QUESTION 5 Given an electric potential of V= 4περ Γ find its corresponding electric field vector. Sol. Using the concept of potential gradient, we have È = - V Since we only have, radial direction (r). Then, the del-operator will be V=î- dr By substitution, we get Ê = - - Evaluating the differential, we, get the following 1 È = *(q/ 4πεο

QUESTION 5 Given an electric potential of V= 4περ Γ find its corresponding electric field vector. Sol. Using the concept of potential gradient, we have È = - V Since we only have, radial direction (r). Then, the del-operator will be V=î- dr By substitution, we get Ê = - - Evaluating the differential, we, get the following 1 È = *(q/ 4πεο

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter19: Electric Potential And Electric Field

Section: Chapter Questions

Problem 30PE: In nuclear fission. a nucleus splits roughly in half. (a) What is the potential 2.00 10-14 m from a...

See similar textbooks

Similar questions

The practical limit to all electric field in air is about 3.00106 N/C. Above this strength, sparking rakes place because air begins to ionize, (a) At this electric field strength, how far would a proton travel before hitting the speed of light (ignore relativistic effects)? (b) Is it practical to leave air in particle accelerators?
Oppositely charged parallel plates are separated by 5.33 mm. A potential difference of 600. V exists between the plates. (a) What is the magnitude of the electric field between the plates? (b) What is the magnitude of the force on an electron between the plates? (c) How much work must be done on the electron to move it to the negative plate if it is initially positioned 2.90 mm from the positive plate?
From a distance of 10 cm, a proton is projected with a speed of v=4.0106 m/s directly at a large, positively charged plate whose charge density is =2.0105 C/m2. (See below.) (a) Does the proton reach the plate? (b) If not, how far from the plate does it turn around?
A long cylinder of aluminum of radius R meters is charged so that it has a uniform charge per unit length on its surface of . (a) Find the electric field inside and outside the cylinder, (b) Find the electric potential inside and outside the cylinder, (c) Plot electric field and electric potential as a function of distance from the center of the rod.
In nuclear fission. a nucleus splits roughly in half. (a) What is the potential 2.00 10-14 m from a fragment that has 46 protons in it? (b) What is the potential energy in MeV of a similarly charged fragment at this distance?
(a) What is the electric field at the lower-light-hand corner of the square shown below? (b) What is the force on a charge q placed at that point?
An electron is located at the origin of the coordinates, anda second electron is brought to a position 2 Å from theorigin in the 1y direction.(a) Calculate the force on the electron at the origin, givingthe components Fx and Fy.(b) Calculate the potential energy of the two electrons.
A simple and common technique for accelerating electrons is shown in the figure, which depicts a uniform electric field between two plates. Electrons are released, usually from a hot filament, near the negative plate, and there is a small hole in the positive plate that allows the electrons to pass through.Randomized VariablesE = 2.7 × 104 N/C Calculate the horizontal component of the electron's acceleration if the field strength is 2.7 × 104 N/C. Express your answer in meters per second squared, and assume the electric field is pointing in the negative x-direction as shown in the figure.
An electron flies into a parallel plate capacitor with length L=10cm and width d=2cm, with an electric field E=1000kV/cm (see the Fig.). 1. What should the maximum velocity be for the particle to be trapped, i.e., hit capacitor plates? [electron mass -mp= 9.1 × 10-31kg, its charge is q= −1.6 × 10−19C, the electric force is found as ? = ??]. Assume that electron flies right in the middle of a capacitor. 2. Find and plot its trajectory for this case (that is, case of maximum velocity).
An electron is to be accelerated in a uniform electric field having a strength of 264×20°Y What energy in keV is given to the electron if it is accelerated through 0.76m? Could you please show all work and look at correct answer
Calculate much net Work per unit charge would it take to move a particle from a -15V potential to a +10V potential? Does the path of the motion matter?
Given an electric potential of find its corresponding electric field vector. Sol. Using the concept of potential gradient, we have Since we only have, radial direction (r). Then, the del-operator will be By substitution, we get Evaluating the differential, we, get the following *(q/)