Answered: q4/ choose the correct answer A…

Engineering

Electrical Engineering

q4/ choose the correct answer A duplicate bus bar system is used to ensure continuity of supply. Select one: True

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter5: Components, Symbols, And Circuitry Of Air-conditioning Wiring Diagrams

Section: Chapter Questions

Problem 21RQ: True or False: The schematic diagram tells service technicians how to wire a system.

See similar textbooks

Related questions

Q: What are the factors that determine which network system to install in a region? Also, what are the…

A: Factors that determine which network system to install in a region : 1.Consider Usage Requirements :…

Q: Can I use the 66-block in telephone wire distribution to its outlets? How is it distributed?

A: According to the question, we need to explain the 66-block in telephone wire distribution.

Q: . Identify and explain the safety procedures and precautions that should be followed for fire…

A: There is always a danger when installing some form of wire or wiring system. If the wires are not…

Q: The grounded circuit (system) conductor is generally not permitted to be used to ground equipment on…

A: Given, The grounded circuit (system) conductor is generally not permitted to be used to ground…

Q: What is the load for 100 15A/20A, 125v duplex receptacles in a non-dwelling occupancy after applying…

A: NEC Table 220.44 gives demand factor for Non Dwelling receptacle.

Q: 1. Circuit breakers should be included in the impedance diagram. (True/False)

A: SINGAL LINE DIAGRAM OF A POWER SYSTEM: A single line diagram is the representation of a power system…

Q: Bus bar system which ensures continuity of supply during breakdown is... single bus bar single bus…

A: large stations, it is important that breakdowns and mainte-nance should interfere as little as…

Q: 7. What is the object of equipment grounding? Briefl y describe the functions of substation…

A: The object of equipment grounding: To reduce as much as possible the emergence of any voltages in…

Q: Explain the following terms in the distribution system 1) maximum demand, 2) coincident demand, 3)…

Q: Which among these statements are false or incorrect? A. In the Duplicate Busbar System, continuity…

A: Statement 1 : n the Duplicate Busbar System, continuity of service is possible even if the Main…

Q: 9. Which type of cable would you use to connect multiple buildings in an industrial facility? A.…

A: Four options are given. We need to choose the correct option. It is asked that which type of cable…

Q: QUESTION 5 a) What is the difference between neutral and earth? b) Differentiate between…

A: In a three phase system, there are two ways to connect a three phase load. Star/Wye Connection.…

Q: Which of the following must be notified prior to equipment shutdown for repair? a. Director of…

A: In this question we will write Which must be notified prior to equipment shutdown for repair..

Q: (a) Name different parts of a distribution system? Give the function of each part.

A: Since both the questions are different so we are supposed to answer 1st one.

Q: - The figure below shows the structure of which busbar? If CBF has occurred, please explain how many…

Q: (a) Describe how TLBs are used to increase paging efficiency.

A: TLB contain entries page table have been most recently used. The processor examines , the frame…

Q: Basically, ______receptacles are required to be installed if an equipment grounding conductor is…

A: Article 406 of NEC covers the installation of receptacles of both grounded type and non-grounded…

Q: Define line of support

A: The line support in terms of electrical energy is defined below: - The various kinds of structure…

Q: Identify and describe the step-by-step process used to install cable in the NCT Colledge buildings?…

A: According to the question we need to Identify and Identify and describe the step-by-step process…

Q: In your own words and from your own understanding, avoid plagiarism or copying from the Course…

Q: 4. Why are the outer metal parts of electrical appliances grounded?

Q: Differentiate the Double Breaker Bus System vs. Double Bus System. Which do you think is more…

A: Double Breaker Bus System : A double breaker bus system consist of two breaker and two buses for…

Q: External effects causing short circuit include insulation failure due to lightning surges,…

A: The above statement is absolutely correct.

Q: Deviations in quality of service include power irregularities. Which irregularity occurs when…

A: This problem is from power system. The solution is given below.

Q: Please provide a background study of maintenance and repair and argument in optical fiber cable…

A: Damage to optical fiber cable accidentally, hamper as we will see while digging within the ground…

Q: Connections from headers to cabinets and other enclosures, in cellular concrete floor raceways,…

A: To explain the means of connection made from header to cabinets and other enclosures, in cellular…

Q: The bus voltages of the network

Q: what is the receptacle load (after demand factors) for an office building with 250 receptacle…

A: Receptacle loads are described as equipment loads that are generally served by electrical…

Q: list the material required for overhead service connection

A: Various Types of Electrical service connections - Overhead Underground Majorly overhead is…

Q: explain span length for ovehead service line

A: Span Length:- The span length is the distance between the two neighboring poles. It is often…

Q: Draw a single line diagram showing a typical distribution system.

A: In a power system, there are generation, transmission and distribution with utilization of…

Q: Draw clearly, neatly, and properly the Circuit Schematic Diagram for a SINGLE BUSBAR SYSTEM with BUS…

A: Draw clearly, neatly, and properly the Circuit Schematic Diagram for a SINGLE BUSBAR SYSTEM with BUS…

Q: With a neat sketch, explain the working of Floating gas holder type biogas plant. List any two…

A: Diagram of floating Gas holder type Biogas plant In a floating gas holder type bio gas plant, we…

Q: 1-Draw the structure of single bus bar system

A: In this question we will draw structure of single bus bar system.... Note:- as per our guidelines, I…

Q: NO. A. Discuss the requirement of an efficient distribution system, describe the

A: Distribution system: The distribution system plays the main role in the calculation of consumer…

Q: What is the total number of systems?

Q: Briefly discuss the loaded and non-loaded telephone cables

A: Loading is the process to increase inductance of line by adding lumped inductors atpredefined…

Q: Chapter 6 of the NEC provides rules that address special equipment such as elevators, cranes, and…

A: The NEC which stands for National Electrical- Code is a set of standards for electrical design,…

Q: List the equipment in detail with rating for substation and swictchgear installation.

A: It is asked to list out the equipment required for substation and switchgear installation with the…

Q: It is not uncommon for electrical designers to require an equipment grounding conductor to be…

A: True, Because for each and every equipment there is different grounding required according to the…

Q: You have determined that a 4700-ohm, 1/2-watt resistor on an electronic circuit board is defective.…

A: Resistor=4700 ohm ,Power=0.5 W Current in the circuit; P=I2R0.5=I2×4700I=0.54700I=10.314 A

Q: A three bus system has the following bus power and voltage specifications:

Q: INFE242 ELECTRONICS PLEASE MAKE SURE THE ANSWER IS CORRECT i put this course 3 times and all the…

A: Vs = Vi Vd > 0 diode will turn on Vd <0 diode wheel turn off . Here we have two diodes…

Q: 7- The power system operation can be considered as.. 8- Bus-bar current limiting reactors added…

A: 7. Power systems operation can be considered as close loop system. Because generation depends on the…

Q: In food and beverage industries, the ON OFF system is implemented. Select one: True False

A: Here it is given that the On Off system is implemented in food and beverage industries. Find the…

Q: Are double locknuts an acceptable bonding method for Class 1, Division 1 Hazardous locations? If…

A: Double locknuts are not totally acceptable bonding method for the class 1, division 1 hazardous…

Q: MC encased in a concrete slab, on the first floor of an office building, is considered a _____…

Q: When expansion fittings are installed in a run of metallic raceway, the electrical continuity and…

A: Bonding conductor or jumper is a reliable conductor that ensures the required electrical…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

q4/

choose the correct answer

A duplicate bus bar system is used to ensure continuity of supply.

Select one:

True

False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Explain the full adder circuit in essay form below Note: Do not send solution, paragraph form only
Welcome, Fatima Nasser This bot specializes in [ www.bartleby.com ] ======================= [ @Bartleby_vip ] For More Info Contact [ @E_oil ]engineering computer
The following problems refer to grounding requirements. Give the source of yourresponses.1. What is the proper size copper grounding electrode conductor for a 100-ampere service that consists of 3/0 AWG ungrounded conductors?
Briefly explain TNC-S earthing scheme as applied to earthing system design. (Hint: Support your answer with a well labelled diagram).
Draw with explain the single line diagram of a power system with all protective elements.
Which one of the following is the definition of slurry? a. Water only b. Animal waste (Dung) only c. The mixer of Water and Bio gas d. The mixer of Water and Animal dung
How is the load determined for outlets supplying specific appliances? See NEC 220.14. __________________________________________
In a single-family dwelling, how is overcurrent protection for branch circuits required to be provided? See NEC 210.20. __________
posting so many many times dont dont post copied or existing one sure strict report to quality teamm dont answer dont dont waste my question very very strictly saying!
Can anyone help? Use Karnaugh Map for this one
Question R give definition of the following: a. Conventional system b. Fixed-radix positional system c. Mix-radix positional system Full explain this question and text typing work only We should answer our question within 2 hours takes more time then we will reduce Rating Dont ignore this line.
Step by step and easy to understand thanks.