Question-7, A runway is being constructed in a new airport as per the International Civil Aviation Organization (ICAO) recommendations. The elevation and the airport reference temperature of this airport are 535 m above the mean sea level and 22.65 °C, respectively. Consider the effective gradient of runway as 1%. The length of runway required for a design-aircraft under the standard conditions is 2000 m. Within the framework of applying sequential corrections as per the ICAO recommendations, find the length of runway corrected for the temperature.

Question-7, A runway is being constructed in a new airport as per the International Civil Aviation Organization (ICAO) recommendations. The elevation and the airport reference temperature of this airport are 535 m above the mean sea level and 22.65 °C, respectively. Consider the effective gradient of runway as 1%. The length of runway required for a design-aircraft under the standard conditions is 2000 m. Within the framework of applying sequential corrections as per the ICAO recommendations, find the length of runway corrected for the temperature.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The length of runway under standard conditions is 1620 m. The airport site has an elevation of 270 m. its reference temperature is 32.9 0C. If the runway is to be constructed with an effective gradient of 0.2 percent, determine the corrected runway length.
"Airport Engineering" Solve ASAP The length of runway under standard conditions is 1620 m. The airport site has an elevation of 270 m. its reference temperature is 32.9 0C. If the runway is to be constructed with an effective gradient of 0.2 percent, determine the corrected runway length.
a 3.1% rising gradient meets a 2.0% down gradient. a vertical curve 200 m is to be used. Calculate the location (m) of highest point measured form BVC. express your answer in 1 decimal place.
A 3.3% rising gradient meets a 1.8% down gradient. A vertical curve 200 m is to be used. Calculate the location (m) of highest point measured from BVC. Express your answer in 1 decimal place.
What does the approach velocity signify in the Rose equation and the Carmen Kozney equation used to calculated the head loss?
The following consecutive readings were taken with a level on continuously sloping ground at a common interval of 20 m. The last station has an elevation of 155.272 m. Rule out a page of level book and enter the readings. Calculate (a) the reduced levels of the points by rise and fall method, and (b) the gradient of the line joining the first and last points. 0.420, 1.115, 2.265, 2.900, 3.615, 0.535, 1.470, 2.815, 3.505, 4.445, 0.605, 1.925, 2.885.
A field measuring 45 m X 90 m is to be prepared using a 1-m upland power tiller at a speed of 3 kph. Assume a 10% overlap between passings and 9 seconds turn around time at the end of each pass. Determine the field efficiency in going the longer field direction:a. 77% b. 80%c. 83% d. 86%
Water is flowing to a depth of 2 ft in a trapezoidal ditch having a bottom width of 3 ft and aside slopes of 2:1. The roughness coefficient is 0.042. The gradient of the ditch is 0.15.Calculate the velocity in ft/s using Mannings’ equation. Answers should be 11.94
suppose you are taking a hike at mt. pulag with a terrain slope of 24 degree from the horizontal. after waling 70 meters, you stopped at point b and throw a stone, perpendicular to the terrain, back to your initial position. determine the velocity of the stone to reach the ground
Water flows in the triangular steel channel of a velocity of 0.41 m/s with an angle at the vertex of 550. The channel bed has a slope of 0.0015 and a roughness coefficient of 0.014. Compute the rate of flow in m3/s Round your answer to 3 decimal places.
The elevations of the ski jumping hill are as follows: hA = 44 mhB = 1.6 mhC = 4.9 m If the velocity of a ski jumper is measured to be 27.9 m/s at position B, what will be the launch velocity (in m/s) at position C.
For a flow of 1500 liters of water per second through a circular channel of 2 m diameter flowing half full. The value of Manning's constant is 0.015 for the rough concrete lining used. Compute the slope required for the flow in the channel. a) 1/1934 b) 1/3295 c) 1/551 d) 1/1569