Q3) A 2-kW resistance heater wire with thermal conductivity of k 20 W/m - °C, a diameter of D = 5 mm, and a length of L = 0.7 m is used to boil water. If the outer surface temperature of the resistance wire is Ts = 110°C, determine the temperature at the center of the wire. Ans: 121.4 °C 110°C Resistance heater

Q: 88: Two liquid (P and Q) having same viscosity are following through a double pipe heat exchanger as…

A: Given that  density of liquid PρP=1000Kgm3densiity of liquid QρQ=800Kgm3average velocity of…

Q: Two hundred mol/h of (CS1112) and 7000 moth of air Ped in to a combusition reactor Calculate the…

A: Given that, Molar flow rate of C5H12 = 200 mol/h Molar flow rate of air = 7000 mol/h It is required…

Q: 8. B. friction factor imbers 7 to 9, e given U-tube manometer, mercury was used in the manometer to…

A: Density of Hg mercury Dhg = 13600 kg/m3 Density of water Dw = 1000 kg/m3

Q: A liquid containing 70 mol % benzene (A), 30 mol % toluene (B) is flash-vaporized at 1 std atm…

A: A mixture of benzene and toluene is flash vaporized at given T and P.

Q: Air expands adiabatically in a piston-cylinder assembly from an initial state where p₁ = 100…

A: Given that- Air expands adiabatically in a piston-cylinder assembly for which initial states are,…

Q: Derive the transfer function of the feedback closed- loop Control System from the block diafrom…

A: We can find the, the transfer function by using closed loop reduction method. And for stability…

Q: I apologize upfront, but I do not understand the solutions here. I cannot follow along due to the…

A: Note: We are not authorized the provide the handwritten solution, please follow the typed solution.…

Q: Follow the standard energy balance steps to determine the water condensed and the heat removed from…

A: a)  b) Degree of freedom analysis Number of unknowns = 4 (Q, n1, n2, y) Number of independent…

Q: etermine the percentage humidity of air at 19.643 degree Celsius with a relative humidity of 80%,…

A:

Q: CHAPTER 10 10-15 Water is to be boiled at atmospheric pressure in a mechanically polished steel pan…

A: Given:  Water is to be boiled in a polished pan of d = 30 cm or 0.3 m at atmospheric pressure. At…

Q: An acetone and water liquid mixture is fed to an evaporator to be partially vapourized. The initial…

A: A mixture of acetone and water is to be partially vaporized.

Q: Can you explain if the answer to part b physically reasonable?

A: Given time of evaporation of the droplet(t0) is t0=CA(L)R22cDABln11-xAR Where CA(L) is molar density…

Q: Determine the energy loss if carbon tetrachloride at 25°C flows 250 m through a standard DN 100-mm…

A: Given: The inner diameter of a 100 mm Schedule 40 pipe is equal to D = 102.26 mm = 0.102 m The…

Q: ( Acetylene is produced from methane in the reaction: 2CH4 (g) → C₂H₂ (g) + 3 H₂ (g) An undesired…

A: Write the reaction as follows: 2CH4g → C2H2g +3H2g Two moles of CH4 is decomposed into 1 mole of…

Q: 2. (20%) Given the below block diagram, derive the transfer function Y/U₁' in terms of the various…

A:

Q: 2. Describe a typical polymer molecule in terms of its chain structure and how the molecule may be…

A: Take the hydrocarbon ethylene (C2H4), which has the following molecular structure and is a gas at…

Q: since im not given that information to find z, is there any other way to find the value or solve for…

A: Given data: Molar flow rate of methane = 125,000 mol/h Absolute pressure = 233 psi or 16.06 bar…

Q: An LDPE polymer is having 200 monomeric units in its structure. The molecular weight of the polymer…

A: Given data: Molecular weight of the polymer = 10000 g Number of monomeric units = 200

Q: Q1/ Ideal gas is cooled at constant volume (2.23 m³/kmol) from an initial state of 4°C to final…

A:

Q: A standard 0.4-in. flange-tap orifice is installed in a straight horizontal length of standard 2-in.…

A: Given that- Diameter of pipe, D1 =2.067 inch= 0.0525 m Diameter of orific, D2=0.4 inch= 0.01016 m…

Q: A 15kg sample of water is held at 200°C in a variable-volume container (a piston-cylinder…

A: Given data: Mass of the sample = 15 kg T = 200 0C Specific volume of the mixture = 0.1 kg/m3

Q: A 1,1,2-trichloroethane-acetone solution containing 42% acetone by weight at a flow rate of 1200…

A: A mixture of carrier solvent and solute is contacted with the impure solvent (water) to extract the…

Q: Q4) Estimate the fugacity of isobutylene as a gas: (a) At 280°C and 20 bar (by using 2nd virial…

A: Given data: T = 280 0C OR 553 K P = 20 bar

Q: Q.21 An aqueous sodium chloride solution (10 wt%) is fed into a single effect evaporator at a rate…

A:

Q: 11-65 In a textile manufacturing plant, the waste dyeing water (c=4295 J/kg-K) at 80°C is to be used…

A:

Q: A benzene-air mixture is to be scrubbed in a simple counter-current absorption tower using a non-…

A: Benzene is separated from air-benzene gas mixture with the help of a liquid solvent.

Q: Make a flow chart of the process, showing all the steps in the process and labeling all of the input…

A:

Q: 10-32 A 1-mm-diameter nickel wire with electrical resis- tance of 0.129 2/m is submerged…

A: Given details: Diameter of wire, D=1 mm =0.001 m electrical resistance of wire , R=0.129 ohm/m…

Q: A process vessel is to be designed for the maximum operating pressure of 500 kN/m². The vessel has…

A:

Q: A liquid super conductor E is produced from its water solution by staged evaporation and…

A: Given: Data Temperature, °C Wt.% E in saturated solution 20 5.71 30 7.23 100 31.0

Q: The homogeneous gas phase reaction A -> 2R is irreversible and of first scheme. At 750 K, the…

A: Given:  The first-order gas-phase reaction taking place in a tubular reactor is A → 2R, at T =750 K,…

Q: ///C:/Users/MEGA/Downloads/Cengel.%20Heat%20and%20mass%20Transfer%20Fundar 10-10 Water is boiled at…

A: 10-10) Given, Water is boiled at temperature = 120°C The inner surface of the bottom of the cooker…

Q: Couldn't you use these equations

A: The molar flux of a species (A diffusing through non-diffusing B) is calculated using the following…

Q: In a solid-liquid extraction process operated on the principle of continuous counter current, the…

A: Meat is to be extracted in a continuous counter current multistage extraction process.

Q: The rate of the following reaction has been found to be first-order with respect to hydroxyl ions…

A:

Q: Write the number of the appropriate answer from list B in front of list A List A 1 Material balances…

A: The correct pairing between lists A and B is as follows: 1) Material balances: In order to start…

Q: L. 60 P=1 Q1/A cylindrical core sample has a length of 6 cm and a diameter of 1 inch. the sample is…

A: given = L = 6cm D = 1 inch = 2.54 cm  hence r = 1.27 cm hence the volume of a cylinder V = πr2hV =…

Q: An ideal Diesel operates with a compression ratio of 14. The compression process begins with air at…

A:

Q: Consider the following hypothetical chemical reaction: As (aq) + 4B (g) → C(s). An experimental run…

A: Given details, reaction, A+4B→C B consumed ,V=1500 mL=1.5 L P=2 atm T=50 C = 50+273 =323 K…

Q: A natural gas-fired industrial boiler operates with an oxygen concentration of 3 mole percent in the…

A: GivenFuel burnt =CH4Mole fraction of O2 in the combustion gas mixture=mol %100=3100=0.03To finda)…

Q: Aqueous sulfuric acid (H₂SO₂) will react with solid sodium hydroxide (NaOH) to produce aqueous…

A: Given that, Reaction: H2SO4 + 2NaOH → Na2SO4 + 2H2O The mass of sulfuric acid mH2SO4 = 7.8 g The…

Q: A shell-and-tube heat exchanger consists of 120 tubes of internal diameter 22 mm and length 2.5 m.…

A:

Q: Problem 3: A heat pump operating at steady state maintains a dwelling at 22°C on a day when the…

A: COP=Q/Win

Q: Experimental Value of Hoc. Using the experimental data given in Problem 10.6-8, calculate the number…

A: Acetone is absorbed from the air. Operating conditions are, T = 293 K P = 101.32 kPa Packing = 25.4…

Q: (d) A continues stream of humid air contains water vapor and dry air, the latter containing…

A: Introduction:- A mixture's mole fraction is calculated by dividing the number of molecules of a…

Q: Combustion basics UNIVERSITY OF LEEDS Calculate the AFR for the combustion of methane with…

A: Write the reaction as follows: CH4+2O2+3.76N2 → CO2+2H2O+7.52N2   1 mole of CH4 reacts with 2 moles…

Q: Example: A 40 kg steel casting ( Cp = 0.5 kJ/kg.K) at a temperature of 450°C is quenched in 150 kg…

A: Given data: Cp,casting = 0.5 kJ/kg.K Mass of the casting = 40 kg Initial temperature of casting =…

Q: One hundred mol/h of butane (C4H10) and 5000 mol/h of air are fed into a combustion reactor.…

A: Given details: molar flow rate of butane, m=100 mol/h molar flow rate of air,M=5000 mol/h   we need…

Q: Q.3 Two Infinite Black plates at 1800k and 180C² exchange = heat by radiation calculate heat…

A: Given that- Two infinite black plates are at, temperatures T1=1800 K T2=1800C= 453 K The diagram can…

Q: what is the intracellular concentration of M-OPO32? F

A: