Answered: Q31. If the no load voltage of a…

Q31. If the no load voltage of a certain generator is 210 V and the rated voltage is 200 V, then the voltage regulation is A. 0.025 B. 0.05 C. 0.1 D. 0.15

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.28MCQ: The total instantaneous power delivered by a three-phase generator under balanced operating...

See similar textbooks

Related questions

Q: Question 23 When calculating the voltage of an FFT peak of a sinusoidal signal, would it match the…

A: Frequency response represents how the output gain or phase responds for a single frequency over a…

Q: R-C Series Circuit. In an AC series circuit containing capacitance C and resistance R. Which of the…

A: Use basic electric circuit laws and phase diagram technique. According to kvl sum of the voltages in…

Q: Determine the no. of studs and resistance of the section for a D.C. series motor starter from data:…

Q: Consider an audio recording system where the microphone generates a continuous voltage in the range…

Q: A series RLC circuit has a hypothetical current that is described by the expression, I(t) = 6e-t sin…

Q: A core with three legs is shown in Figure. Its depth is 5 cm, and there are 100 turns on the…

A: This core can be divided up into four regions. Let R1 be the reluctance of the left-hand portion of…

Q: Q3/ Consider a satellite receiver as shown in the figure below, if the operating frequency is 4GHz…

A: The given figure is shown below: It is given that: Fin=0.69 dBFrf=1 dBFin=4.48 dBFif=7.9 dBTo=290 K

Q: Find the Thévenins equivalent circuit for the network external to the 7N capacitive reactance in the…

A: The given circuit is shown below. Find the Thevenin’s equivalent circuit across XC=7 Ω.

Q: on a practical inductor at 10 MHz give L = 8 µH and Q = 40. Find the capacitance C for parallel…

A: Given, f = 10 MHz L = 8 μH Q = 40 C = ?

Q: I still don't fully understand how to build it?

A: In order to design this circuit we need the following components 5V power supply Red LED Blue LED…

Q: B. Solve the following circuits (fill in the missing values). Remember to include your reasoning…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 1. 2. x[n]=cos [n] Plot and show that it is periodic. A continuous-time signal x( t ) is shown…

Q: Please answer it with further explanation. badly need it What are your observations in this table…

A: We know that in a Reverse biased condition diode acts as an open switch(ideally speaking of infinite…

Q: Find the equivalent resistance of the circuit in the Figure P18.9 3.00 Ω 10.0 Ω www 5,00 £2 www 4.00…

A: Given data, Circuit diagram is given as,

Q: R +1 1=0 Vi R₂ 사 + output

Q: For the POT in the figure, if Rac= 10K and Rab-44% of the POT rated value, then Rbc equals: MM.…

Q: 33Ω gv 15Ω |₁ Μ 45 Ω Μ 30 Ω Μ 12 10Ω 70 Ω Μ 50 Ω |3 6 w 22Ω

A: The given circuit diagram is shown below:

Q: A 230/230V, 3 KVA transtormer gave the following results: O.C Test 230 V, 2amp, 100 W 04 S.c.…

A: Given: Transformer of rating 230 V/ 230 V, 3KVA Open circuit test : 230 V, 2 A, 100 W Short circuit…

Q: d and e

Q: A led is required to turn on when a switch is closed. The necessary illumination is obtained when…

A: The circuit is as shown below, Given, LED forward drop, Vd=1.2V, LED current, ID=20mA, Current…

Q: The monthly reading of a paper mill's meter is as follows: Maximum demand: 32,000 kW Energy…

Q: A squirrel-cage induction motor developed 100 N-m of starting torque when 50% tap on the compensator…

Q: Determine if the following assumptions are correct and briefly support your answer on the basis of…

A: The given circuit is as shown below,

Q: VBB 2 V www +₁ RE 1.0 ΚΩ Vcc 10 V

Q: A loop of wire is bent to have straight and circular arc shaped parts as shown in the figure. A…

A: The given figure is shown below: It is given that: I=36 AR=13 cm=0.13 mμo=1.26×10-6 T.m/A

Q: A system has the frequency response 0.1 ja H(jw) = (1+10) (1 + 100) a) Sketch the Bode straight-line…

A: The frequency response of a system is given by Hjω=0.1jω1+jω101+jω100 ...1. We need to (i)…

Q: The cascaded amplifier of figure below uses a common collector first stage followed by a common…

A: The ac circuit is given as Data are given as For transistor Q1ho1=0,hi1=1kΩ,hr1=1,hf1=100,For…

Q: A 4-pole generator having wave wound armature winding has 50 slots, each slots containing 20…

A: Given a DC generator with, Total number of pole, P = 4 Wave wound, so total number of parallel path,…

Q: 1. Simplify ABC+ĀBC+ABC+ABC 2. Simplify ABCD+ABCD+BCD + ABCD

Q: A3-phase, 220 KV, 50 Hz transmission line consists of 1.2 cm radius conductors spaced 2m at The…

Q: For the self-bias JFET network a. Determine A Zi, and Zo VNL b. Sketch the two-port model with the…

A: The required parameters of the FET amplifier circuit can be calculated by using the DC and AC…

Q: 1. A 2000/200V, 20kVA transformer has 66 turns in the secondary. Calculate: (a) Primary turns (b)…

A: Given data, A transformer has V1/V2=2000/200 VS=20 kVAN2=66 turns

Q: What is the typical value of refractive index for an ethyl alcohol? a. 1 b. 1.36 c. 2.6 d. 3.4

A: The correct option along with the explanation is provided in the following section.

Q: find the equivalent resistance of the circuit whereR1=190, R2=16N, R3=9N, and R4=60 30V R1 www. R2 9…

Q: A) Find the equivalent resistance of the combination shown in the figure Req Ω

A: Given data, Circuit diagram is given as,

Q: Determine whether the following assumptions are correct, and briefly support your answer based on…

A: The given circuit is as shown below with labeled diode current directions.

Q: A coil has an inductance (L) of 50 mH and negligible resistance. Calculate its inductive reactance…

Q: Find the Total Resistance in the circuit if all the 8 resistances are equal to 36Ω and total voltage…

Q: 3) Consider the (unrealistic) active load shown below with its corresponding small signal model.…

Q: In a tansistor, I = 70 mA and I = 70.2 mA. The value of B is Select one: a. 50 b. 350 c. about 1 O…

Q: Please give 3 statement of a problem about "Blu-ray disc to improve solar power generation"

A: It is asked to give three statement of a problem about Blu-ray disc to improve solar power…

Q: A 120 Hz, four pole, three-phase induction motor runs at a no-load speed of 3535 rpm and a full load…

A: Given: A three phase induction machine has f=120 HzP=4Nrnl=3535 rpmNrfl=3415 rpm

Q: 7.2Ω THE 6V 8 Ω R₂ 12 Ω R3

Q: 1. An unbalanced wye connected load whose impedance per phase are given as Zin = 6 + j8N, Z2n = 102…

A: Given:- Z1n=6+j8ΩZ2n=10ΩZ3n=5+j10ΩVL=220 V We have to find the positive sequence component of line…

Q: A series RLC circuit has a hypothetical current that is described by the expression, I(t) = 6e-t sin…

Q: The minimum spectrum allocation required for W-CDMA is a. 5MHz b. 2MHz c. 500KHz d. 100KHz

A: The solution is provided in the following section.

Q: Advantage of using Dynamic channel assignment is

A: The solution is provided in the following section.

Q: BT1 15+ R8 15k www R1 10k www · R2 30k + V1 www BT2 10 R5 15k W R3 30k V6 www + V3 R6 20k R7 20k 11…

Q: Draw the NOR equivalent a) circuit of the expression CD b) c) Draw the NAND equivalent circuit of…

Q: Determine the output voltage for the circuit in the figure for each input voltage waveform. Also,…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

Q31. If the no load voltage of a certain generator is 210 V
and the rated voltage is 200 V, then the voltage
regulation is
A. 0.025
B. 0.05
C. 0.1
D. 0.15

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The total instantaneous power delivered by a three-phase generator under balanced operating conditions is (a) A function of time (b) A constant
A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
For the circuit shown in Figure 2.24, compute the voltage across the load terminals.
1. At no-load conditions what is the terminal voltage2. What is the terminal voltage if the generator runs at rated speed while delivering 6 kW to an electrical load
10 kW, 230 V, d.c shunt generator is operating at rated condition with 80% efficiency. Input power and the total loss are respectively
The ohmmeter registers the value of the resistances as follows: Ra= 0.02 ohms; Rf= 80 ohms; Rse=0.03 ohms. The emf induced by the generator is 510 V while the terminal voltage is 500 V. Determine the load current delivered assuming that the generator is a short shunt compound generator.
A 2500KVA, 6,600 volts, three-phase wye connected alternator has an effective resistance of 2 ohms and a reactance of 10 ohms per phase. Calculate the per cent voltage regulation at full-load for 0.866 lagging power factor a) Using I phase as a reference vector. b) Using V phase as a reference vector.
The terminal voltage of a 3-φ generator is 19053 V, line-to-line. The load draws a current of 2727 A, leading, with a phase angle of 30o. The total reactive power, Q, absorbed by the generator would be:
For single phase ac voltage controller, R=15ohm, f=50Hz and Vrms=230V and α=0,82 rad. Calculate the rms load voltage (V). In this question, take 2 digits after the comma and take pi = 3,14; enter your answer into the system in terms of the desired unit only as a number.solve the question by using the rules of power electronics
A 6.6 kV, 6 MVA, Y-connected, 3φ alternator has an effective ac resistance of 0.436Ω between terminals. The field current of 103A produces an open circuit emf of 6600V between terminals. The field current required to produce rated full-load current at short-circuit condition is 82A. What is the synchronous impedance per phase?
Usually the generator with the ___________ cost of generation will be loaded first. a. costly in omr b. Low cost diesel c. Cheapest d. moderate
A 174000W substation delivers 76000 W for 7 hours and it shut down for the rest of the day. Every 52 day of the year the station is shut down for maintenance. Calculate its percentage annual load factor Percentage Annual Load factor=_______________