Answered: Q4) The circuit in Fig.4 have( D1) and…

Q4) The circuit in Fig.4 have( D1) and (D4) is (Si) and (D2) and (D3) is (Ge) and maximum (AC supply) is 10V find: 1. Draw the Vout. 2. Vrms. 3. Vav. AC Supply V M

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter20: Electric Current, Resistance, And Ohm's Law

Section: Chapter Questions

Problem 73PE: Certain heavy industrial equipment uses AC power that has a peak voltage of 679 V. What is the rms...

See similar textbooks

Related questions

Q: 6. You have a 400-2 resistor, a 0.300-H inductor, and a 8.00-µF capacitor. Suppose you take the…

A: The impedance of a series L-C-R circuit is Z=R2+XL-XC2 R is resistance Inductive Reactance, XL=ωL…

Q: 2. The figure on the right shows an RL circuit which can be used to generate time-varying high…

A: RL is a series resistor and inductor circuit. When a dc voltage is applied to a circuit on its own,…

Q: 25. A resistor and capacitor are connected in series acrss an ac generator. The emf of the generator…

A: Since, we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Chapter 31, Problem 065 Your answer is partially correct. Try again. n ac generator provides emf to…

Q: Determine, Z, of the circuit. Determine the rms current in the circuit. What is the voltage drop…

Q: Radios often utilize a variable capacitor in series with an inductor to tune the circuit to a…

A: Radios often utilize a variable capacitor in series with an inductor to tune the circuit to a…

Q: 8. The impedance of the given AC circuit is.. а. Хс b. R с. X d. R?

A: Impedence is given by Z = R2+(XL-XC)2

Q: High-frequency noise in AC power can damage computers. Does the plug-in unit designed to prevent…

A: A high frequency noise in AC power can damage computers.

Q: Problem 6: In the simple AC circuit shown on the right, C = 0.045 F, L = 1.2 H, R = 36 2, AV =…

Q: For the series circuit of Fig. 20.49: a. Find the value of Xc for resonance. b. Determine the total…

A: Given E = 50 mV R = 10 ohm XL = 30 ohm XC = ???

Q: Neon signs require 12-kV for their operation. A transformer is to be used to change the voltage from…

A: Given data The primary winding voltage is Vp = 220 V. The secondary winding voltage is Vs = 12 kV.…

Q: A Step-Down Transformer. A transformer connected to a 120-V (rms) ac line is to supply 12.0 V (rms)…

Q: Problem 7: A series AC circuit contains a voltage source, a resistor, a capacitor, and an inductor.…

A: The given ac circuit has a resistor, a capacitor and an inductor connected in series. The maximum…

Q: Radios use resonance in order to tune-in to a particular station. A physics student builds a simple…

A: Given that the value of capacitance and resistor and frequency and RMS value of current then we have…

Q: Problem 8: AR = 184-Q resistor, C = 170-uF capacitor, and L = 2.2-H inductor are connected in series…

A: Given:

Q: Problem 6: In the simple AC circuit shown on the right, C = 0.045 F, L = 1.2 H, R = 36 Q, AV =…

A: As it is asked to solve the sub-parts (g, h, and i), we will solve the same for you. The given…

Q: 4. Consider a parallel LRC circuit driven by an AC source. a) What is the impedance of this circuit?…

A: In this question we have to answer the given questions about the parallel LCR circuit given in the…

Q: Problem 6: In the simple AC circuit shown on the right, C = 0.045 F, L = 1.2 H, R = 36 2, AV =…

Q: 4) For a parallel RLC circuit a) Find the impedance b) And find the phase angle between voltage and…

A: In parallel RLC circuit, supply voltage is common to all three components. And supply current is…

Q: Question 2 ( - - A circuit has in series a resistor R Q, an inductor of L H, and a capacitor of C…

A: We have a series LCR circuit with initial current I(0)=0 A and initial charge Q(0)=Qo C. We need to…

Q: Electrosurgical units (ESUS) supply high-frequency electricity from resonant RLC circuits to cut,…

Q: When a wire is connected between the two ends of a solenoid, the resulting circuit can oscillate…

Q: Q2) Determine the , , (rms), of a half-wave rectifier circuit connected to 1 KO. 1:1 230 V ip 1 K

Q: 3. A series circuit consists of an ac source of adjustable frequency, a 50-Ω resistor, a 0.50-H…

A: The answer is given below

Q: uncharged and are ideal. Which branch will have the most current after “a long time”? Expla

Q: 2. Now consider an instant when the current is momentarily zero. Describe the magnitude of the…

A: Explanation and solution shown in the picture below ?

Q: A student builds a series circuit using a 1.20 mH inductor and an initially uncharged 1.20 µF…

A: Given: The inductance is 1.20 mH. The capacitor is 1.20 μC. The current is 19.0t.

Q: 3) Draw to scale a phasor diagram showing Z, XL, Xc, and o for an AC series circuit for which R =…

A: Given The resistance of the AC circuit is R = 300 Ω. The capacitance of the AC circuit is C = 11 μF…

Q: 1. A pure capacitor is connected to an AC power supply. In this circuit, the current 2. In a RLC…

Q: Problem 8: AR= 184-Q resistor, C = 170-µF capacitor, and L = 2.2-H inductor are connected in series…

A: Given : Resistor, R = 184 Ω Capacitance, 170 x 10-6 F Inductor, L = 2.2 H Amplitude of AC voltage…

Q: 3. An AC circuit draw / 50 mA (ms) current from fixed voltage source. V-20 Vrms Calculate the…

Q: Problem 9: A neon sign requires 13 kV for its operation. A transformer is used to raise the voltage…

A: (a) The input rms AC voltage is 220 V and the required output rms AC voltage is 13 kV. The ratio of…

Q: Q1:- A 15 kVA, 440/230 V, 50 Hz, transformer gave the following test results: Open Circuit (LV side)…

A: Solution of the above question given in below step with proper explaination.

Q: Q4:- For the AC circuit v(t) 20 Sin (314 t). Find:- a-Signal frequeney (n? b- v(t) at t-5000us? c-…

A: Given that V(t)=20sin(314t)Comparing it with standard equationV(t)=Asin(ωt) A=20ω=314 (a) Signal…

Q: Problem 7: A series AC circuit contains a voltage source, a resistor, a capacitor, and an inductor.…

A: Part (a)Capacitive reactance is given by,

Q: 11. A series RLC circuit consists of 100-N resistor, a 10.0-µF capacitor, and a 0.3 H inductor. The…

A: GivenR=100 ΩC=10 μF=10×10-6 FL=0.35 HVrms=120 Vf=60 Hz

Q: AC An AC current passes through a capacitor as shown. How does the phase of the voltage across the…

A: Let the voltage produced by the AC source is given by : V(t) = Vo Sin(ωt) Where Vo is the maximum…

Q: The phasor diagram pictured represents the voltages in a series RLC circuit powered by an ac source.…

A: Given that: VL,max=43 VVC,max=9 VVR,max=34 V

Q: Electrosurgical units (ESUS) supply high-frequency electricity from resonant RLC circuits to cut,…

A: (a) Calculate the resonant frequency. f = (1/2*π)(1/sqrt(LC)) = (1/2*π)(1/sqrt(1.75*10-6*44*10-9))…

Q: 2) A series RLC cireuit consists of a 150-2 resistor, a 21-µF capacitor and a 460-mH inductor,…

A: Given: Resistance (R) = 150 Ω Capacitance (C) = 21 µF. Inductance (L) = 460 mH. Supply voltage (V) =…

Q: Problem 6: In the simple AC circuit shown on the right, C = 0.045 F, L = 1.2 H, R = 36 2, AV =…

Q: 2. The plot below shows the voltage (solid line) and current (dashed line) in a device that is…

A: Given, Vmax = 30 mV , Imax = 90 mA a) from graph, T = 0.020 s n = 1/T = 50 ω =…

Question

I need the answer as soon as possible

Q4) The circuit in Fig.4 have( D1) and (D4) is (Si) and (D2) and (D3) is (Ge) and
maximum (AC supply) is 10V find:
1. Draw the Vout. 2. Vrms. 3. Vav.
AC Supply
M.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Construct Your Own Problem Consider the use of an inductor in series with a computer operating on 60 Hz electricity. Construct a problem in which you calculate the relative reduction in voltage of incoming high frequency noise compared to 60 Hz voltage. Among the things to consider are the acceptable series reactance of the inductor for 60 Hz power and the likely frequencies of noise coming through the power lines.
In addition to phasor diagrams showing voltages such as in Figure 32.15, we can draw phasor diagrams with resistance and reactances. The resultant of adding the phasors is the impedance. Draw to scale a phasor diagram showing Z, XL, XC, and for an AC series circuit for which R = 300 , C = 11.0 F, L = 0.200 H, and f = 500/ Hz.
An RLC circuit consists of a 150- resistor, a 21.0-F capacitor, and a 466-mH inductor connected in series with a 120-V, 60.0-Hz power supply. (a) What is the phase angle between the current and the applied voltage? (b) Which reaches its maximum earlier, the current or the voltage?
Neon signs require 12-kV for their operation. A transformer is to be used to change the voltage from 220-V (rms) ac to 12-kV (rms) ac. What must the ratio be of turns in the secondary winding to the turns in the primary winding? (b) What is the maximum rms current the neon lamps can draw if the fuse in the primary winding goes off at 0.5 A? (C) How much power is used by the neon sign when it is drawing the maximum current allowed by the fuse in the primary winding?
The capacitor in Figure 23.55(a) is designed to filter low—frequency signals, impeding their transmission between circuits. (a) What capacitance is needed to produce a 100 k reactance at a frequency of 120 Hz? (b) What would its reactance be at 1.00 MHz? (c) Discuss the implications of your answers to (a) and (b).
High-frequency noise in AC power can damage computers. Does the plug-in unit designed to prevent this damage use a large inductance or a large capacitance (in series with the computer) to filter out such high frequencies? Explain.
The capacitor in Figure 23.55(b) will filler high—frequency signals by shorting them to earth/ground. (a) What capacitance is needed to produce a reactance of 10-0 m for a 5.00 kHz signal? (b) What would its reactance be at 3.00 Hz? (c) Discuss the implications of your answers to (a) and (b).
A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
When a wire is connected between the two ends of a solenoid, the resulting circuit can oscillate like an RLC circuit. Describe what causes the capacitance in this circuit.
Certain heavy industrial equipment uses AC power that has a peak voltage of 679 V. What is the rms voltage?
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
(a) Use the exact exponential treatment to find how much time is required to bring the current through an 80.0 mH inductor in series with a 15.0 (resistor to 99.0% of its final value, starting from zero. (b) Compare your answer to the approximate treatment using integral numbers of (c) Discuss how significant the difference is.