Q3. By using the method of images, prove that the capacitance between conductor and earth, taking into account the effect of earth for 3- phase equilateral spacing (as shown in fig. below) is : 27 an D |(H,) H, Ground level In + In (H,} H, (H .} H, Where %3D H,H, H, and (r) is the radius of the conductor.

Q3. By using the method of images, prove that the capacitance between conductor and earth, taking into account the effect of earth for 3- phase equilateral spacing (as shown in fig. below) is : 27 an D |(H,) H, Ground level In + In (H,} H, (H .} H, Where %3D H,H, H, and (r) is the radius of the conductor.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle. If each equal side of this triangle is 2 m, find line-to-neutral capacitance per km. Take the diameter of each conductor as 1·24 cm. The conductors are transposed at regular intervals.
An Underground cable of length 40 Km has a conductor of diameter of 1.5 cm and a sheath of inner diameter 5 cm. If the permittivity of insulation is 3.5, Analyze the following Electrical Parameters of the UG-cables (i) the inductance per km length (ii) capacitance per km length. (iii) Natural impedance (Surge Impedance) and (iv) velocity of propagation of the travelling waves.
96 kg of ice has accumulated over 40 meters of a conductor whose 40 meters are 46 kg in a naked state. This conductor is III, where k=0.3. is in the ice zone.Since it is known that it is calculated with qb=k√d (kg/m) and the conductor is exposed to wind force at the same time with ice on it, calculate the q+bw value as kg/m.Frosted diameter D=√d2+216.46 qb mm (d bare conductor diameter, qb ice load in kg/m)Wind load qw=p x d x c x 10-3 N/m (no ice condition, different formula will be used in icy condition.)It will be taken as c=2 and p=294.3 N/m2
The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and DBC = 2·5 m. Find line-to-neutral capacitance per km if diameter of each conductor is 1·24 cm. The conductorsare transposed at regular intervals.
The geometric mean radius of the conductor in a 380 kV, 120 km long transmission line 24mm. The roughness factor of the conductor is 0,98. Geometric mean length between phases of conductors 3,2 m. Air pressure across the line 725 mmHg, temperature 18 degrees Celcius and the conductor surface temperature is 85 degrees Celsius.According to this,a) Calculate the voltage at which ionization starts and the corona voltage.b) Find the corona loss for operating voltage with Peek formula.c) Calculate the total corona loss of the line with the Peek formula for a 15% increase in operating voltage.
Three Conductors of a 3-phase line are arranged at the corners of a triangle of sides 20, 15, and 18 meters. The diameter of each line conductor is 3 cm. Calculate the Capacitance per phase per km (C1) for this arrangement. Calculate Capacitance per phase per km(C2) if the spacing between the conductors are reduced by 1/4th of given spacing. Capacitance in micro.F per Phase per Km for Arrangement 1 (C1)? Capacitance in micro.F per phase per km for Arrangement 2 (C2)
Describe the surfaces, in the spherical coordinates, defined by the following equations:a) ρ=13b) θ=2π/3c) φ=π/4
A 110 kV, three-phase, 50 Hz, 150 km long overhead line consists of three 1.8 cm diameter stranded copper conductors spaced in 2.5 m delta arrangement. Assume surface irregularity factor m = 0.89 (roughness factor), m for local corona = 0.74 and m for general corona is 0.84. Determine the following at 290° C and barometric pressure of 76 cm Hg. (i) Disruptive voltage (ii) Visual corona voltage for local corona (iii) Visual corona voltage for general corona (iv) Power loss due to corona under fair weather and in wet conditions
In a three layered, cylindrical electrode system, 100 kV is applied to the inner conductorwhile the outer conductor is grounded. Radii of cylinders in this system are: r1 =1 cm, r2 =1.5cm, r3 =3 cm, and R =5 cm. Relative dielectric constants of layers are r1 = 5, r2 = 3 and r3 =2.5 respectively;a) Calculate maximum and minimum field strengths across each layer.b) If R=5 cm and r3 =4.5 cm, for uniformly stress condition find the new values of r1 and r2and the thickness of each layer.
Q4. A Transmission Line has a span of 250 meters between two level supports. The conductor has a cross-sectional area of 1.29 cm2, weighs 1170 kg/km and has a breaking stress of 4218 kg/cm2. Calculate the sag for a safety factor of (5), allowing a wind pressure of 122 kg per square meter of projected area. What is the vertical sag?
If the ratio of the inner conductor circumference to the outer conductor circumference of a coaxial cable is 0.4993, what is the capacitance per unit length of the air-insulated coaxial line, in pF/m?
a)We have a two-wire overhead transmission line, powered by a constant voltage source of 700 V. The values for the inductance of the conductors are 2.348x10-3 H/km and the capacitance values are 6.325x10-9 F/km. Assuming an ideal (no loss) line and its length at 130 km, determine the natural impedance of the line. b) What is the transient phenomenon in a transmission line? As an example of its causes.