Q4/ The decimal 793.251)= ( number O 1431.204 O 1431.200 O No one of them 1341.200 number ( O 1341.201 ) in octal

Q: Simply the function below using K-map. FIABCDE ABCDE+ ABCDE+ABCDE+ABCDE+ABCDE+ABCDE+ABCDE +…

A: Given,The function is,FABCDE=A¯BC¯D¯E¯ + ABC¯D¯E¯+A¯BC¯DE+A¯BC¯D¯E¯ + A¯B¯CDE+A¯BCD¯E+…

Q: Using only 2-input totem-pole gates and as few inverters as possible, complete the logic to allow…

A: Given data: Inputs, Two LEFT systems, R1 & R2' One temperature sensor, H Output, Two RIGHT…

Q: An amplifier operating from a +15V power supply provides a 12V peak-to-peak sine- wave signal to a…

A:

Q: 3.4 Determine U, in the circuit of Fig. 3.11. 2 Α 30 V ww 8 Ω – FIGURE 3.11 Μ 2 Ω 10 Ω ΣΩ 2 Ω + υχ…

A:

Q: The average per of a load is 2.76 KW with a lagging power factor of 0.914. The magnitude of the rms…

A:

Q: A 60 Hz, 33 kV, 3-phase alternator with earthed neutral has a reactance of 7 ohms per phase and is…

A: We have an alternator with earthed neutral which is connected to a bus-bar through a circuit breaker…

Q: 6 similar amplifiers are cascaded, with lower cut-off frequency 100Hz. Bandwidth is B1=10 kHz. What…

A: The higher cut-off frequency lowers and the lower cut-off frequency rises as a result of cascading,…

Q: PROBLEM 6 Find the time domain signal of the spectrum given in Fig -2 IX(e)| E (b) beitraume if h(t)…

A:

Q: Problem 2.4b: Sketch double sided and single sided amplitude and phase spectra of the following.…

A:

Q: 4. Calculate Vout where RO 10kQ, R1 = 5kΩ, R2 = 4kΩ, R3 = 2kQ2, Rf = 50kQ, VO = 5V, V1 = 2V, V2 = 8V…

A: Assume opamp is ideal , for ideal opamp current into opamp terminal is zero and voltage at inverting…

Q: 4 Pole's DC generator delivers a current of 100 A at 230 V. It has 1500 armature carriers attached…

A:

Q: N 11. Consider a piezoelectric capacitor shaped like a slab 1 mm thick and 3 mm² in area.…

A:

Q: III. Procedures: BLOCK DIAGRAM Interconnect the electrical components per set in a block diagram…

A: Given two sets with generators and transformers of different ratings. They are to be interconnected.

Q: A star-connected, 3-phase, 15 MVA, 3.3 kV alternator is protected by Merz Price circulating-current…

A: Given,For a 3-ϕ star connected alternator,S=15 MVAVL=3.3 kVR=8 ΩImin = 0.5 ACT ratio=10005

Q: Using J-K. fp, design asynchronous counter to count binary sequence from 0100 to 1100, Corresponding…

A:

Q: Using nodal analysis, find U₁ and U₂ in the circuit of Fig. 10.3. 30 sin 2t A Figure 10.3 292 0.2 F…

A:

Q: What is the market for electricity?

A: ANSWER             MARKET FOR ELECTRICITY  Electricity market is…

Q: 24p CA 1 GA น 12 V Ov Bu +W 22 u

A: we need to find the current i2 in the branch by using source transformation

Q: A balanced abc-sequence Y-connected source with Van -220L 0° V is connected to a delta-connected…

A:

Q: A carrier of 16 cos (2710ºt) volts is amplitude modulated by a modulating signal of 8 cos(2710³t)…

A: NOTE:      As per our company guidelines we are supposed to answer only first three sub-parts .…

Q: Q4/ The decimal 793.251)= ( number number ( O 1431.204 O 1431.200 O No one of them O 1341.200 O…

A:

Q: Q10/the minimum sum-of- products for the following function isF(A,B,C,D,E)=[m(0,3,5,7,9)+…

A:

Q: (₁ kov Mr 2522 Mur Find the current 42 M 251 Ús 22 чт 22 64 4. 1201

A:

Q: 4. For the system given below R(S) OOT** D(s) G(S) G(s) = 5 (S+2)(S+3) C(s) D(s) = C(S) a) Identify…

A:

Q: what is the electrical symbol shown? a. Socket-outlet b. Twin Switched socket outlet c. 2 way Switch…

A: Given electrical symbol,

Q: Refer to the circuit shown in Fig. 11.88. (a) What is the power factor? (b) What is the average…

A:

Q: A process with two inputs and two outputs has the following dynamics, [[8]-[C [G₁₁(s) G₁₂(S)] G₂1(s)…

A: Given, G11s=4e-5s2s+1, G12s=2e-2s4s+1G21s=3e-6s3s+1, G22s=5e-3s2s+1 Here, we have to find static…

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

A:

Q: For a system with a DC gain of 2 and open-loop poles S1,2= -3+ or - j4 What is the transfer function

A:

Q: Can you please give 5 examples of Kirchhoff's Current Law (KCL) with figure and complete solution…

A:

Q: 3-phase A-connected induction motor has a rated current and a full-load slip of 4 %. Answer the…

A: Given - For three phase induction motor- Direct starting current to rated current = 800% Slip value,…

Q: 4. Determine i in the given circuit. SV (+) 3.2 M W ľ 752 +8V +1

A: Given, The circuit diagram is shown below,

Q: Calculate the amount of gate-to- source voltage necessary to regulate a JFET's drain current at a…

A: Given here drain current and Vgs(off) and Idss and asked to find the gate to source voltage ( VGS…

Q: Example 2.8: Draw the electrical analogue circuit for the mechanical system of Fig. 2.8. Using the…

A:

Q: 2. Given a system with input x(t) and impulse response h(t) given by: x(t) = t³u(t) and h(t) =…

A: Given that Input is given by x(t) and impulse response is given by h(t). xt=t3 utht=t2 ut Find the…

Q: Prepare an assembly chart for a table lamp.

A: An assembly chart is model that shows which part are to be fitted together and the overall view of…

Q: A series R-L-C circuit having resistance 50 2, inductive reactance 0.2 H and capacitance 10uF is…

A:

Q: Q6/F1-A'B'+B'C+ABC+A'C' F2=A'+B'C+A'C F3=B'+ABC F4=A'B+AB'C+A'BC' Chose the correct answer O F1=F3 O…

A:

Q: 50 V OO Select one: O O voltage across terminals a and b is 592 ww O (+1) a. 40 v b. 10 v c. 50 v d.…

A: The given circuit is,

Q: Q1/Find( (90)10/(36)8)* (F1)16+(1100111)2=( )Gray O 1000101100 O 1010100111 O None of them O…

A:

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

A: Given- Steady state error=5%, To Find- The type number and velocity error constant of the system.

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

A: SOLUTION                According to question input signal R(t) = r(t)…

Q: Compute the convolution x[n] *h[n] for all n ≥ 0, by using Graphical or Tabular method.…

A:

Q: What is the relation between Fourier transform & Laplace transform? 5 comparison between Amplitude &…

A: A mathematical model known as the Fourier transform may be used to convert signals between two…

Q: The speed control of an AC motor can be achieved by using 2 common types of drive circuit, namely…

A:

Q: Give the solution for J and K ONLY ans (0.99959 degrees and 63.643 ms respectively).Read A 70-Vac…

A: Given a voltage signal waveform with following equation v(t) = 98.9949sin(20πt + 125.0876°) [From…

Q: A 2 mH, a 3.3 mH, and a 0.2 mH inductor are connected in series. The total inductance is A. 55 mH B.…

A: Given data: L1=2 mHL2=3.3 mHL3=0.2 mH

Q: A closed loop control system is shown in the figure. Find the Damped natural frequency and the peak…

A: Given data, Open loop transfer function is given as, Gs=4ss+1

Q: Q6/F1-A'B'+B'C+ABC+A'C' F2=A+B'C+A'C F3=B'+ABC F4=A'B+AB'C+A'BC' Chose the correct answer O F1=F3 O…

A:

Q: 4. Thevenin/Norton Equivalent of a DC circuit: a. Find the Thevenin equivalent across a - b; (show…

A:

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.