Question 4: al Give four main characteristics of b1 Give four main programming languages of a PLC cl Give the name of the PLC. used your Lab for practical, a PLC

Q: ● Plot the root locus for the C.E. of system as 0<K<∞o. K S³ + 3s² + 2s 1+ 0 A) Find the number of…

A: Given characteristic equation (C.E) isWe need to plot the root locus for the C.E. of system as…

Q: A power amplifier delivers 50 W output at 50% efficiency. The ambient temperature is 25°C. If the…

A: It is given that:  A power amplifier delivers 50 Watts power at 50% efficiency.  The ambient…

Q: -26 Prodem 3. If ((t) = C ²²tu(e) f what's too? Vo V₁₂ Priett) (SE) ↑ EIH (56) 1 mmm 22 QSF £…

A:

Q: A 440-V 50-Hz six-pole Y-connected induction motor is rated at 75 kW. The equivalent circuit…

A:

Q: An amplifier with an open loop gain of 500 operates in an environment where a certain temperature…

A: The above question is based on sensitivity in a feedback system. As asked, only part (b) has been…

Q: Q2)A-A 220-V, three-phase, two-pole, 50-Hz induction motor is running at a slip of 5 percent. Find:…

A:

Q: The capacitor voltage of the RC circuit depicted in Fig Q3 is denoted by V.(t). Vin R Vc(s) = 1(t) 7…

A: Given Data: An RC series circuit with, Input voltage Vint=t-e-4t Output capacitor voltage = Vct…

Q: How do I see the answer

A: It is given that: Three phase voltageV=480 Vsupply frequencyf=60 Hzsupply current(I)=216 ATrue…

Q: 2s. IX. Refer to Figure 9. Switch Si in the circuit below is closed at t=0, and switch S₂ is closed…

A: In this question We need to determine the current in the inductor at different different time.  We…

Q: 4. A 1-cm by 2-cm solar cell has a conversion efficiency of 9%. Determine the maximum power rating…

A:

Q: The figure below shows the small-signal, equivalent-circuit model of a bipolar junction transistor…

A: Step-1-&gt;

Q: I. USING KIRCHOFFS CURRENT LAW (KCL), FIND THE REQUIRED CURRENT IN THE FIGURE BELOW. a) Find 11 if…

A: In this question we need to find the current I1 shown in the given fig .

Q: A system is described by a differential equation as dy(t) Follows +3y(t)= u(t). dt Assume initial…

A: It is given that: dytdt+3yt=utinitial conditions are zero.

Q: an you please appear the solution. Thanks

A: L=5 H,R=16 Ω,E=120 Volts.

Q: 7. For the system shown in Fig. Q7, where (-0.6, and wn=5 rad/sec. Obtain the rise time t, peak time…

A: The damping ratio,ξ = 0.6 and undamped/natural frequency, ωn =5rad/sec Need to calculate rise time,…

Q: Problem 4 Find the time-domain node voltages v1(t) and v2(t) in the circuit shown in Fig. P4 -j5 n…

A:

Q: For the circuit attached, determine: A. The voltage across each capacitor. B. The energy stored in…

A: In this question , we have given an electrical circuit having  number of capacitor connected in…

Q: Complete both the nodal analysis and mesh analysis sections of Table 3.0. Include all calculations…

A:

Q: For the circuit shown below, determine the current io(t) using super position theorem. 8V + 0.25 F…

A: For the circuit shown below determine the current i0(t) using superposition theorem: According to…

Q: Design and implement Octal to Binary converter using Encoder

A:

Q: QUESTION 5 Consider the feedback system illustrated: r(t) + s+3 and G(s) = s+10 Which of the…

A:

Q: Explan the method to compensation of bias current, offset voltage,Offset current and maximum output…

A: Offset voltage in op-amp circuits can introduce small errors.Manufacturers provide provisions to…

Q: GI the network of Pig (2) Pined the value of 24 for maximum Power transfer to the load then find…

A:

Q: Calculate the rms value of each of the following: (a) v(t) = 5 + 3 cos (10t +30°) V (b) i(t) = -3 +…

A:

Q: b) Find I4 if I2 = 3A, I3 = 5A, I1 = 6A, & I5 = -4A. = L

A: Kirchoffs current law states that the sum of incoming currents to a Node is equal to the sum of…

Q: 14. Determine the nodal voltages for the networks in Fig. 17.72. 1₁ = 3A 20 바 (1₁ voo 592 402 20 0₁₂…

A: By applying nodal analysis to above circuits we get two linear equations interns of V1 and V2 for…

Q: V₁ Ri V2 R + + R Vo=?]

A: Given: An op-amp circuit,  To find: The value of V0.

Q: Q5)A- A 3-phase Induction motor has an efficiency of 0.91 when it delivers an Output power of 22KW.…

A: The above question is based on the power flow diagram of a 3-phase induction motor. Please note that…

Q: consider a 1- I imaging system with rect. This is a bar phantom with bar width and separation "w" as…

A:

Q: (b) Series Resistors Circuit - KVL (i) For the circuit of Figure 2.1a, assume the source-voltage, E…

A: supply voltage E = 15 V resistances are  R1 = 3.3 KΩ  R2 = 2.2 KΩ R3 = 1 KΩ measurement of voltage…

Q: The Nyquist plot of a system with transfer function GH (s) = tem stability. Use Nyquist criterion,…

A:

Q: these waveforms and explain M soidal waveforms. ime

A:

Q: 400/231V Asom 100m j-0,15 A/m co 1 100m 125m 80 A cos 5-1 j-0.08 A/m 50m 50m 400/231V In the…

A:

Q: b) Figure Q3 shows an MOS inverter consisting of a saturated n-MOST load (M₁) and an enhancement…

A: An n-MOS inverter consists of a depletion n-channel load ML and an enhancement n-channel driver MD.…

Q: is (mA) A 30 0 -30 is 1 6 μF 2 3 ↓in 4 4 μF 5 - 12 + 5. V

A: A parallel Capacitor circuit is given we need to plot and calculate v(t) , i1(t) and i2(t) Figure:-

Q: A O B m 4 Н 5 Н (a) m 6 H oc OD A O BO Li M (b) 12 ос OD

A: given here two circuit and asked to find the values of L1 , L2 , M

Q: The time constant in the circuit shown below is 20 V ΣΩ + Μ 48 V 1=0 6Ω Μ 2 Η 3 Ω

A: Circuit diagram is given as,

Q: Construct the Bode plot for the phase of the following transfer function. 100(je + 1) (jo) (jo+10)…

A:

Q: Determine the inverse Laplace transform of -5760 e-s G(s) 87 Note: You must use the notation u(t -…

A:

Q: using mesh analyses find the power lose in las resistor

A: It is given that:

Q: For the circuit in the figure, assuming that the op-amp is ideal in all respects: 1. Derive an…

A: The op-amp circuit is shown below, Where,L=1 mH.R1=10 kΩ.R2=100 kΩ.

Q: Q2: Consider the rectangular loop shown in Figure below. Calculate the torque? X Z Bo=-0.6a, +0.8a,…

A: The magnetic field, B→∘=-0.6ay+0.8az T The current flowing in the loop, I=4 mA

Q: Calculate the rms value of each of the following: (a) v(t) = 5 + 3 cos(10t +30°) V (b) 10°) A i(t) =…

A: (a) vt=5+3cos10t+300. (b) it=-3+7sin8t-100 A. (c) vt=15 V.

Q: For the following circuit, VDD = 2 V, VBE = 0.7 V, Vx = 0.8 V, kn = 20 mA/V², Is = x fA (see below),…

A: ϕλ Ω We have given circut is Common-Emitter trasistor amplifier circuit VDD = 2V VBE = 0.7V Vx =…

Q: Write a VHDL code to implement Full Adder-Full subtractor with a control k.

A: Inputs: A, B, Cin and K Outputs: Sum and COUT Operation If K=0, perform Addition Sum=A⊕B⊕Cin…

Q: Problem 10. For the negative feedback systems having the following open-loop transfer functions, K(s…

A: The open-loop transfer function of two negative feedback systems are given as i KGsHs=Kss+2s+5s+8,ii…

Q: Find the charge on the capacitor in an LRC-series circuit when L == h, R = 10 , C = 0.01 f, E(t) =…

A: a) To find the charge on the capacitor in an LRC-series circuit. when L=12h, R= 10 Ω, C= 0.01 f,…

Q: (b) Series Resistors Circuit - KVL = (i) For the circuit of Figure 2.1a, assume the source-voltage,…

A: supply voltage E = 15 V resistances are  R1 = 3.3 KΩ  R2 = 2.2 KΩ R3 = 1 KΩ measurement of voltage…

Q: For the signal x(t) = 12 cos(2π350t + π/4), find the signals y(t) for each sampling frequency which…

A: x(t) = 12 cos(2π350t + π/4)

Q: The Point Charge Q = 18 nc has a velocity of 5x10 m/s in the direction ar = 0.609x +0.75ay +0.30ax…

A:

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.