Q4- For the apparatus shown in the Figure below, a) Determine the pressure, elevation, and total head at points A, B and C. b) If the coefficient of permeability for the soil is estimated to be k = 0.05 cm/s, what is the average velocity of flow through the soil? Da=25° soil Datum 35 cm 30 cm 25 cm 30cm

Q4- For the apparatus shown in the Figure below, a) Determine the pressure, elevation, and total head at points A, B and C. b) If the coefficient of permeability for the soil is estimated to be k = 0.05 cm/s, what is the average velocity of flow through the soil? Da=25° soil Datum 35 cm 30 cm 25 cm 30cm

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter8: Seepage

Section: Chapter Questions

Problem 8.12P

See similar textbooks

Similar questions

Refer to Figure 7.24. The following data were collected during the field permeability measurement of a confined aquifer using a pumping test. Determine the hydraulic conductivity of the permeable layer. Use Eq. (7.49). Thickness of the aquifer, H = 4.5 m Piezometric level and radial distance of the first observation well: h1 = 2.9 m; r1 = 17.8 m Piezometric level and radial distance of the second observation well: h2 = 1.8 m; r2 = 8.1 m Rate of discharge from pumping, q = 0.5 m3/min
The figure below represents a system with flow in the horizontal direction. Find the value of each pressure charge, level charge, and total charge in A, B, C, D, E, F, G, plus the real and approximate velocity of water flow plotting all of the above, given that soil porosity = 0.33 and transmittance coefficient = 0.50 cm/sec
The section of a concrete gravity dam with its flow net diagram is shown in Pigure 10.38. The coefficient of permeability of the soil (anistropic) in the vertical and horizontal directions are 0.25 m/day and 0.58 m/day, respectively. The length of dam perpendicular to the paper is 120 m. 1. Determine the number of pressure drops 2. Determine the seepage loss 3. Determine the total amount of water percolated in one year.
The SQUARE base permeameter (seen from above), has three soil layers arranged vertically as shown in the image. L is: 70cm, the difference of head h is: 105 cm. The coefficient of permeability of soil 1 K1 is 0.065 cm/sec, soil 2 K2 is 0.0030 cm/sec and soil 3 K3 is the 0.0095 Calculate the amount of water collected in a time of 10 minutes.
A constant-head permeability test is performed where the hydraulic gradient is 0.75. The crosssectional area of the sample is 0.25 ft2. The quantity of water flowing through the sample is measured to be 0.004 ft3/minute. (a) What is the coefficient of permeability in feet per minute? (b) What is the coefficient of permeability in millimeters per second?
A falling head hydraulic conductivity test is performed on a sample of soil. The standpipe. having a diameter 0.35 cm is observed and it takes 80 seconds for the water to drop by 70 cm from an initial hydraulic head of 90 cm. The sample has a length of 22 cm, and a diameter of 5 cm. Compute the rate of flow of water in the soil (in cm³/s). Answer in 3 decimals Pls answer asap
Figure below shows layers of soil in a tube that is 100mm x 100mm incross section. Water is supplied at a constant head difference of 400 mm across thesample. The hydraulic conductivities of the soils in the direction of flow through them areas follows. Soil k (cm/sec) Porosity, n (%) A 1x10-2 25 B 3x10-3 32 C 4.9x10-4 22 a. Calculate the equivalent k in cm/sec.b. Calculate the rate of water supply in cm^3/hrc. Calculate the seepage velocity through soil C in m/sec.
For a falling-head permeability test, the following values are given: Length of specimen = 200 mm Area of soil specimen = 1000 mm^2 Area of standpipe = 40 mm^2 Head difference at time t = 0 = 500 mm Head difference at timt t = 3 minutes = 300 mm Determine the hydraulic conductivity of the soil in ×10−4cmsec Please answer this asap. For upvote. Thank you very much
Sketch the figure and determine coefficient of permeability (k) in mm/min using constant head permeability, given the following data, Water flows horizontally The height of the reservoir supply source is 2 m above the elevation of the outlet. The soil sample length in the direction of water flow is 200 mm. The cross-sectional area of the soil sample is 1,950 mm2. The measured volume of flow for the steadystate condition is 500 ml in a 10-minute time period.
For a falling head laboratory test, the following are the given values:• Length of soil specimen = 480.0 mm• Initial head = 700.00 mm• Final head = 395.00 mm• Duration of test = 5.5 mins• Area of standpipe = 0.97 sq.cm• Area of specimen = 18.0 sq.cmA. Compute for the hydraulic conductivity of the soil in cm/sec.B. Determine the head difference at t = 3.50 mins.
A falling head permeability test started at t = 5 seconds with a head difference of 40 cm while the head difference at t = 205 seconds is 50 cm. Find the hydraulic conductivity given that the area of the standpipe is 0.004 cm, the area of the soil specimen is 0.1 cm2, and the soil specimen’s length is 20 cm
Solve for the ratio of equivalent hydraulic conductivity with the following given: h1 = 2 m h2 = 2.5 m h3 = 1.8 m h4 = 0.9 m k1 = 1.5E-3 cm/sec k2 = 2.2E-4 cm/sec k3 = 1.6E-4 cm/sec k4 = 4.0E-4 cm/sec What is the equivalent coefficient of permeability if the water flows perpendicular to the layer of soil (KeqV) in cm/sec?