Q6: Determine the Miller Indices for directions (Three only) and planes of the following:

Q: Lycoming TIO-5XX engine is a turbocharged, fuel-injected, horizontally opposed, six-cylinder…

A:

Q: Determine the acceleration of a 48.3lb block shown in the figure. Ans. a 2.8 ft per sec 48.3 lb swe…

A:

Q: double-shear pin connections at Band D. All pins are 7 mm in diameter. a = 750 mm, b= 350 mm, h= 550…

A: The angle  of the BD with respect to AB can be caluclated using trignometry formula. for the…

Q: B. For the cycle, calculate: 4. Network, W in KW 5. Cycle thermal efficiency, e.

A: For the Rankine cycle, Turbine inlet conditions are P1 = 10 MPa, T1 = 600 oC Condenser pressure =…

Q: kinematics diagram

A:

Q: the centre distance in mm

A: Given data;  Compound gear train with gears;  p=20 teeth  Q= 40 teeth  R= 15 teeth  S=20 TeethGears…

Q: Ex: A pressurized can contains air at a gage pressure of 3 bar when the temperature is 25 °C. The…

A: Given   Initial       Pressure, P1 = 3 bar  Temperature, T1 = 25oC    Final        Pressure, P2 = 14…

Q: Draw the isometric figure for the following projections

A: Find Isometric figure of the projections

Q: Dynamics Lab is A 7.75-kg uniform disk developed in the attached to the 4.85-kg slender rod AB by…

A:

Q: A pulley is supported by a circular pin at A. The pin has a diameter of d = 0.375 in., and each side…

A: When an amount of load act on the object, it has the tendency to change the shape of the object, so…

Q: Air initially at 101.325 kPa, 30°C db and 40% relative humidity undergoes an adiabatic saturation…

A:

Q: A wind generator with an efficiency of 0.85 has a blade diameter of 20 m. if the wind velocity is 30…

A:

Q: A sign of uniform density weighs 320 lb and is supported by a ball-and-socket joint at A and by two…

A: Given Data The weight of the sign is:W=320 lb Now the tension in cable BD and EC is consider as,…

Q: Sketch and name the parts of manipulator? Give some example of robot End effector:

A: Introduction: Robotics is the design and operation of systems capable of doing physical tasks…

Q: 1 à steam power plant uses the ideal Rankine Cycle where the steam enters the high pressure turbine…

A: Given data: Cycle : Reheat Rankine CycleConditions at high pressure turbine  T1 = 300°C P1 =  4…

Q: Below figure shows Ts diagram of an aircraft engine. Draw the engine diagram only. Answer the…

A: Given:

Q: Compute the moment (positive if counterclockwise, negative if clockwise) of the 0.50-lb force about…

A: Moment of force about any arbitrary point is equal to the product of magnitude of force and the…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A:

Q: The 340-lb force is applied at point A of the bracket. Determine the moments of this force about…

A:

Q: the magnitude of unit vector is 2 units 3 units O unity O

A: Correct Option is :  Unity

Q: Two blocks of wood, 50 mm wide and 20 mm thick, are glued together as shown in figure below. Using…

A:

Q: An iron column of annular cross section has an outer diameter of 200mm and is subjected to a force…

A:

Q: Construct and dimension three views of the object. Scale 1:1

A: Find Construct the three views of the object. Scale 1:1

Q: The d = 17-mm-diameter solid rod passes through a D = 22-mm-diameter hole in the support plate. When…

A:

Q: .X2 kl ww W1= 6KN W2= 8000N W1 ▶X1 k2 ml kl 12 KN/cm W2 k2 2 = 15KN/cm

A:

Q: g/s, what is the increase in the water content of the moist air? Express your answer in kg/s.

A:

Q: Moist air initially at standard atmospheric pressure, 15°C db, 70% relative humidity undergoes a…

A:

Q: (e) E = бу 30 MPa Txy 85 MPa Ox 120 MPa = =

A: GivenPart eσx=-120MPaσy=30MPaτxy=85Mpa part fσx=30MPaσy=-80MPaτxy=15Mpa

Q: The 150 mm pipeline as shown conducts water from a reservoir and discharges at a lower elevation…

A:

Q: A 3-phase I.M. operate at 400 Hz has a rated speed 10800 R.P.M, its speed at slip = 0.7 is equal to:…

A: Last option is correct. Correct ans is 3240 RPM

Q: F₁ = 14 kN a= 270mm, b = 160mm, c= 80mm, and 8 = 45° Pin B is in a double-shear connection and has a…

A:

Q: fluid is heated from 125 degrees Fahrenheit to 225 degrees Fahrenheit. Consider an ideal gas with…

A:

Q: Draw (FBD) and calculate the support reactions in the simply support beam ABCD below 3kN b 5kN 60⁰ C…

A:

Q: The rigid beam BC is supported by rods (1) and (2). The cross-sectional area of rod (1) is 10 mm2.…

A:

Q: PLS ANSWER 8-14

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: In A two-stage single-acting air compressor, 5 kg/min. are compressed from 1bar and 20 °C to 16 bar.…

A:

Q: a) A gas is trapped in a piston-cylinder device. The initial pressure and temperature of the gas are…

A:

Q: Three identical steel balls, each of mass m=80kg, are placed in the cylindrical ring which rests on…

A: Solution.jpg

Q: If a disk rolls without slipping, compute for the acceleration a of its COG. Assume the fixed…

A:

Q: Ina hydroelectric plant, water flows at 10 m/s in a penstock of 1.2 cross sectional area. If the net…

A:

Q: A simple pin-connected truss is loaded and supported as shown. The truss is constructed from three…

A: Answer: The stress in each member of the truss: ◆ AB : 45.9650 MPa (C) ◆ BC : 11.4746 MPa (T) ◆ AC :…

Q: Frame {2} is rotated with respect to frame {1} about the x-axis by an angle of 600. the position of…

A: Given data: Angle of rotation = 60 degrees. 1D2 = [9 7 9]T  2P = [4 6 8]T

Q: The L-shape frame shown in Figure 2 is fixed and supported at point A and experienced multiple…

A:

Q: The Bayer information systems discussed in class, and demonstrated in the assigned videos, are…

A: Bayer is a multinational corporation with primary capabilities in the areas of health care and…

Q: * The state of plane stress at a point is represented on the element shown in the figure. The…

A: GIven σx=10MPaσy=30Mpaτ=20MPa

Q: Air initially at 101.325 kPa, 30°C db and 40% relative humidity undergoes an adiabatic saturation…

A:

Q: Axial loads are applied with rigid bearing plates to the solid cylindrical rods shown. If F₁ = 31…

A: According to this principle, if member is subjected to various loading then the resultant load will…

Q: A process innovated by Engr. Santioque is considered to be in a constant pressure. If there is ten…

A:

Q: Axial loads are applied with rigid bearing plates to the solid cylindrical rods shown. If F1 = 30…

A:

Q: Q.1: A standard vapor-compression cycle developing 50 kW of refrigeration using refrigerant 22…

A: Refrigerating effect, Q˙e=50 kWRefrigerant=R22Condensing temperature, TC=35oCEvaporation…

The Space Lattice and Unit Cells

Every matter consists of atoms, molecules, and ions. If these atoms, molecules, and ions (micro-particles) are represented in a three-dimensional space-occupying certain specific points in space, then these arrangements are termed as space lattices and the specific points which are being occupied by atoms, molecules and ions are termed as lattice points. The atoms, molecules, and ions at the lattice points are generally grouped in a regular fashion and repeat periodically at the three-dimensional space.