QI Figure Q1 shows a canon firing a shell at 50° from the slope, from a height of 200m. It was observed that the shell remained in the air for 4 seconds. (a) Determine the velocity, VA at which the shell was fired. (b) Determine the horizontal distance between A and C. (c) Determine the maximum height the shell attains from the sea level. Neglect the size of the shell. Use g= 9.81m/s2 Hints: The verticle displacement is the difference in elevation of A and C. Va: 50° 200 m Sea kvel 40° 150m FIGURE Q1

QI Figure Q1 shows a canon firing a shell at 50° from the slope, from a height of 200m. It was observed that the shell remained in the air for 4 seconds. (a) Determine the velocity, VA at which the shell was fired. (b) Determine the horizontal distance between A and C. (c) Determine the maximum height the shell attains from the sea level. Neglect the size of the shell. Use g= 9.81m/s2 Hints: The verticle displacement is the difference in elevation of A and C. Va: 50° 200 m Sea kvel 40° 150m FIGURE Q1

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 4-N projectile is shot onto a 400-N sand bag as shown. The bag is hanging from rope 2m long. How high will the sand bag swing if the velocity of the projectile is 300 m/s?
Fluid mech 1.A cargo truck having a weight of 4000 lb skids through a distance of 46 m before colliding with a parked Toyota land cruiser having a wight of 2000 lb. After collision both vehicles skid through a distance equal to 10 m before stopping. If the coefficient of friction between tires and pavement is 0.6 m, compute the speed of the truck after collision. 2. A driver of the service car at Solair Casino Hotel is traveling at 55 mph on a wet road. An object is spotted on the road 450 ft. ahead and the driver is able to come to a stop just before hitting the object. Assuming standard perception/reaction time of 2.5 sec and practical stopping distance, determine the grade of the road if the car has a deceleration of 11.2 ft/sec2.
A projectile with a weight of 45 lbs is heading towards a cantilever beam with a configuration and crosssection as shown. Upon impact, the beam deflects as depicted in the red line. If the allowable flexurestress of the cantilever beam is 20 ksi, determine the resulting deflection of the beam as well as thelimiting speed in m/s of the projectile. Let H = 2b and E = 30 x 10^6 psi
An illegal connection was observed on a 300 mm diameter horizontal pipe. Upstream from the connection two gages 600 m apart showed a pres- sure difference of 140 kPa. Downstream from the connection two gages 600 m apart showed a pressure difference of 116 kPa. How much oil (assume logical Gs, four decimal places) is being stolen due to the illegal connection? Assume loss of head ranging from 40% - 50 % of velocity head for every 50 m. (Please use BERNOULLI'S ENERGY EQUATION) Include complet solutions
Glycerin (s.g.=1.26, and absolute viscosity = 1.49 Pa-s) flows through a rectangular conduit 325mm by 450mm at the rate of 160 lit/sec. Determine the major head loss due to friction (hf) per 1km length of pipe.
40. Situation 14 - A calibration test of a 0.00785 m2 circular sharp-edged orifice in a vertical side of a large tank showed a discharge of 22,300 N of water in 1 minute and 40 seconds at a constant head of 1.20 m. Measurement of the jet showed that it traveled 1.92 m. horizontally while dropping 0.80 m. a. What is the nearest value of the coefficient of contraction? Round off to four decimal places. b. What is the nearest value of the coefficient of velocity? Round off to four decimal places. c. What is the nearest value of the coefficient of discharge? Round off to four decimal places.
A fluid is placed between two parallel plates with area of 2 m2. The lower plate is pulled with 0.4 N with velocity of 0.4 m/s (in x direction), while the upper plate is pulled in other direction (in –x direction) with 0.75 N with velocity of V2 m/s. If the distance between the plates is 1 cm, the viscosity of fluid is 0.01 kg/m.s, find V2.1. Calculate ryx (from the eqn. ryx = ∑ F), consider directions when summing up the forces!2. Use Newton’s law of viscosity to calculate V2
A projectile is fired up the inclined plane at an initial velocity shown. Compute the maximum height z measured perpendicular to the incline that is reached by the projectile. Neglect air resistance.
A tank with 100.58 kPa pressure is connected with manometer measure the pressure. The specific gravity of fluid was 0.85 and the atmospheric pressure is 96 kPa find the manometer column height "h". P-96 kPa
Part A Determine the magnitude of the moment of the force F={50i− 25 j − 80k}N about the base line AB of the tripod. (Figure 1) Express your answer to three significant figures and include the appropriate units.
An illegal connection was observed on a 300 mm diameter horizontal pipe. Upstream from the connection two gages 600 m apart showed a pres- sure difference of 140 kPa. Downstream from the connection two gages 600 m apart showed a pressure difference of 116 kPa. How much oil (sp.gr.=0.8450) is being stolen due to the illegal connection? Assume loss of head ranging from 40% - 50 % of velocity head for every 50 m. (PLEASE INCLUDE COMPLETE SOLUTION) USE BERNOULLI'S ENERGY EQUATION
1.) What is the mass (lbm) of an object that has a base area of 4 inch2 which exerts a pressure of 25 psi? 2.) Determine the dynamic viscosity (Pa-sec) and kinematic viscosity (m2/s) of water with a specific weight of 9.81 kN/m3, if a Falling Sphere Viscosimeter test is conducted using an aluminum sphere that has a diameter of 10 mm and a specific weight of 28.06 kN/m3. The theoretical terminal velocity of the sphere is 0.650 m/s. Round off your answer to 3 decimal places. 3.) Given the water tank A in an orifice setup that transfers water to tank B, determine the theoretical and actual velocity and flow rate if the time it takes to fill up tank B is 20 sec. 4.) Given the computed velocities and flow rates in Question 3, determine the coefficient of contraction, velocity, and discharge. Assume the diameter of vena contracta to be 4mmø.