Answered: Q/A balanced wye-connected generator…

Q/A balanced wye-connected generator delivers power to the balanced wye-connected load with a Line voltage of 200 v, the load is (10+j8), determine the line currents for abc phase sequence.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.19P: Consider a single-phase load with an applied voltage v(t)=150cos(t+10)volts and load current...

See similar textbooks

Related questions

Q: Q.26: For the circuit shown, let Z,=Z2=Z3=15Z45°Q, and a- the line voltage be a balanced abc (-ve)…

A: Wattmeter is used to measure power in an electrical system. For an balanced Load in three phase…

Q: Determine the amplitude of the line current in a three-phase system with a line voltage of 207 V…

Q: 3. Three wye-connected load impedances, Z. 15260° N, 202 - 30° SN, and Z. 10245° 2, are connected to…

A: Given:Za=15∠60° ΩZb=20∠-30°ΩZc=10∠45°ΩVL=208VVP=2083=120.088V

Q: 11.13 An abc-sequence set of voltages feeds a balanced three-phase wye-wye system. If the line…

A: The solution is given below

Q: One line voltage of a balanced Y-connected source is VAB 240/-20° V. If the source is connected to a…

A: When the load impedance of delta converted to star, its impedance reduces by a factor of 3.…

Q: 11.29 In a balanced three-phase wye-wye system, the total power loss in the lines is 400 W. VAN =…

A: Steps: First, write the per phase mode and calculate the current magnitude using the given power…

Q: 11.17 An abc-sequence balanced three-phase wye-connected source supplies power to a balanced…

Q: Determine the line currents for the three-phase circuit of Fig. Let Va = 11020°, V = 110Z – 120, V.…

Q: Fig. shows a balanced three-phase delta-connected load having per phase impedance of 10 +j 15 2. The…

Q: Q5/A: A balanced abc sequence star-connected source with Va = 100410° is connected to delta-…

Q: 11.45 An abc-phase-sequence three-phase balanced wye- connected source supplies a balanced…

Q: A balanced Y - connected load having in each leg a 20 N resistance in parallel with 20 N capcitive…

A: The phase voltage of generator and phase voltage of load are same as both are star connected.

Q: O: In a three-phase balanced wye-wye system, the source is an abc-sequence set of voltages with…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: In an abc-sequence balanced three-phase system a source is Y-connected and the line voltage Vab…

A: In this question we need to find a line current and phase current of the given 3 phase system.

Q: 2. A 3-ph, delta-connected alternator drives a balanced 3-ph, delta-connected load whose phase…

Q: H.W. An abc-phase-sequence three-phase voltage source connected in a balanced wye has a line voltage…

A: Given an abc phase sequence three phase voltage source connected in balanced wye connection has,…

Q: 11.41 An abc-phase-sequence three-phase balanced wye-connected source supplies a balanced delta-…

A: To solve this question we convert the delta connected load into star since the load is balanced and…

Q: 11.31 In a balanced three-phase wye-wye system, the load impedance is 20 +j12 N. The source has an…

Q: Suppose you have a three-phase delta-wye system, which has a line voltage at the 200 Vac source,…

A: Power factor is cosϕ where ϕ is angle between phase voltage and phase current

Q: Q: In a three-phase balanced wye-wye system, the source is an abc-sequence set of voltages with…

A: In the question, A 3 phase balance star -star system, Line to line voltage Vab= 300∠ 60V Per phase…

Q: 2. One of the line voltage of a balanced Y-connected source is VAB = 240L – 20° V. If the source is…

Q: Given V an = 120/220° V, ZL = 2- j2 N, and Z = 8+j8 N for a balanced three-phase wye-wye circuit…

A: The solution can be achieved as follows.

Q: Q.18: For the circuit shown, let Z=Z2=Z3 =10275° and the line voltage be a balanced abc (tve)…

A: The complex power in an AC system is defined as the product of rms value of applied voltage and…

Q: H.W. A three-phase wye-connected load is supplied by an abc-sequence balanced three- phase…

A: The solution is given below

Q: Three identical impedances are connected in delta across a 3-phase , 600V line. If the line current…

A: In delta connection line current is 3 times of phase current and lags by 30 degree to the phase…

Q: 5. A three-phase wye-connected load is supplied by an abc-sequence balanced three-phase wye-…

A: In a three phase system there are two ways to connect a three phase load. Star/Wye Connection Delta…

Q: a) Find the reading of each wattmeter in the circuit shown in Fig. below ZB = 60 /0 N, and Zc = 40…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: 11.57 An abc-phase-sequence balanced three-phase source feeds a balanced load. The system is…

A: The solution is given below

Q: If the system in Example 8 has line transmission with impedance determine the phase current. 10…

A: It is given that: ZL=10+j12 ΩVab=210 ∠0° V

Q: .If Vab = 234/180 Vrms in a balanced Y-connected three-phase generator, find the phase of the…

Q: 11.19 An abc-sequence set of voltages feeds a balanced three-phase wye-wye system. The line and load…

A: The solution is given below

Q: H.W. A three-phase wye-connected load is supplied by an abc-sequence balanced three- phase…

A: A three phase star connected load. Phase Sequence of the load is abc. This load is connected…

Q: A balanced delta connected generator supplies a line voltage of 180v rms to a balanced load…

A: The line voltage supplied by delta source is: The per phase voltage on star side is given as: The…

Q: 11.15 An abc-phase-sequence three-phase balanced wye-connected 60-Hz source supplies a balanced…

A: In this question we need to find a line current of the given system

Q: A three-phase wye-connected load is supplied by an abc-sequence balanced three-phase wye-connected…

Q: If Vab = 160 Vrms in a balanced Y-connected three-phase generator, find the magnitude of the phase-c…

Q: A balanced three-phase A-connected load with a phase impedance of 10-j16 Q. If the line voltage is…

A: The complex/ Apparent power in a system is defined as the product of rms value of applied voltage…

Q: If Vab = 210 Vrms in a balanced Y-connected three-phase generator, find the magnitude of the phase-b…

A: (Q10)Solution:- Given:- (1) Vab =210 Vrms (2)Y -connected three-phase generator

Q: 31 In a balanced three-phase wye-wye system, the load impedance is 20 +jl2 N. The source has an…

A: The solution is given below

Q: A THREE-PHASE SYNCHRONOUS ALTERNATOR, OPERATING OF ABC SYSTEM WITH AN EFFECTIVE LINE VOLTAGE OF…

Q: 11.44 An abc-sequence set of voltages feeds a balanced three- phase wye-wye system. If V = 440/30° V…

A: In this question, We need to determine the load impedance ZL if source and load voltage is given.…

Q: 11.44 An abc-sequence set of voltages feeds a balanced three- phase wye-wye system. If V = 440/30° V…

Q: B/ A Balanced abc-sequence Y-connected source with Van =100410V is connected to a A-connected…

A: The solution can be achieved as follows.

Q: . A If Vab = 405 V in a balanced Y- connected three-phase generator, find the phase voltages,…

A: Given, 3-phase star connected system Line voltage is

Q: WA Q.26: For the circuit shown, let Z,=Z2=Z3=15Z45°Q, and the line voltage be a balanced abc (-ve)…

Q: A balanced abc-sequence Y-connected source with Van = A-connected balanced load (10+j2)Q per phase.…

Q: H.W. An abc-phase-sequence three-phase voltage source connected in a balanced wye has a line voltage…

A: The magnitude of phase voltage is (1/1.732) times the line voltage .And line voltage leads the phase…

Q: 11.19 An abc-sequence set of voltages feeds a balanced three-phase wye-wye system. The line and load…

A: The solution is given below

Q: One line voltage of a balanced Y-connected source is VAB = 180-20° V. If the source is connected to…

A: In this question We need to determine the phase and line currents. We know , current I= V/Z Phase…

Q: 2. A 3-ph, delta-connected alternator drives a balanced 3-ph, delta-connected load whose phase…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Q/A balanced wye-connected generator delivers power to the balanced wye-connected
load with a Line voltage of 200 v, the load is (10+j8), determine the line currents for abc
phase sequence.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A generator and load are connected in Wye –Wye connection, see figure below.Get the line current ib and phase voltage VANUse a frequency of 100Hz
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020°, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.332Z –120° A (C) 0.9962-120° A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
Three single-phase transformers are connected into a three-phase bank. The primary is connected as a wye, and the secondary is connected as a delta. If 4160 V is connected to the primary, what is the phase voltage?
The primary windings of three single phase transformers are wye connected and the secondary windings are delta connected. The voltage applied to each primary winding is 2300V and the secondary line voltage is 230V find the secondary line current when the primary line current is 30A Show calculations
Two 7970-V:230-V single-phase transformers with impedance with respect to their secondaries of 1.5 + j3 and 2 + j4.5 ohms are connected in parallel to a 7900-V source. Their secondaries are supplying a common load of 30 + j40 ohms. What is the magnitude of the voltage across the load in volts? (2 decimal places)
If the line-to-line primary voltage and line current is 1.0 at 0 degrees, what is the secondary line- to-line voltage for the following three-phase transformers? Assume a turns ratio of N = 10. Express answer in polar form. a. Delta-to-Delta: b. Delta-to-Wye: c. Wye-to-Delta: d. Wye-to-Wye:
Q. 2a) The impedance Zi and Z2 are connected in parallel across 200 V, 50 HZ single phase ac supply. Zi carries 2 A at 0.8 lag p.f. If the total current is 5 A at 0.985 lagging p.f. Determine - 1. Value of Z, and Z2 2. Total power and power consumed by Z2.
For this kind a problem, how do you know how the voltage source is configured ( wye or delta). The problem start getting the phase current for phase 1 and 2 , but do we have to pretend that voltage source to delta load is connected like y-delta to convert the voltage to delta source? Or how does it work?
If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
Draw Wye- Delta three phase transformers connection ( no-load and full-load) in Lt-spice
A generator having emf 7sint Volts is connected in series with 8 Ohm resistor and an inductor of 2 Henrys. Find b) the current, I after 15 minutes.
A 440 V, 60 Hz generatorsuppliestwo parallel-connected loads A and B,. LoadA draws an apparent power of 100 KVA at 0.8 pf lagging and load B draws anapparent power of 70 KVA at unity pf. Determine the KVA supplied by the generator.