81 ms-1, atmospheric pressure, Patm = 101250 Pa. How fast is the water traveling when it emerges from the ground, If the water originates in a chamber 44 m below the ground, what isthe pressure there (consider there is NO friction within the chamberand that the water can be considered to be stationary)?
Answer seems to be 736kpa, please show Formula and calculation as fast as (handwritten only) A 75-m-high water body that is open to the atmosphere is available. Water is run through a turbine at a rate of 200 L/s at the bottom of the water body. The pressure difference across the turbine is
For a tank, calculate the volumetric flow of water, which comes out through a pipe, the tank is sealed, the depth is h1=2M, Qexit=0.05,substance water Vexit=? and Q=?.
An open vessel of water accelerates up to a 30ᵒ plane at 2 m/s². a). What is the angle the water surface makes with the horizontal? B). If the angle mage by the water surface to the horizontal is increased to 25.21ᵒ, what will be the depth of water at the rear side of the vessel, if the initial depth of water at the rear side is 4m and the front is 2m before accelerating? The vessel has a length of 4m and 2m width. C). If the vessel’s depth at the rear side is 5m, what will be the volume spilled if the acceleration is increased to 15m/s²?
A typical pump has a head that, for a given shaft rotationrate, varies with the fl ow rate, resulting in a pump performancecurve as in Fig. P3.181. Suppose that this pump is75 percent efficient and is used for the system in Prob.3.180. Estimate ( a ) the flow rate, in gal/min, and ( b ) thehorsepower needed to drive the pump.
A fi sh tank 14 in deep by 16 by 27 in is to be carried in acar that may experience accelerations as high as 6 m/s 2 .What is the maximum water depth that will avoid spillingin rigid-body motion? What is the proper alignment of thetank with respect to the car motion?
In Fig. P3.131 both fl uids are at 20 ° C. If V 1 = 1.7 ft/s andlosses are neglected, what should the manometer readingh ft be?
The tank in Fig. is fi lled with water and has a venthole at point A. The tank is 1 m wide into the paper. Insidethe tank, a 10-cm balloon, fi lled with helium at 130 kPa, istethered centrally by a string. If the tank accelerates to theright at 5 m/s 2 in rigid-body motion, at what angle will theballoon lean? Will it lean to the right or to the left?