Q8 The average power to the plant shown in the figure is 2438 kw and the power factor is 0.707 lagging. The generator is sinusoidal in waveform with w = 377 4488 Volts. Determine the value of the ca- rad/sec and the effective value is pacitance C such that the power factor is 0.866 lagging. Plant Zoom

Q8 The average power to the plant shown in the figure is 2438 kw and the power factor is 0.707 lagging. The generator is sinusoidal in waveform with w = 377 4488 Volts. Determine the value of the ca- rad/sec and the effective value is pacitance C such that the power factor is 0.866 lagging. Plant Zoom

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.8MCQ

See similar textbooks

Similar questions

C) Find the average power delivered to the circuit and Find the power factor of the circuit, and indicate whether it is leading or lagging then Write the sinusoidal expressions for the currents and voltage.
A motor is supplied from an AC source with a voltage of 240 V-RMS. The motor is consuming an average input power of 1.2 kW and the current supplied by the source is 6 A-RMS. You can assume the motor has a lagging power factor. Determine: i. The apparent power. ii. The reactive power. iii. The power factor of the load and explain why the reactive power draw of this load may be undesirable.
For maximum average power transfer in the circuit shown in the figure, set the impedance ZLand ZLFind the value of the maximum average power transferred to ? (Can you write the steps in detail in sentences?)
a. Find the average power b. Find the power factor. Is it lagging or leading? c. Find the sinusoidal expressions for the currents and voltage.
For the maximum average power transfer in the circuit shown in Figure 2, use the impedance ZLand ZLFind the value of the maximum average power transferred to ? (Can you write the steps in detail in sentences?)
An industrial installation has a power factor of 0.85 in backward. The demand is 150 KVA, and the operating voltage is 4800 V at 60 Hz. What should be done to bring the power factor to 0.95 in lagging? Indicate what you would connect and with what three-phase power. If the connection of the element to be added is in delta, indicate its reactance and the value of its capacitance or inductance. capacitance or inductance.
1. Write down a formula for the three-phase power factor, assuming perfectly sinusoidal and symmetrical conditions, using line-line voltage measurements. 2. Write down a formula that relates three-phase apparent power to active and reactive power. 3. Draw a graph that depict single-phase waveforms for a purely sinusoidal 50 Hz voltage and a lagging current.
From the circuit given below, How can I find the value of load Z for the maximum power transfer and the maximum average power transferred?
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
1) the RMS value of the current is? /2) the peak value of the voltage is?/3) the value of the reactive power is?
what is the average power absorbed by the load ZL in watts? Assume source is in rms.
If the rms phasor of a voltage is given by V=12060 volts, then the corresponding v(t) is given by (a) 1202cos(t+60) (b) 120cos(t+60) (c) 1202sin(t+60)