Q5/ If the radius of the capillary tube is r = 0,033 cm and when dipped in a %3D liquid its density d = 0,866 g/cm3 then the height of the liquid in the capillary tube h = 2cm knowing that the gravity g = 981 so the surface tension is equal ;

Q5/ If the radius of the capillary tube is r = 0,033 cm and when dipped in a %3D liquid its density d = 0,866 g/cm3 then the height of the liquid in the capillary tube h = 2cm knowing that the gravity g = 981 so the surface tension is equal ;

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter9: Liquids, Solids, And Materials

Section: Chapter Questions

Problem 74QRT

See similar textbooks

Related questions

Q: The surface tension of water at 20°C is 72.7 mN m and its density is 0.998 g cm" Assuming a contact…

A: Given that, at 20oC The surface tension of water is γ = 72.7 mN/m = 0.0727 N/m = 0.0727 kg/s2. The…

Q: viscosity

A: In this question we have to explain the relate viscosity to strength of IMFs among liquid molecules.

Q: B. The contact angle for water on clean glass is close to zero. Calculate the surface tension of…

A: From the given date , The contact angle = 0 Cos (0) = 1 Temperature at °C = 30°C Height of water…

Q: n measuring the surface tension of a liquid (drop weight method), 20 drops of the liquid (r=0.2cm)…

A: olume = Area x Height , Mass = Volume x Density , Force = Mass x Acceleration V = P r2 H…

Q: For whole blood flowing in a capillary of radius 1.9x10-4 cm, estimate the maximum velocity for…

Q: Q2- Choose the correct answer for the following (Justify your answer): 1- The necking region is the…

A: Necking area is describe the localized reduction of cross-sectional area of specimen under the…

Q: Explain how molecular weight of a polymer can be determined by dilute viscosity measurements?

A: Polymers are composed of multiples of simpler chemical units i.e. monomers or we can say polymers…

Q: Is it possible to have a homogeneous, binary liquid solution that has a higher (or lower) viscosity…

A: Solution stoichiometry involves the calculation of concentration of solutions in the given…

Q: The contact angle for water on clean glass is close to zero. Calculate the surface tension of water…

A: Surface tension- This is property of surface of liquid in which due to cohesive nature of…

Q: When the temperature is 20 ° C, water flows through an ostwald viscometer at 363 s, whose density…

A: Viscosity of a substance is a glowing capacity of that substance. Normally thin liquids have less…

Q: Q2: (A) Sketch the following Miller indices: 1. [ī02] 2 (2iio) 3 (3i2)

A: Miller indices form a notation system in crystallography for planes in crystal (Bravais) lattices.…

Q: n 14 ch of the following corresponds to a layer of ions unaffected by fluid motion and is separated…

A: According to Helmholtz this double layer consist of two opposite charged layers at a fixed distance…

Q: Water required 120.5 seconds to flow through a viscometer and the same volume of acetone required…

Q: The surface tension of water at 20°C is 72.7 mN m and its density is 0.998 g cm³. Assuming a contact…

A: This problem utilises the concept of balancing of downward pressure force with the suface tension…

Q: 11- find the normality N of NaCl soluton , if w/v% = 0.85%. M.Wt =58.5? 0.145 0.0145

A: Given, w/v %=0.85% M.Wt of NaCl = 58.5 g mol-1 Normality = ?

Q: A glass capillary of diameter 0.12 cm is dipped into a liquid. Calculate the level of the liquid in…

A: (a) Water Diameter of tube = 0.12 cm Radius of tube (r) = 0.06 cm = 6.0 * 10-4 m Density of water…

Q: The thermal conductivity of helium at 400 K is 0.176 W m1 K-1. Knowing only this datum, estimate the…

A: Introduction: The ability or tendency of a material to transfer heat is called thermal conductivity…

Q: The viscosity coefficient of gaseous chlorine at 1 atm pressure and 20 C is 147.0 micropoise. Find…

Q: At 537°R, how high will water rise in a glass capillary tube (in cm) with a cross sectional area of…

Q: Calculate the end-to-end distance of a polymer with a molecular weight of 1 million and an intrinsic…

Q: What is the inner diameter of the capillary used in an experiment on the surface tension of liquids…

Q: What is the density of nitrobenzene at 30 degree centigrade and How can you describe the viscosity…

Q: Define cohesion and adhesion, and how they can predict capillary action.

A: Adhesion can be defined as the sticking tendency of particles of different types of material.…

Q: Calculate the viscosity of air at (i) 273 K, (ii) 298 K, (iii) 1000 K. Take σ as 0.40 nm2 and M as…

A: Viscosity is given by: μ=μoTTo3/2To+CT+C ...... (1) where μo is the reference…

Q: Q4: A: Calculate the average of (number, weight, and viscosity) of molecular weight, Dp for…

A: The mid-point of the histogram in the given chart is used for the molecular weight.

Q: The diffusion coefficient of glucose in water at 25 °C is 6.73 × 10−10 m2 s−1. Estimate the time…

Q: Consider two different spherical protein molecules, where the larger protein has a surface area that…

A: Given: Larger protein has surface area greater than smaller protein by 16 times To find: Relative…

Q: Calculate the surface tension of a liquid at 25 °C given that at that temperature, the liquid climbs…

Q: The logarithm of diffusion coefficient (1) (2) with the reciprocal of absolute temperature. (1) =…

A: The logarithm of diffusion coefficient is (1)= decrease, (2)= linearly with reciprocal of absolute…

Q: a) Determine the diffusion coefficient for urea (CH4N20 - molecular weight 60.06 g/mol) dissolved in…

A: Given: Molecular weight of urea = 60.06 g/mol Temperature of water = 37 oC Viscosity of water…

Q: °C, the capillary rise at sea level for th air in a tube with inside diameter 0. e contact angle is…

Q: Q3) Calculate the ratio between the height to which ethyl alcohol rises to water by capillary action…

Q: What is the surface tension of benzene(in micro-Newton/m), if it rises to a height of 1.06299 inch…

A: Given that, w/v % = 0.85% M.Wt = 58.5 g mol-1 Normality = ?

Q: The experimentally measured density of a bulk material is slightly higher than expected based on the…

A: Solution A material could be a substance or mixture of drugs that constitutes associate degree…

Q: Q4: A: Calculate the average of (number, weight, and viscosity) of molecular weight, Dp for…

A: To calculate number , weight and viscosity average molar mass we need to know the relation between…

Q: In an experiment to determine the surface tension of methanol (ρ = 791 kg m-3 at 298 K) it was found…

A: In order to find the surface tension of the liquid we first write down the given data: Density of…

Q: III. Experimental Data Table 3b.1. Observation on determination of melting point of unknown A.…

A: The percent error is calculated using the formula: Percent error=Actual value-theoretical…

Q: For whole blood flowing in a capillary of radius 1.9x10-4 cm, estimate the maximum velocity for…

Q: Пrр dv 8nL using a propagation of errors technique as applied to Poiseuille's law d error in the…

Q: Calculate the mass of the liquids collected in surface tension determination. 2. Calculate the…

A: Mass of liquids collected in the determination of surface tension 1. Water Mass collected in trial…

Q: AI-Si Eutectic, Calculate the mass fraction of the B phase, silicon, given a sample with 61.8 wt%…

A: Given, At 61.8 wt% aluminium at 576.99 oC. Formula Used Mass fraction = given masstotal mass of…

Q: relative viscosity

A: Ans. Option 4. Between 0 and 1. Relative viscosity can never be negative. Relative viscosity with…

Q: To what height would you expect ethanol (γ= 22.39 mN m-1 at 298 K, ρ = 789 kg m-3) to climb by…

A: The column height of a narrow capillary is obtained from following equation.

Q: Calculate the height in meters of a column of liquid glycerol (d = 1.26 g/cm3) required to exert the…

A: Pressure will remain same then we can write dHg×g×hHg = dalc×g×halc Where dHg = density of mercury g…

Q: The viscosity of Cl₂ gas at 293 K and 1.0 atm is 120 up, using these data, what would be the…

A: The expression to calculate the collisional cross-section of a molecule is: σ = 1 / 3 [(8RT / πM)1/2…

Q: Determination of the Surface Tension of a Liquid by the Capillary Rise Method: A group of students…

A: Given:

Concept explainers

Crystallography

Crystallography is the category of science that focuses on the atomic and molecular arrangements with their bonding constituting the crystal structure. It is derived experimentally and originated in the year 1912. It is a combination of two words; those are crystal, meaning a cold drop, and graph, meaning writing.

Question

Q5/ If the radius of the capillary tube
is r = 0,033 cm and when dipped in a
%3D
liquid its density d = 0,866 g/cm3 then
the height of the liquid in the capillary
tube h = 2cm knowing that the
%3D
gravity g = 981 so the surface tension
is equal ;

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

At 25∘C, how high will water rise in a glass capillary tube with an inner diameter of 0.75 mm? For water, T=71.99mN/m and ρ=1.0g/cm3.
A liquid rises to a height of 1.50 cm in a capillary tube. What is the radius of the tube if the density and surface tension of the liquid are 1.80×10³ kg/m³ and 0.135 N/m respectively?
How high will sap rise in a plant if the capillaries are 0.01 mm in diameter and the density of the fluid is 1.3 g cm-3 and its surface tension is 65 mN m-1, assuming that surface tension accounts for the rise? The answer is [2.04m]
At 25 °C, how high will water rise in a glass capillary tube with an inner diameter of 0.25 mm? For water, T = 71.99 mN/m and ρ = 1.0 g/cm3.
To what height would you expect ethanol (γ= 22.39 mN m-1 at 298 K, ρ = 789 kg m-3) to climb by capillary action in a tube of internal radius 0.10 mm?
At 537°R, how high will water rise in a glass capillary tube (in cm) with a cross sectional area of 2.1124×10-6 ft². For water the surface tension is 71.99 mN/m (milli-Newton/meter) and the density is 1000 g/L. With the contact angle to be 0°. A. 8.5 cm B. 2.5 cm C. 12 cm D. 15 cm E. 25 cm F. 13.25 cm G. 14.75 cm
5 if the viscosity of Nacl = 664.256 mpa.s viscosity of NaOH= 1.00979 cp viscosity of water= 0.6531 cp what is the viscosity of the mixture if they are mixed together ?
1) For a crystalline substance with a hexagonal unit cell, the distance interplanar d is given by the expression. Consider graphite, for which a = 0.247 nm and c = 0.679 nm. On a standardized diffractogram with Cu Kα radiation ((λ = 1.5418 Å)), where angle 2θ will be observed the Bragg 002 peak of graphite?
The polypropylene (repeat unit CH3CHCH2) in a plastic object has a molar mass of 2.8x10^5 g/mol and a repeat unit length of 252 nm. Calculate the radius of gyration.
When the temperature is 20 ° C, water flows through an ostwald viscometer at 363 s, whose density and viscosity are given as 0.9982 g / cm3 and 1,000 cP, respectively. The flow time of OF2 from the same viscometer at -145.8 ° C was measured as 68 s. Since the density of OF2 at this temperature is 1.523 g / cm3, what is the value of its viscosity?
At 25 ℃, how high will water rise in a glass capillary tube with an inner diameter of 0.63 mm?
which of the following would have the highest viscosity at a temperature and pressure where all are liquid? Rn, He or Ne?