Q5 Suppose that the modulating signal is a sinusoid of the form m(t) = AmCos2nfmt and carrier signal is %3D c(t) = Accos (2nfct), where fm « fc- %3D (a) Determine the time domain expression of two possible SSB AM signals. (b) Given: Am = 10V, A̟ = 100V, fm = 500KHZ, f. = 2500KHZ, obtain the equations in time and frequency domains and sketch the frequency spectrum of the modulated signal using given values of amplitudes and frequencies. %3D %3D %3D C. %3D

Q5 Suppose that the modulating signal is a sinusoid of the form m(t) = AmCos2nfmt and carrier signal is %3D c(t) = Accos (2nfct), where fm « fc- %3D (a) Determine the time domain expression of two possible SSB AM signals. (b) Given: Am = 10V, A̟ = 100V, fm = 500KHZ, f. = 2500KHZ, obtain the equations in time and frequency domains and sketch the frequency spectrum of the modulated signal using given values of amplitudes and frequencies. %3D %3D %3D C. %3D

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4. short answers a. What is the effective antenna area of an antenna at 2500 MHz, if the gain is 13 dBi. b. For a WCDMA handset with 7 dB noise figure and 5 MHz effective noise bandwidth, calculate the noise floor in dBm. c. An NBA basketball player is close to 2 meters tall, and an “Umpa-Lumpa” from the movie “Willie Wonka” is 0.5 meters tall. Assuming 2-ray propagation model, what is the ratio of the signal strength received by the two people? d. Consider a 12-km microwave link with 15 meter towers at both ends, calculate the minimum frequency in GHz, such the first Fresnel zone does not intersect the ground? Assume that the ground is flat between the towers.
An FM modulator has kf=30kHz/V and operates at a carrier frequency of 180 MHza. Find the output frequency for an instantaneous value of the modulating signal equal to150mV. b. If the carrier signal is modulated by a 2Vrms sine wave. Calculate the peak frequencydeviation. c. Using the given in the previous number, also find the bandwidth using the Bessel table below for thePM signal when the message frequency is (a) doubled, (b) halved, but all else remains constant.
The modulating signal that is the input into an FM modulator is m(t)=2cos(10??).a) Express the time domain expression of ?(?) signal.b) Express FM signal in terms of Bessel functions.c) Sketch the frequency spectrum of the modulated signal.d) Determine the bandwidth of ?(?) occupies 98% of the total power (Carson Rule) in the acquired spectrum.e) Determine the condition of required bandwidth of ideal BPF if at least 80% of the total power appears at the output of the filter?
The SNRi of an FM transmitter is determined to be 24.093dBV. Solve for the peak frequency deviation caused by the noise if the transmitter sensitivity is determined to be 368.903Hz/V, and a modulating signal of 13.926V and the modulating index is kept at 4
You have an FSK transmitter using a mark frequency of 500 kHz, a space frequency of 380 kHz, and sending 10 kbps. A) How much bandwidth do you need for your transmission? B) if you are to design the system with continuous phase shift keying in mind, what would be the value of the space frequency if the mark frequency remains the same?
The equation of an angle-modulated voltage is v = 10 sin (l08t + 3 sin 104,). What form of angle modulation is this? Calculate the carrier and modulating frequencies, the modulation index and deviation, and the power dissipated in a 100-ohm resistor.
A Wi-Fi access point is transmitting at (P) 20 W. A client is 200 meters away with a local noise power (N) of -110dBm. Assume that the received signal power (S) falls off as the square of the distance (r) between the access point and client. What is the SNR in dB? What is the theoretic capacity assuming a bandwidth of 20MHz? [Hint: S = P ?! /(4?? ! ). Assume speed of light in free space as the wave’s speed.] F = 2.4 GHZ, C=3*10^8 m/s.
For an Armstrong indirect FM transmitter with the crystal carrier oscillating at 210 kHz, the crystal reference oscillating at 10.2 MHz, the sideband voltage is 0.018 V, the carrier input voltage to the combiner is 5V, the first and second multipliers are both 40, and the modulating signal frequency is 2 kHz, determine: a.) modulation index at the output of the combining network and the power amplifier; b.) frequency deviation at the same two points; and c.) the transmit carrier frequency.
Given an FM modulator with a deviation sensitivity K1= 3.7 kHz/V and a modulating signal vm = 5.2 sin(2π1,906t), determine the carrier swing in kHz For an FM modulator with an unmodulated carrier amplitude Vc= 14 V, a modulation index m = 1, and a load resistance RL = 8 ohms, determine the power (in watts) in the modulated carrier The percent modulation of the sound portion of a TV signal is 85%. The maximum frequency deviation for the sound portion of the TV signal as specified by the FCC is 25 kHz. Determine the carrier swing (in kHz) of the signal. For an FM modulator with 40-kHz frequency deviation and a modulating-signal frequency fm= 13 kHz, determine the bandwidth (in kHz) using Carson's rule. Given an FM modulator with a deviation sensitivity K1= 1.4 kHz/V and a modulating signal vm = 3.9 sin(2π1,948t), determine the peak frequency deviation in kHz. The percent modulation of the sound portion of a TV signal is 73%. The maximum frequency deviation for the sound portion of the…
The carrier c(t) = 100 cos(2πft) is frequency modulated (FM) by the message signal m(t) = 5 cos( 20000πt), where f.= 100MHz. The peak-frequency deviation is 20 kHz. The modulated signal is a wide-band FM.1. Determine the amplitude and frequency of all signal components that have a power level of at least 10% of the power of the unmodulated carrier component.2. From Carson's rule, determine the approximate bandwidth of the FM signal.
1. Knowing that carrierfrequency=10MHz and Δfpeak=20kHz Find, using Bessel plots and Carson's rule,the bandwidth of the modulated wave, for modulating frequency=a) 200kHz,b)200Hz,c) 10kHz2. sketch the spectrum infrequency.
Consider a mobile system at 900 MHz carrier frequency, and with 25-kHz bandwidth, that is affected by thermal noise (noise temp Te = 300k). Antenna gains of Tx and Rx sides are 8dB and -2dB respectively. Cable loss at Tx is 2dB. The noise figure at Rx is 7dB. The required operating SNR is 18dB and desired range of coverage is 2km. The break point is at 10dB up to which the path loss is given by [ ] , beyond that point the path loss exponent is 3.8, and the fading margin is 10dB. What is the minimum Tx power required?