Q3: The man is applying a force of 100N to the box. A mass of 300N is placed on an inclined plane as shown in the figure, if you know that us = 0.25 1- Draw the free body diagram (F.B.D) 2- Determine if the block is in equilibrium 3. find the val frietion force

Q3: The man is applying a force of 100N to the box. A mass of 300N is placed on an inclined plane as shown in the figure, if you know that us = 0.25 1- Draw the free body diagram (F.B.D) 2- Determine if the block is in equilibrium 3. find the val frietion force

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.21P: The 1200-lb homogeneous block is placed on rollers and pushed up the 10 incline at constant speed....

See similar textbooks

Related questions

Q: 3. Consider the force system in equilibrium shown in the image below. Determine the following: a.…

Q: The shaded shape is supported by Cable 1 and Cable 2 in the position shown (Drawing is NOT to…

A: It is asked to find the equilibrium condition and evaluate the tension in cables Weight per unit…

Q: 275 mm 30 30° E 0.5m FHE A) d=0.275 500 mm C D 0:5m 500 mm B) d=0.5 300 mm C) d=0.5*cos30 friction…

A: If a force F is inclined at an angle θ with the horizontal, then the component of force along the…

Q: 3. Consider the force system in equilibrium shown in the image below. Determine the following: a.…

A: To draw the free body diagram.

Q: Q5) for the equilibrium figure below if the tension in the cable AD and AC are 450 N and * 600 N…

A: The free body diagram of the joint A is as follows:

Q: Activity 1: Determine the angle 0 for equilibrium of the lever shown in the figure. Disregard the…

Q: The system in the figure is in equilibrium. A concrete block of mass 243 kg hangs from the end of…

A: (a) Tension in wire, T = 1686.73 N. (b) Horizontal reaction at hinge, Rx = 1466.6 N→. (c) Vertical…

Q: A bucket hangs off the end of a rod rigidly attached to a pulley. A spring acts as a counterbalance.…

Q: Given the assembly in equilibrium as shown in the figure, determine the following: 1. Tension in…

Q: Activity 2. In the figure, the coefficients of friction are as follows: 0.25 between blocks, 0.20 at…

Q: Consider a ladder used by a construction worker as shown below. The worker weight plus his tools is…

A: Given data (Ra)x = 50 lb (Ra)y = 200 lb (Rb)x = 50 lb W = 200 lb To determine the moment about…

Q: The mechanism shown in the figure, supports a 50 lb cylinder. Determine the angle ? for equilibrium…

A: Given data as per question Weight =50 lb Spring constant = 200 lb/ft FBD of system

Q: please is urgent The 7.8m steel I-beam has a mass of 800kg and is lifted into position by applying a…

A: Given Data : mass= 800kg h=3.6m AC=1.5 the force applied by pully =p

Q: Masses M1 and M2 are held on the frictionless inclined plane by a rigid inextensible bar of length l…

A: The free-diagram is shown in the figure below.

Q: The system in the figure is in equilibrium. If the bar is of length L, of mass M = 8Kg and the mass…

Q: Ex. 3-2 etermine the tension in cable BC and BA necessary to upport the 60 kg cylinder shown in the…

A: Given:mass of the cylinder, m=60 kg

Q: Determine the tensions T1 and T2 in the strings required to maintain equilibrium for the suspended…

A: Given data: The angle α = 29.8°. The angle β = 50.2°. The object weight is W = 38.7 N.

Q: A rectangular solid is held in the arbitrary posion by the tension T in the cable as shown in Figure…

Q: B 45° 30° 60° E D

Q: Q5\ The system shown in figure has meg =30 kg and Keg = 4.8 x 10* N/m. If it is subject to a force…

Q: 3.) A wheel of 10-in radius carries a load of 1000lb, as shown. (a.) Determine the horizontal force…

A: Given data: Weight = 1000 lbf Diameter of wheel = 20 inch

Q: -?- W A 2.5 ст 5.0 ст —

Q: F В The cable and spring system attached at the ring at A, is kept in equilibrium by the force F =…

A: Write the given data: Draw the free body diagram of the problem.

Q: -3 m end is tied to a steel cable of length 3.00 m, as shown in the figure. The other end of the…

A: The FBD of the given problem is given below θ=36.86°

Q: 3. Consider the force system in equilibrium shown in the image below. Determine the following: a.…

A: To draw the free body diagram.

Q: Q2. The system shown below is in equilibrium. Find the reactions at A (hinge support) and the force…

A: find the reaction at point A and force at B.

Q: P=20 ton W= 20 tons 10' To prevent the traveling crane as shown in the fig. from tipping to the…

A: Given data: P=20 tonW=20 ton Need to determine the value and position of Q.

Q: In figure shown, the unstretched length of spring AC is 3 m. If the block is held in the equilibrium…

A: The final length of the member AB can be determined as, The final length of the member AC can be…

Q: Determine the value of T if the force systems shown in the figure is in equilibrium

A: Given A system of forces To find Magnitude of T

Q: a). A fixed crane has a mass of 1000 kg and is used to lift a 2400 kg crate. It is 5. held in place…

A: Given:- Mass of crane (m) = 1000 kg Mass of crate (M) = 2400 kg To Find:- Draw free body diagram…

Q: e system is in static equilibrium. 1. For the forces applied on point

A: given:

Q: 10° A cable B 15° rope

Q: Example: A 3000kg crate is being unloaded from a ship as shown in the following figure. A rope BC is…

Q: D 50 kN 25 kN

A: This is a simple truss problem. In this question we calculate the reactions at the supports by…

Q: A horizontal board weighing Wb = 600 N is hinged to a vertical wall. A person weighing Wp = 400 N…

Q: Consider the bracket shown in Fig-3. If: • F1 - 10 lb @ -90° • a- 2 ft • b- 4 ft • c-1 ft then, what…

Q: Q1 -A- A man stands on the middle rung of a 250 N ladder resting on a smooth floor and against a…

Q: Determine the force in the cable OC and the elongation of the spring OA, OB necessary to support a…

A: Spring force is the reaction exerted by the spring which is required to bring the spring back to its…

Q: A 20kg mass is supported by two cables AB, AC, and a force F as shown in Fig.Q2. The tension in each…

A: Given that, Mass of the weight, m=20 kg, The coordinate of the points is, A≡0,y,8B≡5,4,0C≡-5,4,0…

Q: The boom AC in the figure rests in a ball and socket joint at A and is held in equilibrium by the…

A: Given: To find: Coordinates of D

Q: The block W has a mass, M. Weightless bar AB rests against a smooth vertical wall at B and is…

Q: The steel cable is hoisting a 2,000N weight. Assume the weight is not accelerating and the cable is…

A: A pin support will exert both horizontal and vertical components of reaction. The support B is pin…

Q: Q1/ In the equilibrium position shown in figure below, the uniform bar (AB) has a mass of (50 kg)…

Q: 2. Determine the forces P, F, and T required to keep the triangular frame ABC shown in the figure in…

A: For a truss to stay in equilibrium, there must be zero resultant force in x and y direction and must…

Q: Determine the reaction forces at the support A and the tension force T in the cable needed to…

Q: Q1/ In the equilibrium position shown in figure below, the uniform bar (AB) has a mass of (50 kg)…

A: given data:- mass of rod = 50 kg find the tension in the cable and reaction at B.

Q: The system is made up of a bar, supported by a pin at point A and by a smooth collar at point B (the…

Question

i need the answer quickly

Q3: The man is applying a force of 100N to the box.
A mass of 300N is placed on an inclined plane as shown
in the figure, if you know that us = 0.25
1- Draw the free body diagram (F.B.D)
2- Determine if the block is in equilibrium
3- find the value of the friction force
300N
FNE
alumn is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Find the tension T in the cable when the 180-N force is applied to the pedal at E. Neglect friction and the weights of the parts.
Find the smallest value of P for which the crate in the Prob. 4.34 will be in equilibrium in the position shown. (Hint: A rope can only support a tensile force.)
The woman is trying to move the crate of weight W by pulling on the rope at the angle to the horizontal. Find the smallest possible tension that would cause the crate to slide and the corresponding angle .
The homogeneous 240-lb bar is supported by a rough horizontal surface at A, a smooth vertical surface at B, and the cable BC. Draw the FBD of the bar and count the unknowns.
The 14-kN weight is suspended from a small pulley that is free to roll on the cable. The length of the cable ABC is 20 m. Determine the horizontal force P that would hold the pulley in equilibrium in the position x=5m.
The bar ABC is supported by three identical, ideal springs. Note that the springs are always vertical because the collars to which they are attached are free to slide on the horizontal rail. Find the angle at equilibrium if W = kL. Neglect the weight of the bar.
The 1200-lb homogeneous block is placed on rollers and pushed up the 10 incline at constant speed. Determine the force P and the roller reactions at A and B.
Repeat Prob. 4.152 assuming that the 400-kN force is applied at O instead of L.
The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
The uniform ladder of weight W is raised slowly by applying a vertical force P to the rope at A. Show that P is independent of the angle .
The spring attached to the homogenous bar of weight W is undeformed when =0. Determine the smallest spring stiffness k for which the =0 equilibrium position will be stable. Use W = 10 lb, a = 24 in., and b = 6 in. Assume that the spring remains horizontal, which is a valid approximation if is small.