Q4: Given a sequence x[n] where x[n] = [1 2 3 4 4 3 2 1]. a- Find DFT using Radix-2 DIT-FFT flow graph. b- Plot the magnitude and phase spectra. c- Determine the speed improvement factor.
Q: Transmission degradation is caused by attenuation, distortion, and noise. What would be the remedy,…
A:
Q: Q4: Consider the system given by -E主-8- 1 -11 y = [20 9 1| Is the system completely state…
A:
Q: 1. What type of transmissions represented the first type of digital communications? A. Digital…
A: Only one individual question is to be answered. 1. This question is from telecommunications. Digital…
Q: QI Define lcno and leao. How are they different? How are they related? Are they typically close in…
A:
Q: Sketch the Z-plane pole- Zero plot for this filter.
A: conside the given question;
Q: 1) Upper cutoff frequency? 2) Lower cutoff frequency? 3) AV(mid)? 4) AV(300K)? 5) AV(200)? 6)…
A:
Q: Explain the advantages of non-linear quantisation (or equivalently companding) over linear…
A: According to the question, we need to discuss the advantage of nonlinear quantization and A law…
Q: i) Present your point view on mutual information, how channel capacity is assumed, and declare the…
A: Dear student as per our guidelines we are supposed to solve only one question in which it should…
Q: What is maximum power transfer theorem?
A: Whenever the resistive load is connected in the circuit then it will receive the maximum power if…
Q: Consider a zero-mean WSS Gaussian random process X (?) with the autocorrelation function given…
A: We have given that , Rx(τ)=8sinc2(5000τ)Power Px=E(x2)=Rx(τ) when τ=0 Px=Rx(0) and Rx(0)=8hence…
Q: Implement the following function using 8 to 1 line Multiplexer. F(A,B,C,D) = m(0,4,5,8,10,12,14,15)
A: Implematation of funtion using 8×1 mux as- first draw k map then circle the given no on k map if…
Q: Explain why NRZ coding is not attractive for signal transmission applications?! Short answer please
A: NRZ coding : NRZ coding is known as non return to zero encoding this coding is used where speed of…
Q: Using a ZN stability margin approach, provide the "proportional only" controller gain for the…
A: We need to find the proportional controller gain for the discrete-time process g(z)=z3z-1.
Q: What is the mixer in a superheterodyne receiver?
A: Superheterodyne receiver It is used in radio broadcast reception and two-way radio communication…
Q: In series clippers, when clipping of signal occurs? In parallel clippers, when clipping of signal…
A: “Since you have asked multiple question, we will solve the first question for you. If you want any…
Q: 8- Design equation F(A,B,C,D) ={(1,3,4,11,12,13,14,15) using a suitable Multiplexer?
A: Note : In the question you didn't mention the type of multiplexer. So I am going to design the given…
Q: Using Verilog continuous assignment statements or VHDL signal assignment statements, write a…
A: The given logic is:
Q: Question 3: Enumerate solutions to decrease propagation delay. Question 4: What are the effects of…
A: 3) Following are the solutions to decrease propagation delay- 1. Minimize no. of transistors through…
Q: A system is having the following transfer function. Y(Z) z + 7z + 10 X(Z) 23 + 3z? – 10z – 24
A: Given: A system is having the following transfer function: YzXz=z2+7z+10z3+3z2-10z-24 To find: a)…
Q: We need to send 210,000 bits per second over a noiseless channel using 128- QAM. Determine the…
A: In this question we will find bandwidth for transmitting signals through noiseless channel....
Q: For the bridge circuits shown in the figure bellow, derive expressions to calculate the unknown…
A:
Q: The Nyquist plot of a system is shown in figure below. The order of system is: Im Re O=0 00 = M
A: In this question, We need to choose order of the system? Nyquist system is given.
Q: for the FM system, the carrier Signal fraquency is (25 MH2) and the information signal froquencyis(…
A:
Q: 42/ what s m eont by Palse Moduletim? why we need PM? suppose you have sct) amessaye signal, give an…
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: (b) Using Routh-Hurwitz criterion determine the relation between K and T so that unity feedback…
A:
Q: The A.M transmission is used for long distance and video communication instead of F.M. Why? Also…
A: We need to explain why A.M transmission is used for long distance and video communication instead of…
Q: 0.2 0.19 0.18 0.17 0.16 0.15 0.14 0.13 0.12 400 500 600 700 800 900 Frequency (MHz) A 700 MHZ tv…
A: Attenuation is the general term which refer to reduction in a strength of the signal . Attenuation…
Q: By using Ziegler-Nichols Method, design P, PI and PID controllers for the given system below…
A:
Q: 3. Are linearity and shift invariance independent of each other in a Linear and Shift Invariant…
A: LSI = LINEAR SHIFT INVARIANT( LSI) OR LINEAR TIME-INVARIANT. (LSI) To satisfy a system as a LTI…
Q: Question: There are different empirical loss prediction models you have studied. Explain…
A: Empirical Model: Experimental evidence is the only source of support for empirical models. The…
Q: 1. The closed-loop transfer function of a control system has a denominator polynomial equals to s +…
A:
Q: function with probability p. The total system will be able to operate effectively if at least one-…
A: Here it is asked to find the value of p with the informations given. Here event A denotes that 3…
Q: What are the outputs of a mixer with inputs of 162 and 189 MHz?
A: Let input of the mixer fs = 162 MHz input of the mixer fvco = 189 MHz mixer can give sum or…
Q: eight-level encoding scheme is used in a 30-kHz-bandwidth system, what is the channel capacity in…
A:
Q: What do you mean by over modulation?
A:
Q: In layman's term, explain intermediate frequency and its importance. What is the use of intermediate…
A: An intermediate frequency (IF) is a frequency to which a carrier is shifted as an intermediate step…
Q: 1. The load flow data for the sample power system are given below. The voltage magnitude at bus 2 is…
A:
Q: Q3: The bit stream 10110100 , draw the sequence using following digital data formats : a)Unipolar RZ…
A: 10110100 will be represented as follows in the respected digital data formats
Q: Using Routh-Hurwitz criterion, determine the relationship between KE edback control system whose…
A:
Q: 3. Category 5 cable, commonly referred to as CAT-5, is a twisted pair cable for computer networks.…
A:
Q: The frequency deviation is the amount of change in carrier frequency produced by the modulating…
A: Frequency deviation concept is used delivering or casting(broadcasting) of FM. Fm means the FM…
Q: Explain load flow analysis of Radial distribution system by artificial neural networks with neat…
A: The load flow of distribution system is different from that of transmission system because it is…
Q: Q3) For the following 8-bit Transmitter-Receiver system; write a VHDL code to check received vector…
A: Q3 VHDL Transmitter code: library ieee;use ieee.std_logic_1164.all;entity UART_Transmitter…
Q: Use Routh-Hurwitz method, characterize the system defined by the polynomial equation: stable…
A:
Q: Explain the key parameters or information that are obtained from a load flow study.
A: Load flow analysis - The load-flow study is a mathematical examination of the flow of electric…
Q: type of a connector is semi precision and provides excellent performance from direct current to 18…
A: There are many types of connectors used for coaxial cables. Sub Miniature A connectors are also…
Q: The 8380198 Draw the Nyquist diagram of the system and determine the- function of a system is given…
A: Ans. Given below
Q: 4. Explain Maximum power transfer theorem in brief.
A: Proof maximum power transfer theorem: The circuit is given as:
Q: 0.2 0.19 0. 18 0.17 0. 16 0.15 0.14 0.13 0.12 400 500 600 700 800 900 Frequency (MHz) A 700 MHZ tv…
A: The solution is given below
Plz plz I need the answer of
Step by step
Solved in 3 steps with 3 images
- STABLE OR UNSTABLE ? Use Routh-Hurwitz method, characterize the system defined by the polynomial equation:Use Routh-Hurwitz method, characterize the system defined by the polynomial equation: stable unstableDescribe the role of impedance matching in ensuring efficient signal transmission over guided media.
- 2. Mention the advantages of indirect method of FM generation? 4.Compare an optimal UC problem with an economical load problem.The A.M transmission is used for long distance and video communication instead of F.M. Why? Also analyze the effect of noise and environmental conditions (i.e.moister, temperature and geographical terrain) on both modulation schemes and elaborate which modulation schemes will be more effect by noise and environmental conditions? (your answer should be technical and to the point). Subject is Communication system
- 1. I want a detailed solution with explanation, please 2. Please mention the type DSD-LC OR DSD-SC and why?a) Sketch the root locusb) Using Routh-Hurwitz, determine the maximum gain Kp before system goesunstablei) Present your point view on mutual information, how channel capacity isassumed, and declare the Shannon capacity formula for the additive white Gaussian noise channel.iii) Discuss “additive white Gaussian noise” in the conventional way andconvince your audience that Gaussian noise always white.
- From the given electrical system get the transfer function ??(?)/?(?). Write the answer in a single fraction and make sure to arrange the degree of variables in descending order.Which of the following cannot be determined with the help of load flow analysis?a) frequency of busbar voltagesb) active and reactive forcesc) phase angle of busbar voltagesd) loss of strengthe) amplitude of busbar voltages1. What type of transmissions represented the first type of digital communications?A. Digital signal processing B. Amplitude-shift keying C. Morse codeD. On-off keying 2. Each form of digital modulation has implications in terms of spectral efficiency, power distribution, and _________.A. amplitudeB. bandwidth C. performanceD. distortion3. Which of the following is a key characteristic of orthogonal frequency-division multiplexing?A. Amplitude modulationB. Noise performanceC. Digital modulationD. Spectral efficiency4. When a carrier is conveying intelligence by simply turning it on or off according to a prearranged code, this type of transmission is called ____________.A. continuous waveB. sine waveC. square waveD. cosine wave5. Why must modulated signals be demodulated?A. To recover the original intelligenceB. To improve the spectral efficiency of digital transmissionsC. To enable implementation of advanced featuresD. To produce one or more significant sideband pairs 6. What is one…