Question 20SaAtThe shown circait is connected for a very long time with all capacitors were initially uncharged. The final charge on C, and Cz are Q1 and 02, respectively. You are given that C-2C E- t undEy- 33 E1. Find the ratio Q2Qr.RRR Question 20 Sept Artowe The showncircuit is connected for a very longtime with all capacitors were initiallyuncharged . The final charge on C,and C2 are Q, and Q2 , respectively .You are given that C - 20 , E and E-33 £ ,. Find the ratio Q2 Q1 E1 G, REs

First we will find out voltage for given capacitor then we will find charge .

Question 20 SaveAt The shown circait is connected for a very long time with all capacitors were initially uncharged. The final charge on C, and Cz are Q1 and 02 respectively. You are given that C-2C, E- t and Ey- 33 E. Find the ratio Q2Qr. R Es R

Question 20 SaveAt The shown circait is connected for a very long time with all capacitors were initially uncharged. The final charge on C, and Cz are Q1 and 02 respectively. You are given that C-2C, E- t and Ey- 33 E. Find the ratio Q2Qr. R Es R

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A charge Q is placed on a capacitor of capacitance C. The capacitor is connected into the circuit shown, with an open switch, a resistor, and an initially uncharged capacitor of capacitance 3C. The switch is then closed, and the circuit comes to equilibrium. In terms of Q and C, find (a) the final potential difference between the plates of each capacitor, (b) the charge on each capacitor, and (c) the final energy stored in each capacitor. (d) Find the internal energy appearing in the resistor.
A paper dielectric plate capacitor is to be experimentally tested. The metal plates and the paper material between said plates are all 20 cm in radius and subjected to 10V dc in the test. How much is the capacitance does this capacitor have in picofarads (pF), if the paper material between plates used is 2 cm thick? Input answer in 4 decimal places and in pF. Note: Relative permittivity of the paper ( εr ) : 0.4225
Determine the total capacitance, total charge, individual voltage drop and charges across across each capacitor. Use two decimal places for your answer. Please put your answer for the individual voltage and charge for each capacitor in a table for faster checking. Thank you! C1= 27 F C2= 53 F C3= 21 F C4= 50 F C5= 17 F C6= 22 F C7= 45 F C8= 16 F C9= 25 F C10= 16 F V= 110 V Note: This topic is under capacitors.
In the circuit shown: a) Obtain the equivalent capacitance in pF b)Determine the charge Q1 (nC) at the capacitor C1. c) Determine the charge Q2 (nC) at the capacitor C2 d) Determine the charge Q4 (nC) at the capacitor C4. e) Solve the voltage (V) across C1. f) Solve the voltage (V) across C2 g) Solve the voltage (V) across C3 h) Solve the voltage (V) across C4
The following data was collected in a lab where a 1000 uF capacitor was discharged using a 3 volt power supply. The capacitor was in series with a resistor of unknown value. a. Draw an RC circuit diagram where a capacitor can be charged and discharged in the same circuit using asingle pole double throw switch.b. Construct a graph of showing the discharge curve of the capacitor’s voltage with time using the databelow.c. Linearize the data below to construct a straight line with a constant slope.d. The graphs should be labeled and titled. The axes should be labeled with appropriate units.e. Using the the linearized data calculate the time constant for the RC circuit.f. Calculate the value of the unknown resistor.g. Show that the capacitor is nearly discharged after 5 time constants.
Determine the total capacitance, total charge, individual voltage drop and charges across each capacitor. Use two decimal places for your answer. Put your answer for the individual voltage and charge for each capacitor in a table for faster checking. Thank you! Here are the values for the capacitors: C1 = 55 C6 = 50 C2 = 25 C7 = 17 C3 = 49 C8 = 44 C4 = 22 C9 = 53 C5 = 45 C10 = 44
A small capacitor of 100 pF is charged by a steady current of 1 µA for 1 ms. At that time, the charging circuit is disconnected. a) What is the voltage across the capacitor when the charging finishes? b) A 10 MΩ resistor is connected across the capacitor to discharge it. Sketch a graph of the voltage V across the resistor as a function of time, with appropriate numbers and units marked on the axes.
The differential equation for the instantaneous charge q(t) on the capacitor in LRC-series circuit has inductance L = 1 henry, resistance R = 2 ohms, capacitance C = 0.1 farads and external force E(t) = O. Given that there is no initial current and the initial charge is 1 coulomb. a) Find the equation of the charge. (b) Sketch the graph of the charge.
For the circuit, now keep switch J2 closed, close switch J1. Determine the expressions for the voltage across the capacitor and the current delivered by the source.
draw graphs of the voltage over r1 (v against t graph) for the charge cycle. starting at t=0 until steady state after the switch is closed (initially all capacitors are empty) and another case when the switch is opened (initially the capacitors are fully charged)r1 = 100k ohms r2 = 10k ohms v1 = 5v (dc) c1 = 100nf c2 = 220nf c3 = 330nf
a) Find the mathematical expression for the voltage VR (t).b) Calculate the reactive power on the capacitor.
Vbatt=25 VC1=90 ?CC2=75 ?CC3=60 ?CR1=160 ΩR2=120 Ωt2=21.6 msect3=27 msecConsider the circuit shown below which shows a battery connected to some resistors and capacitors along with some switches which will be toggled opened or closed at different times. The components are listed above. The capacitances are in microFarads (?F), the resitances are in Ohms (Ω), and the times are in milliseconds (msec). A stopwatch is started at time t1=0 ms. At that time, switch S1 is closed and all other switches are open and the capacitor is allowed to charge up.(a). (i)What is the charge (in uC) on C1 at the time the stopwatch reads t2=21.6 ms?a)3690 b)1520 c)5710 d)2630 e)683 f)1750 (a).(ii)What is the current (in mA) through R1 at t2=21.6 ms?34.9 30.4 114 13.6 73.6 52.4 (b)(i)What is the voltage (in V) across R1 at t2=21.6 ms?8.37 5.58 2.18 11.8 18.2 4.85(ii). What is the voltage (in V) across C1 at t2=21.6 ms?63.2 29.1 40.9 7.57 19.4 16.9(c). (i) What is the energy (in mJ) in C1 at t2=21.6 ms?6.63…