Q3- Find H and the pressure gage P as shown in Fig. 125 mm d H 75 mm d 175 mm 100 mm d Hg (13.57)

Q: 1300 m^3 to t

A:

Q: The cylinder shown in the figure extends 8 ft into the paper. If the cylinder has the radius of 4…

A: Radius of cylinder, R=4 ftlength of the cylinder, l=8 ft

Q: Q1) for the given gate find the force and it center of pressure, If H=6 m and K=3 m. Oil s.g =0.7 15…

A: Write the given data with suitable variables. d=1.5 ms.g=0.7H=6 mK=3 m

Q: e height h2 (in): Grou

A: To determine the h2

Q: In figure below pressure gage A reads 1.5 kPa (gage). The fluids are at 20 °C. Determine the…

A:

Q: Determine the hydrostatic force and its location by (a)integration method and (b)formula method.

A:

Q: Convert the following. 1. 2 tons to lbm  2. 347 KN-m to kip-ft

A:

Q: find Q ? and Pressure

A:

Q: 6) Determine the internal energy of water at 20 psi and 400 F

A:

Q: Find the unit for H. Show all steps

A: Given, all the units of each parameter Substituting these values in the above equation,

Q: Prob-7 Find the height of mercury (y=?) below manometer. PA=10 psi OI 3 ft Oil (s.g.= 0.90) -Mercury…

A: GIVEN DATA- A manometer device given we have to find height of limb y =? Pressure at A =10 psi =…

Q: y 1m 2 m 1 m

A: Vector is a physical quantity that has magnitude and direction both. Scalar is a physical quantity…

Q: Pressure 450.50 kPa at depth of 20-m: determine the unit weight in kN/m (UP TO THREE DECIMAL PLACES)

A:

Q: What would be the maximum weight W of the block, shown in the

A: Draw the FBD at point C Check the condition in which cable tension will be maximum Put the value of…

Q: For the dam shown in Fig. 2-1, find the horizontal pressure acting at the face of the dam at 20-ft…

A: given data -  depth at which pressure is to be found = 20 ft to determine - horizontal pressure

Q: A WATER TANK IS “L1” IN DIAMETER AND “L2” HIGH. IF THE TANK IS TO BE COMPLETELY FILLED, DETERMINE…

A:

Q: *2-32. Determine the difference in pressure PB - Pa between the centers A and B of the pipes, which…

A: Draw the figure.

Q: Three liquids of different densities fill connected tubes as shown in the figure below (not drawn to…

A:

Q: 6. Determine the pressure difference between the water pipe and the oil pipe shown in the figure…

A:

Q: Calculate the pressure difference between point A and B * 2m 3. 60 mm 40mm 4 (S = 13.56)

A: Here we have to find the Pressure difference between A and B.  For this purpose various manometric…

Q: Determine the pressure difference between point A and B. pv = 1000 kg / m3 , pk = 13600 kg / m3…

A:

Q: 2.) Given the two-compartment vessel shown in the figure. Gage A reads 85 psig: gage B inside…

A: Given data: -  The reading of gauge A is (PA)g = 85 psig. The reading of gauge B is (PB)g = 25…

Q: A closed pressurized tank shown below is filled with oil and mercury. Mercury is confined in an…

A:

Q: 2-45. The pipes at A and B contain oil and the inclined-tube manometer is filled with oil and…

A: Given : The density of oil = 1.70 slug/ft3 The density of mercury = 26.3 slug/ft3

Q: The standpipe is connected at C to the field storage tank with oil, and the system is open to the…

A: Given data:h1=9fth2=5.5fth3=8ftP0=1.78 slug/ft3

Q: Q1:- A steel cylinder floats on water, find the relative density of cylinder if the depth of…

A: Given data: The density of the of water is ρ=1000 kgm3 The depth of submergence is h=70 mm=0.07 m…

Q: Water Hinge If R=0.88 m and h=3.8 m, calculate the value of the force F needed to maintain the gate…

A:

Q: 4.) The pressure gage reading is 70 kPa. Find the weight (kN) of the piston. 1mø Piston 1 m Ol S…

A: The pressure exerted by the fluid at a point which is located at a depth of h from the surface is…

Q: h₂ Water dB *** da huy=370lmag dA=200 [mm] dB = so[mm] no friction find Q hng

A: The volumetric flow rate of water: Q = 18.8155 litres/ sec

Q: g15m Delamine fresine at depth inside liquid Jn suumming feool

A:

Q: Three smooth cylinders, each weighing 500 N, is placed inside a smooth box as shown in the figure.

A:

Q: 2. Given the two compartment vessel as shown in the figure. Gage A reads 85 psig, gage B inside the…

A: Consider the compartment X and write the expression of pressure in it.   PX=PC-Pbaro       ......…

Q: Pa) that suspends the elevator car in its shaft is 2500 N. How many mm will the elevator cable…

A: To find :- Cable strech

Q: interface in the right column to drop by 5 mm in the brine level in the right column while the…

A:

Q: D Ar 1 m 2.5 m B 8 m

A: Given

Q: The volume of the syringe’s reading read as 4cc when the weight (pressure) was 600 g. Determine the…

A: Initial Volume, V1=4 ccWeight for 4 cc volume, M1= 600gFinal Volume, V2=2.5 cc

Q: Determine the pressure difference at A and B

A:

Q: 2. Given the two compartment vessel as shown in the figure. Gage A reads 85 psig, gage B inside the…

A: Given Data  Gage pressure A reads =85 psig Gage pressure B reads=25 Psig Barometer reads in Hg…

Q: Determine the specific volume o of 5°C and a quality of 70%.

A: GivenT=5°Cquality=70%

Q: 1.) Water backs up behind a concrete dam as shown in the figure. Leakage under the foundation gives…

A: Given:specific weight of concrete=150 lb/ft3width of the dam, l=30 ft

Q: Prove that CIpoise = 0.1 dyne.sec cm2

A: Poise: The poise is the unit of dynamic viscosity. The unit of the viscosity is N·sm2 in the SI…

Q: Positions A-l are different points with respect to the atmospheric pressure as shown in the figure…

A:

Q: Find Stress Force=3 N Cross sectional area=1 mm2

A: Given data : Force=F Cross sectional area=A   Required : Stress

Q: Draw the hydrostatic pressure distribution diagrams on the surfaces. A | A |A h hi B h2 C D C E h3…

A:

Q: 04m 0.4 m 45° Figure Q3

A:

Q: Question 12 What is the resulting modulus of In (2 +3 j)?

A: To find: The resulting modulus of ln2+3j. Given: The complex function is ln2+3j. Formula used: The…

Q: Q1:-The gate AB as shown in fig.1 has long 1 m and wide 0.9 m .Find the force F on The gate AB and…

A:

Q: - Two cylinders M and N rest in a channel as shown in figure. The cylinder M has diameter of 6 cm…

A: Given dataCylinders M and N rest in a channelDiameter of the cylinder M Dm=6cmWeight of cylinder m…

Q: Q1) calculate stress tensor of a reservoir if you were given the following information: S1= 70 MPa,…

A: given; ⇒stress are given;⇒S1=70MPa⇒S2=80MPa⇒S3=35MPa⇒stress tensor =?⇒SHmax oriented to north…

Q: 3.6 The tube shown is filled with mercury at 20°C. Calculate the force applied to the piston. d = 10…

A: Given data ,D=50 mm=0.05 m        Density of Mercury At 20°d=10 mm= 0.01 m         ∫m=13,550…