Derive the transfer function of the feedback closed- loop Control System from the block diafrom shown in the figure Determine the Kc values that ensure stable operation of the Control System. экс S+lo 2 25 +1 Stu 45+1 CV (s)

Q: 59: A metal wire of 0.01m diameter and thermal conductivity 200 W/(m.K) is exposed to a fluid stream…

A:

Q: 5. A Carnot heat engine receives 650 kJ of heat from a source of unknown temperature and rejects 250…

A:

Q: Aqueous hydrochloric acid (HC1) reacts with solid sodium hydroxide (NaOH) to produce aqueous sodium…

A: HCl + NaOH = NaOH + H2O Molar mass of NaOH = 40 g/mol Molar mass of HCl = 36.5 g/mol     x…

Q: # 1 2 4 5 3 Citric acid 6 7 8 Chemical process/ product manufacture Biodiesel 9 Methanol Aspirin…

A: The question asked is which three topics are easiest for this report writing.

Q: Question) Draw the following by Chemdraw and write the Molar Mass?

A: 1) 4-chlorobenzaldehyde molar mass = 140.57 g/mol 2) 2-Pyrrolecarboxaldehyde molar mass = 109.13…

Q: T2=45 °C 1-25 °C TI=45 °C 12-40 °C

A:

Q: 1. The elementary gas-phase reaction A+B+2C is carried out in a packed-bed reactor. The entering…

A: Write the reaction as follows: A +B→ 2C   (a) Write the mole balance as follows: -rA = FA0dXdV…

Q: Q3/ The bulk volume of the core sample is 150 cm³ and its porosity 18%. The pore compressibility of…

A:

Q: Reactants (B) and (C) react at 25°C as shown below: B + C R The reaction is in the liquid phase. The…

A: A bimolecular reaction is carried out in a well stirred batch reactor.

Q: Estimate the diffusivity of acetic acid diffusing through air at 298 K at 2 atm using the Fuller-…

A:

Q: Consider a reaction where A is converting to B. A B The reaction is known to be of first order and…

A: Write the reaction as follow: A→ B   The molar flow rate of A, FA0 = 0.4 mol/s

Q: Mark Cuban is a billionaire investor in a hit business reality TV-series called Shark Tank. An…

A: Dear User! As the question has been posted in Chemical Engineering, we reckon that its intent is to…

Q: etermine the percentage humidity of air at 19.643 degree Celsius with a relative humidity of 80%,…

A:

Q: Air at 1 atm and 400 K and with a velocity of U∞o = 10 m/s flows across a compact heat exchanger…

A:

Q: A low grade fuel oil containing approximately 80% C, 10% H, 4% 0, 4% N, and 2% S is burned in a…

A:

Q: In a plug flow reactor, a gaseous feed of pure A (2 mol/L, 100 mol/min) decomposes to give a variety…

A: Write the reaction as follows: A→2.5 products   The concentration of pure A, CA0 = 2 mol/L The molar…

Q: Liquid mercury has a molar volume of 0.01465 dm3 mol-1 and solid mercury a molar volume of 0.01413…

A: Write the Clapeyron equation as follows: dPdT = ∆HfusT∆VdPdT = ∆HfusTVl-Vs Integrate the above…

Q: Estimation of Liquid Diffusivity. It is desired to predict the diffusion coefficient of dilute…

A: Given that- Solution of dilute acetic acid in water at, T1=282.9 K T2=298 K  As per Wilke-Chang…

Q: 68. The mineral manganosite is a compound of manganese-55 and oxygen-16. If 77% of th mass of…

A:

Q: 1 mol of a mixture consisting of 30% methane and 70% propane is burned in stoichiometric air.…

A:

Q: The aqueous acetone solution is mixed with Methyl isobutyl (MIB) solvent containing 3% acetone by…

A: Given, The molar flow rate of the lower stream, B = 400 kg/h The molar flow rate of the upper…

Q: 5- Air, at 100 °C, flows through a thin-walled steel tube with an inside diameter 25 mm. The wall…

A:

Q: Determine the energy loss if carbon tetrachloride at 25°C flows 250 m through a standard DN 100-mm…

A: Given: The inner diameter of a 100 mm Schedule 40 pipe is equal to D = 102.26 mm = 0.102 m The…

Q: (1) Identify each of the following half-reactions as either an oxidation half-reaction or a…

A: 1) if an element gain electron, then it undergoes reduction and if its losses electrons it undergoes…

Q: Using the rate equation k = 96 lit/hr kg cat, determine the amount of catalyst needed in a packed…

A: Given: The reaction given is, A → 4R, and the conversion is X = 0.35. The molar flow rate is FAo =…

Q: 1) A mixture of 62 wt% water, 28% methyl isobutyl ketone acetone and the remainder acetone are…

A: A mixture of water, MIBK, and acetone is brought to equilibrium.

Q: ropylene oxide (C3H8O) is produced by reacting propylene (C3H6) with oxygen and hydrogen. A side…

A: A mixture of propylene, hydrogen, oxygen, and carbon dioxide is fed to a continuous reactor.

Q: In a solid - liquid extraction process operated according to the principle of continuous reverse…

A: A mixture of solids, hexane and oil is to be extracted with the help of pure hexane in a…

Q: 10.3% and flows at the rat alculate: ressure of each component.

A:

Q: 100 mols per second of ammonia (NH3) is burned with 20% excess O2 based on fresh ammonia feed)…

A:

Q: 1) Explain why simple distillation cannot be used to separate crude oil intovarious fractions.…

A: Simple distillation involves only one boil and recondensation of the mixture, which leaves room for…

Q: Prepare a Layout of plant items, Process flow sheet and Process Instrumentation diagram of the Vinyl…

A: Introduction Vinyl acetate is a colorless, flammable liquid that also has a characteristic fruity…

Q: ma Q2/ A closed pressure vessel contain 100 kg of liquid water and 2 kg of water vapor at…

A: Given data: Mass of liquid water = 100 kg Mass of water vapor = 2 kg T= 350 0C

Q: Q.4 Liquid methanol is pumped from a large storage tank through a 1.5-in. ID pipe at a rate of 5.00…

A: Given data: Internal diameter of pipe = 1.5 in Volumetric flow rate of fluid = 5 gal/min

Q: 1) Steam at 325°C and 8 bar pressure is produced from liquid water at 21°C in a boiler. 556 kW of…

A: Given, The amount of heat supplied to the liquid water, Q˙ =556 kW Here 10% of the energy supplies…

Q: Calculate the enthalpy of sublimation of Iodine from the following data: H₂(g) + 1₂(s) → 2 HI(g) AHR…

A:

Q: 2. You need to design a heater to preheat a gas flowing into a chemical reactor. The inlet…

A: a) Inlet of the heater  temperature is 300K and the pressure is 50 bar hence Z is The outlet of the…

Q: The start-up procedure for a batch reactor includes a heating step where the reactor temperature is…

A:

Q: 8.8 For a mixture of 0.0786 mol of CH, and 0.1214 mol of CO, in a 700.0-cm³ container at 40°C,…

A: Given: Moles of C2H4 in the mixture is nC2H4 = 0.0786 mol and that of CO2 is nCO2 = 0.1214 mol Total…

Q: Minimum Liquid Flow in a Packed Tower. The gas stream from a chemical reactor contains 25 mol %…

A: Given data are as follows: Mole fraction of ammonia in entering gas stream y1 = 0.25 Entering molar…

Q: :):Uninsulated steam pipe passes through a room in which the air and walls are at 25 °C. The outside…

A: Given that- Surrounding temperature, Tsur=250C Outside diameter of pipe, d=70mm=0.07 m Surface…

Q: 5.) The phase diagram of sulfur, S8, is presented below. There are two crystalline forms, rhombic…

A:

Q: An elementary liquid phase reaction A+B>C was conducted in two continous stirred tank reactors…

A:

Q: Consider a system of air with a molar volume of 0.02479 m³/mol which undergoes thermodynamics…

A:

Q: for question C, why is the dot at when the atm is 1 rather than 0.0001?

A: Phase diagram of a compound is given.

Q: What is the primary function of the aeration step in water treatment?

A:

Q: The homogeneous gas phase reaction A -> 2R is irreversible and of first scheme. At 750 K, the…

A: Given:  The first-order gas-phase reaction taking place in a tubular reactor is A → 2R, at T =750 K,…

Q: percentage of O₂ on a wet basis.

A:

Q: 2. The liquid-level process shown in below Fig. is operating at steady state when the following…

A:

Q: please don't solve by handwritten What is a steady state process? Provide 2 examples of steady state…

A: Steady state processes are those process which does not change with respect to time or they are…