Q3. The following information on the pressure-temperature diagram of nitrogen: P (atm) T(K) 0.123 63.15 33.3978 126.19 1.0 77.35 Triple point Critical point Normal boiling point Density of N₂(s): 1.03g/cm-³ N₂(1): 0.808g/cm-³ Using this information, sketch a phase-equilibrium diagram of nitrogen and mark each point. Then, describe why the slope of each phase/phase equilibrium is positive or negative.

Q: 2. Calculate the pH of the following solutions: a. 0.1 M HCI b. 0.1 M NaOH c. 1 nM HCI d. 0.1 M…

A:

Q: The specific gravity of white petrolatum is 0.850. Find the weight of this substance needed to fill…

A:

Q: A single effect evaporator is fed with 10000 kg/h of weak liquor containing 15% caustic by weight…

A:

Q: 4. A Chemical Engineer was able to extract a fluid from a plant and used it as the liquid in a…

A:

Q: When methane combusts in the presence of oxygen, the following two reactions are possible. CH4 +20₂…

A: Given data: Initial number of moles of CH4 = 10 mol Number of moles of CH4 in the product stream = 2…

Q: Tanning beds use primarily UV-A radiation, the same dangerous UV radiation type strongly linked with…

A: Tanning salons use lamps that emit both UV-A and UV-B radiation and UVA penetrates deep into the…

Q: Find the heat flow rate through the composite wall as shown: The thermal conductivities are:…

A:

Q: Given that the vapor pressure of n-butane at 350 K is 9.4573 bar, find the molar volumes of (a)…

A: The critical properties of the compound are considered which are critical temperature, critical…

Q: You have three CSTRS you can place in series to carry out a liquid phase reaction at constant…

A:

Q: 5.16. In the tank in Fig. 5.24 water is under a layer of compressed air, which is at a pressure of…

A: Write the Bernoulli's equation as follows: P2ρg + z2 +v222g = P1ρg + z1 +v122g P2ρ +gz2 +v222 = P1ρ…

Q: Regarding the following reaction, A (s) + 2B (g) →→ C (1) + 3D (g) ArH(298K)=91.4kJ/mol where g, I,…

A:

Q: *9.36. Biodiesel fuel-a sustainable alternative to petroleum diesel as a transportation fuel-is…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Midday ozone levels reach about 0.4 ppm in a particular area. This means that for every…

A: Given statement is to be identified whether it is true or false.

Q: 4. A refractory material with an emissivity of 0.40 at 1500 K and 0.43 at 1420 K is at temperature…

A:

Q: Dibutyl phthalate (DBP), a plasticizer, has a potential market of 12 million lbm/yr (AICHE Student…

A: It is given that Dibutyl phthalate(DBP) is produced by the reaction of monobutyl phthalate(MBP) with…

Q: If the overall heat transfer coefficient in question 3 above is 27 W/m²-K find the heat loss per…

A: Given data are as follows: Overall heat transfer coefficient h = 27 W/m2-K Temperature of hot oil =…

Q: Example 3.9. For a system in which the following reaction occurs, CÓ +H_O » CÔ, +H. assume there are…

A: Given  Initial mole of H2O = 1 Initial mol of CO = 1 Given reaction  H2O + CO > CO2 + H2

Q: What is the volume of a plug flow reactor with an elementary gas-phase reaction A⇒ 3R and a lesired…

A:

Q: 3: A concentration C (g/L) varies with time (min) according to the equation; C = 3.00 exp(-2.00t) a)…

A: Given thatC =3.00 exp(-2.00 t )where C is concentration in g/L and t is time in hr Accordint to…

Q: A cell culture is initially composed of 100 cells. After 12 hours, the number of cells is 1.5 times…

A: Given Details: at t=0, no. of cells, Ni=100 cells at t=12 hrs , no. of cells=1.5 Ni we need to…

Q: A. if the density of an oil at 60F is about 900 g/l, what is the corresponding API? What will be the…

A: A. Given: The density of oil at 60oF is 900 g/L or kg/m3; therefore, the specific gravity of the oil…

Q: Describe how to determine the instantaneous rate of chemical change. Choose the best answer. Plot…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Exercise 1. Heating a fermentation medium. A fermentation liquid with a temperature of 30 °C is…

A: It is given that fermenting liquid is heated to 70oC under pressure. Given data are as follows:…

Q: PROBLEM 3: Batch Distillation. A 750 kmol of an isopropanol (1)/1-butanol (2) hinary mixture…

A: Given, The moles of the mixture feed to the distillation, F = 750 kmol The mole fraction of…

Q: A tube 93 mm outer diameter is insulated with a layer of silica foam 38 mm thick of conductivity…

A:

Q: 1. The heat capacity (Cp) of a fluid is given as function of temperature by the following equation:…

A:

Q: 2Zn(s) + O2(g) → 2ZnO(s) +701kJ How many heat kilojoules are needed to decompose 5.2 grams of ZnO(s)…

A: Given data: Enthalpy change for the ZnO(s) formation reaction is given.

Q: % overshoot Rice time

A:

Q: A radiant-heating system is installed in the plaster ceiling of a room 36 ft long by 18 ft wide by 9…

A: Given dimension of ceiling room is 36ft long, 18 ft wide and 9ft high. Temperature of concrete floor…

Q: (a) Invert: x(s)=1/[s(s+1)(0.5s+1)]

A:

Q: Three pounds mass of water in a piston-cylinder assembly, initially a saturated liquid at 15…

A:

Q: The figure below shows the shape of a vibrating string at t = 0. The period of the waves is 0.200 s.…

A: Given that- The figure has the shape of a vibrating string at time, t=0.  The period of the waves…

Q: QUESTION 6 Determine the average speed (unit m/s) of O2 at 250K. Please round to one decimal place.…

A:

Q: A mass of 500 g of gaseous ammonia is contained in a vessel of 30,000 cm3 volume and immersed  in a…

A:

Q: One way to synthesize ethylamine (CH₂CH₂NH₂) is from the reaction of ammonia (NH3) with chloroethane…

A: Ethylamine is synthesized from the reaction of ammonia and chlorobenzene. Fraction yield of…

Q: 1.) Soybean oil is being pumped through a uniform- diameter pipe at a steady mass flow rate. A pump…

A: It is given that soyabean oil is pumped with the help of a pipe.  At the inlet of the pipe, absolute…

Q: Bananas are ripened in an air tight and insulated room by using ethylene  gas at 63 °F. Initially…

A: Given, The temperature of the room, T = 63 °F = 290.37 K The volume of the room, V = 25 m3 The…

Q: Find all letters, answer for a and b are 39.27 W and 93.7 degrees Celcius Heat is conducted through…

A:

Q: a generic civilian Air Car - a type in this case has an assumed weight of 36287.4 kilos. It is…

A: It is given that weight of hovercar is 36287.4Kg. Hovercar is designed to lift one meter off. It is…

Q: 02: If you have C3H6 at 74 atm and 202 °C, calculate the followings using SRK and Lee/Kesler…

A: We need to calculate the values of Z, HR, and SR using SRK equation of state. Given, The pressure of…

Q: Convert 0.002 kg/ms to lbm ft s

A:

Q: What is the NCV and GCV in KJ/mol of the fuel gas?

A:

Q: Write the steady state mole balance equation for component

A:

Q: Fick's law can be expressed in terms of the following EXCEPT: a. none of the choices b. partial…

A: Fick's Law is defined as the molar flux of species A in a particular direction with respect to the…

Q: bar. Example 2.26. The concentration of SO₂ in the flue gases from a boiler was found to be 0.2…

A: Given  Concentration of SO2 at NTP in flue gas = 0.2 kg/m3 Molecular weight of SO2 = 64

Q: Outline the difference between non associate and associated gas

A: Associated gas and non-associated gas both are linked with reservoirs one is produced from crude oil…

Q: Calcium carbonate can dissociate according to the following reaction: CaCO3(s) CaO(s) + CO₂(g)…

A:

Q: Which of the following conformations of butane will be the most stable? O A gauche conformation O An…

A: The ranking of the conformational isomers is given below taking into account the energy levels from…

Q: The specific gravity of white petrolatum is 0.850. Find the weight of this substance needed to fill…

A:

Q: Determine the fugacity of liquid water at 30° C and at the saturation pressure, 10 bar, and 100 bar.

A: