Question 8 Consider the three wires below, labelled X, Y, and Z, carrying various currents as indicated. X Electron current > Y Conventional current In which wire(s) are there electrons moving from right to left? O X and Y O X only O Y only O X, Y, and Z O Z only O Y and Z

Question 8 Consider the three wires below, labelled X, Y, and Z, carrying various currents as indicated. X Electron current > Y Conventional current In which wire(s) are there electrons moving from right to left? O X and Y O X only O Y only O X, Y, and Z O Z only O Y and Z

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter10: Using Wire Tables And Determining Conductor Sizes

Section: Chapter Questions

Problem 10PP: Determine the ohms-per-mil-foot of an aluminum conductor located in an area with a temperature of...

See similar textbooks

Related questions

Q: Solve the following problems with complete solutions and units using 2 decimal digits: An annealed…

Q: What is the cross-sectional area and diameter of a wire that has a length of 1,500 mm and a…

A: Given data: Length = 1500 nm R = 0.43 ohms Resistivity of silver =1.59 x 10-8 Resistivity of…

Q: What will be the string efficiency of a suspension type insulator which has 3 discs? The voltage…

A: string efficiency can be calculated using the following formula

Q: A conductor with a will cause a smaller voltage drop, since its resistance is smaller. O a. large…

A: we know R=ρlA So R∝1A

Q: a) Electric circuit is defined as a combination of various electronic components that prevent the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Round 12-gauge copper wire has a resistance of 1.6W / 1000ft. Calculate the power lost in the…

A: First we will find out resistance for given length then we will find out power and voltage .

Q: If the current flowing in a certain conductor is 40 mA. a. find the total charge in coulomb and…

A: Given, Current in conductor I=40 mA Time t=1.8 s Charge on electron qe=1.602×10-19 C

Q: A copper conductor has a diameter of 0.6 in and it is 1200 ft long. Assume that it carries a total…

Q: a copper conductor of radius 3mm with resistance of (4 ohm) with resistivity of a copper is 0.0159…

A: Resistance of the copper 4ohm Radius R= 3mm Resistivity = 0.0159 u ohm Length?

Q: Two wires, VWire A and Wire B, are made from the same material, but Wire A has a greater resistance…

A: Resistance = (resistivity)×(Length of the wire)/( cross sectionarea of the wire). For same material…

Q: A cable has two conductors, which are connected together at one end of the cable for testing…

A: Given a cable has two conductor for testing purpose, When the cable length, l1 = 700 m The…

Q: A certain wire has a resistance of R. The resistance of another wire identical with the first except…

A: Given, A certain wire has a resistance R, we know that, R=ρlA R= Resistance ρ=resistivity of the…

Q: Two identical, long wires carry equal amounts of currents in the same direction. When their…

Q: A cylindrical copper rod has resistance 37 Ohm . We pull the rod so that its new length is 13 times…

A: As the volume of the wire remains unchanged, determine the expression relating the areas.…

Q: a.a. Which of the following statements about grounding electrode conductors is true? A. They…

A: a.a. The grounding electrode must be connected to earth and electrical equipment in such a way that…

Q: Problem 3. An annealed copper wire has a resistance of 2.672 at 27°C. Find the resistance at 60°C.

A: In this question resistance of copper wire is given at any temperature....We have to find out it's…

Q: If the current flowing in a certain conductor is 40 mA. a. find the total charge in coulomb and b.…

A: Given data: I= 40mAt=1.8 s

Q: 4. You have two cylindrical conductors each one meter long. One is made of aluminum with a radius of…

A: Given, LAl=1 mLCu=1 mrAl=1 mm=1×10-3 mρAl=2.8×10-8 ΩmρCu=1.7×10-8 ΩmV=10 VI=10 A

Q: aluminum cable has a resistance of 44 at 30C. calculate the resistance of the cable when the sun…

A: In this question we will find resistance at given temperature..

Q: A cell has a terminal voltage that changes from 1.5 volts to 1.4 volts when a 10 ohm load is…

Q: A 1m length of wire is found to have a resistance of 25Ω. If the diameter of the wire is 1mm,…

A: From the relation of the resistance, resistivity length and area we can calculate the value of…

Q: The insulation resistance of a cable of length 10 km is 1 MQ. its resistance for 50 km length will…

Q: A 20 meter length of cable has a cross-sectional area of 1mm2 and a resistance of 5 ohms. Calculate…

A: Resistance = resistivity×(Length of the conductor/cross section area of conductor). Conductivity =…

Q: It is the ratio of the potential difference between the two ends of the conductor to the current…

A: Ratio of potential difference between the two ends of the conductor to the current through the…

Q: In the circuit shown in the figure initially uncharged metal balls with radii a;b and a are…

A: (A) Potentials of balls connected at point 1 and 3 are not equal because there is potential…

Q: 1. Calculate the conductivity of 40m cable with cross-sectional area of 2.5m2. The resistance of the…

A: The resistance (R) of a wire of length l and cross-sectional area A can be expressed as In this…

Q: The simplest electric circuit (2 * contains only parts Two Three Four Five None of the above The…

A: The Simplest electric circuit contains three parts as bellow Source Load conducting path (wire)…

Q: 16 Another unit of measurement for electric field is in terms of _____. Select one: a.…

A: Given Electric field units

Q: You want to produce three cylindrical wires with a diameter of 1.00 mm, each with a resistance of…

Q: It is found that the resistance of a coil of wire increases from 40 ohm at 15°C to 50 ohm at 60°C.…

A: Use the given two conditions and find 2 equation

Q: A copper wire has a length of 3500 ft and having an area of 144 cm squared. Find the resistance of…

Q: B) Find the current in a circutar wire show i in figure (1) below if the current density is 20 a…

Q: QUESTION 9 "What happens to the resistance of a piece of wire, if it is strtched to double its…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Two wires, Wire A and Wire B, are made from the same material, but Wire A has a greater resistance…

A: Resistance R =(resistivity)×(Length/ area). From resistances of wires we will find resistance per…

Q: 23. is the measure of work required to move a unit charge from one location to another, against the…

A: In this question we will write about potential, dc current etc... Note:- due to bartleby policy, I…

Q: Two conductors, one of copper and the other of iron, are connected in parallel and carry equal…

Q: Calculate the conductivity of 25m cable with cross-sectional area of 6m2. The resistance of the wire…

Q: a) Determine the colour bands and indicate the resistance range values (minimum - maximum) for each…

Q: how much length must be cut off from the wire in order to reduce its resistance to 12.5 ohms.

A: Given, Resistance of a wire is 17.5 ohm, if its length is 560 m. Let, to reduce the resistance of…

Q: 2. Is there a linear relationship between current and voltage?

A: Ohm's Law- Ohm states that the current in a circuit is directly proposal to voltage and inversely…

Q: 1. Calculate the force developed per meter length between two current-carrying conductors 10 cm…

Q: An aluminum wire 7.5 meters long is connected in a parallel with a copper wire 6 meters long. When a…

A: According to the question we have to calculate the value of diameter of copper wire.

Q: A 1600m long copper cable is made up of 7 wires each having a diameter of 1.7mm. Calculate the…

A: Given Length l=1600 m Diameter d=1.7 mm Specific resistance ρ=1.75×10-8 Ω-m The cross-section area…

Q: Which of the following is true for conductive material? I. Electric current occurs when electrons…

A: We need to select correct option for electric current and conductors .

Q: Problem 13. Some copper wire has a resistance of 200 2 at 20°C. A current is passed through the wire…

Q: Problem 2.3] a wire having a diameter of 0.02mm and a resistivity at 20°C of 4.3µQ-cm. If a =…

Q: 3. It is found that the resistance of a coil of wire increases from 40 ohms at 15°C to 50 ohms at 60…

Q: Find the resistance of a piece of 8 AWG lead wire 600ft long. Consider the temperature to be 20…

Q: A 9V-battery is connected to a resistive strip that consists of three sections with the same…

A: Given Xs = 8.00mm ρ3 = 3.00 × 10-7Ωm Area of cross section is same for all three sections ρ1 = ? ρ2…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

Question 8

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

PROBLEM SOLVING NO. 2: A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.08 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 110 KV. Find the Voltage distribution across each unit. Draw the diagram.
in the 3 layer planar electrode system given below; a) Calculate the voltages and field strengths in the layers. Determine whether the system will be punctured or not.b) Calculate half of the voltage that can be applied to the system without any rupture in any layer of the system.
Calculate the electric field andanswer the follow up questions that follows.
In the circuit shown in the figure initially uncharged metal balls with radii a;b and a are connected with points 1 ;2;3 respectively with long thin conductors. Consider distance between balls to be much larger than their size; the charge on electric circuit itself and on connecting conductors is negligible and internal resistance of battery is zero. Choose correct option
Briefly explain why E = 0 inside a conductor? ‘A conductor is an equipotential’ give your opinion on this statement and explain your opinion. Show all calculation must. Don,t copy from another site or here. Answer must be correct
How many holes are there in a conductor?Please select one:a.Same number as free electronicsb.Only those produced with thermal energyc.Manyd.None
this is an electromagnetic field and waves lesson question. Please only give the correct answer. (for example correct answer is A,B ..etx) Since the two coaxial conductor cables in the above figure are insulated with a non-ideal insulator with a conductivity of σ, in which option the loss resistance is expressed correctly. A. None B. R=2ln(b/a)/(πσl) C. R=ln(b/a)/(πσl) D. R=ln(b/a)/(2πσl) E. R=ln(a/b)/(2πσl)
In the 3-layer planar electrode system shown in the figure; a) Calculate the stresses and electric field strengths in the layers. b) Determine whether the system will be punctured or not. c) Calculate the highest voltage that can be applied to the system without perforation in any layer of the system.
Consider the infinite wire carrying current of 2 A along positive y-direction. The other wire is carrying current of 1A along positive x direction from x= 4 m to x = 12 m. Calculate the force exert on second wire from the first wire. (a) 3.634x107 N (b) 4.394x10 N (c) 7.216x107 N (d) 9.631x107 N
Show complete solutions. Answer item 8.11 only
2. Imagine that you're asked to install an auxiliary grounding electrode at the base of a lighting pole in aparking lot. This auxiliary grounding electrode will be connected to theA. lighting pole's electrical service equipment grounding conductor.B. electrical service's grounding electrode conductor.C. next lighting pole's auxiliary grounding electrode.D. lighting pole's neutral conductor.
The illumination given out by a lamp is not necessarily the same in all directions. The candlepower of an arc lamp was measured in various directions; it was 250 C.P. directly downwards.; 1070 C.P. at 300 to the vertical. If this lamp is 8 m above the pavement, find the illumination directly under the lamp, and also on a screen at the place on the pavement corresponding to the 300 direction and placed perpendicular to the direction of the light.