Q2. (Continued) (b). In the figures shown Figure Q2(b)(i), describe if the energy is conserved in each of the activity described in the figure. Support your description with appropriate equations. Figure Q2(b)-(b) A roller coaster moving along smooth track. Figure Q2(b)-(a) A car is driven down a slope. Figure Q2(b)-(c) A bungee jumping from a tower. Figure Q2(b) (15 marks)

Q2. (Continued) (b). In the figures shown Figure Q2(b)(i), describe if the energy is conserved in each of the activity described in the figure. Support your description with appropriate equations. Figure Q2(b)-(b) A roller coaster moving along smooth track. Figure Q2(b)-(a) A car is driven down a slope. Figure Q2(b)-(c) A bungee jumping from a tower. Figure Q2(b) (15 marks)

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 24P

See similar textbooks

Similar questions

fluıd mechanıcs If an oil tank is pulled uphill on a surface that makes an angle of 162 with the horizontal, the oil makes an angle of 160,a) Show the forces acting on the tank on the figure. Write the balance of force.b) Calculate the constant acceleration of the tank being pulled uphill.
A right circular cylindrical container 3m in diameter and 4 m high is ½ full of water. When rotated about its vertical axis at the rate of 5 radians per second, what is the volume of the paraboloid formed by the rotation of the vessel? Unit of the Correct Answer: m^3 An open cylindrical tank one meter in diameter and 3 m high is 3/5 full of water. If the tank is rotated about its vertical axis, what speed should it have in rpm so that the water could just reach the rim of the tank. Unit of the Correct Answer: rpm
Show the freebody diagaram and a complete and detailed solution. To hold the system in equilibrium, find M if the mass of each pulley is 5kg.
Consider a rectangular plate of width B = 1m (measured in the direction normal to the plane of this sheet) and negligible thickness, which separates two fluids of densities ρ and ρw. A mass of density ρs is supported by an inextensible rope that passes through a pulley connected to one end of the plate. Consider that ρ = 1.59ρw and ρs = 2.40ρw, where ρw = 1000 kg/m3. Determine the volume that this mass must have for the system to remain in equilibrium, as shown in the figure.
Oil is filled within a tall cylindrical tank. A flat disk with a height of 1 cm and with a diameter of 5 cm is placed into the oil. There occurs a narrow spacing of 0.1 mm between the disk and the tank wall. Due to the forces acting on the disk, it moves downward, and after some time, the speed of the disk reaches a terminal velocity. Beyond this moment, measurements reveal that the disk moves 30 cm in 4 seconds. If the oil density is 600 kg/m3and the specific gravity of the disk is 1.5, determine the oil’s viscosity.
An open vessel 4.0m wide, 5.0m long and 3.5m deep contains 3m of water. It is then accelerated to the right along its width. a. Calculate the acceleration just about water to spill. b. At this rate, what is the force (in N) causing the acceleration if the mass of the vessel if the mass of the vessel is 600kg? c. Consider the same vessel accelerated at 7.00 m/s2. Determine the volume (in m3) of water spilled at that acceleration.
A 40 mm plastic sphere (?? = 1.3) is dropped in a certain oil (?? = 0.85, μ =3.6 × 10−2 Pa∙s).(a) Determine its terminal velocity(b) If this sphere starts to rotate at 25 revolutions per second in the clockwise direction. Determine the magnitude and direction of the Magnus force
The water system in a suburban area consists of an old 200mm pipeline 760m long which conveys water from a pump to a reservoir whose water surface is 107m higher than the pump. Water is pumped at the rate of 0.07 m3/s. Determine the horsepower saved by replacing the old pipe with a new 250mm pipe. Assume the value of f as equal to 0.022 and 0.033, respectively, for the old and new pipes. Neglect losses of head except friction head show the diagram and complete solution. Need ASAP. Thank you
In the given figure, W= 200kg. Assume that the coefficient of friction between surfaces is 0.40. Which of the following most nearly gives the reaction between the block and the wedge if the block is raised due to the applied force P?
A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5 m at the top. Gas with a unit weight of 0.12 N per cubic meter enters the bottom of the tank with a uniform velocity of—assume values with decimals between 3 to 4 m per second—enters the stack. The unit weight increases by 7.5 percent every 2 meters. Find the velocity of flow at every 5 meters along the stack. Please answer this with complete solutions and figure. Thanks
For the system shown, the masses of A and B are 55 kg and 135 kg respectively. The coefficient of static friction between block B and the surface C is 0.12 and the coefficient of static friction between blocks A and B is 0.10. The coefficient of friction between the rope and the pulley is 0.10. What is the maximum mass M that can be suspended as shown and still maintain equilibrium?
Shown in the figure below is a small decorative wheel fitted with flat paddles so the wheel turns about its axis when acted upon by a blown stream of air. Assuming that all the air in a 15-mm-diameter stream moving at 0.35 m/s strikes one paddle and is deflected by it at right angles, compute the force exerted on the wheel initially when it is stationary. The air has a density of 1.20 kg/m3 . The paddle is on a horizontal plane.