Question 4: A well with a storage coefficient of 0.05 m/s has a slope define by rise = 3 and run = 4. Find the velocity of flow using Darcy’s equation. Question 5: The soil porosity in the area where the 46-cm diameter well in Question#4 is 48%, find the discharge of the groundwater. Question 6: Given the coefficient k in Question#4 and porosity p in Question#5, find the transmissibility (T) in m/s per unit m, if the aquifer width is 1.2 m.

Question 4: A well with a storage coefficient of 0.05 m/s has a slope define by rise = 3 and run = 4. Find the velocity of flow using Darcy’s equation. Question 5: The soil porosity in the area where the 46-cm diameter well in Question#4 is 48%, find the discharge of the groundwater. Question 6: Given the coefficient k in Question#4 and porosity p in Question#5, find the transmissibility (T) in m/s per unit m, if the aquifer width is 1.2 m.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.5P

See similar textbooks

Similar questions

Given: velocity of flow = 0.0375 m/s coefficient =0.05 m/s porosity p =48% slope S = 3/4 The soil porosity in the area where the 46-cm diameter well is 48%, find the discharge of the groundwater. Given the coefficient =0.05 m/s and porosity p =48%, find the transmissibility (T) in m/s per unit m, if the aquifer width is 1.2 m. Given the discharge Q get in Question #1, transmissibility T in Question#2, slope S = 3/4; find the aquifer width X.
(Question: 4: A well with a storage coefficient of 0.05 m/s has a slope define by rise = 3 and run = 4. Find the velocity of flow using Darcy’s equation.)The soil porosity in the area where the 46-cm diameter well in Question#4 is 48%, find the discharge of the groundwater.
For the two-dimensional flow system shown below (units in meters):Compute the total flow rate under the Dam. X = 4, Y = 8. Note 1: Point A is located in the middle point of the equipotential lines. Point B is located in the middle point of the flow lines.Note 2: Assume e=0.8 (void ratio) and k=10^-3 cm/s (coeff. of permeability).Note 3: Datum is located at the bottom level of the water (right side of Dam).Note 4: Remember, the figure is drawn to scale. So, use the value of 2X+Y to estimate any dimension that you consider necessary.
Given: velocity of flow = 0.0375 m/s coefficient =0.05 m/s porosity p =48% slope S = 3/4 The soil porosity in the area where the 46-cm diameter well is 48%, find the discharge of the groundwater.
Given: velocity of flow = 0.0375 m/s coefficient =0.05 m/s porosity p =48% slope S = 3/4 The soil porosity in the area where the 46-cm diameter well is 48%, find the discharge of the groundwater. Given the discharge Q get in Question #1, transmissibility T in Question#2, slope S = 3/4; find the aquifer width X.
Refer to Figure 6.14. Find the flow rate in m3 /s/m length (at right angles to the crosssection shown) through the permeable soil layer given H = 3 m, H1 = 2.5 m, h = 2.8 m, L = 25 m, a = 10°, and k = 0.04 cm/s.
Find the rate of flow in m^3/sec/m (at right angles to the cross-section shown in Figure 7.33) through the permeable soil layer. Given: H 4 m, H1 2 m, h 2.75 m, S 30 m, a 14°, and k 0.075 cm/sec.
The figure below represents a system with flow in the horizontal direction. Find the value of each pressure charge, level charge, and total charge in A, B, C, D, E, F, G, plus the real and approximate velocity of water flow plotting all of the above, given that soil porosity = 0.33 and transmittance coefficient = 0.50 cm/sec
Given the coefficient k =0.05 m/s and porosity p = 48%, find thetransmissibility (T) in m/s per unit m, if the aquifer width is 1.2 m.Formula: - It is the flow rate per day thru a unit areaunder a unit hydraulic gradient For an aquifer with thickness, Band width, X:T = K*B and Ag = BXThus: Q = (T*X*S)
The hydraulic conductivity of a homogeneous gravelly aquifer is 3 x 10-1 cm/sec. The hydraulic gradient (groundwater surface slope) of the phreatic (water table) aquifer is 0.01 and the aquifer's effective porosity is 0.25. Calculate the following two parameters and provide the answer to question b) in the space provided (numerical answer only, no units or any). Calculate the specific discharge that represents flow conditions of the aquifer in cm/sec. Also Calculate the approximate average velocity of a conservative solute dissolved in this aquifer, calculated to units of cm/sec (enter numerical answer without stating units).
The following figure shows and inclined aquifer at 100 to the horizontal. The difference in water level between to observation points of 60 m is 5 m. Determine the discharge through the aquifer per unit width if k = 0.7 mm/sec. The depth of aquifer normal to the direction of flow is 2.95
The coordinates and the total heads of three observation wells in a regional aquifer are tabulated below. Determine hydraulic gradient and direction of the groundwater flow. 1 0 x 0 y 57.79 m total head 2 200 340 55.11 3 190 -150 52.80