Question: IdE 525521.12 N:313813.5741 E:525621.124 YN 313813.5741 6 E-525521.12... What is the area of the shape defined in a thick line in dunam units, square meters. Document your solution in a complete report with the drawings of the shapes separately Note: i = 268 10 E:525521.12 N:313813.57+i E:525621.12+i N:313813.57+i 16 E525621.12+i N:313778.57 E:525521.12 N:313778.57 6. 10 11 8 13 13 12

Question: IdE 525521.12 N:313813.5741 E:525621.124 YN 313813.5741 6 E-525521.12... What is the area of the shape defined in a thick line in dunam units, square meters. Document your solution in a complete report with the drawings of the shapes separately Note: i = 268 10 E:525521.12 N:313813.57+i E:525621.12+i N:313813.57+i 16 E525621.12+i N:313778.57 E:525521.12 N:313778.57 6. 10 11 8 13 13 12

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 2-meter long sub tense bar was first set-up at A and subsequently at B, and the subtended angle to the bar, as read from a theodolite position somewhere along the middle of the line AB, were recorded as 33’15” and 38’34”. Determine the length of line AB.
8.TAPE MEASUREMENTSa. A line was recorded as 1650.00 meters long. It is measured with a 0.65 kg standard tape30.00m long at 20°C under a 50N pull supported at both ends. During the measurementthe temperature was 5°C and the tape was suspended under a 75N pull. The line wasinclined on a 3% grade. What is the true inclined distance? E = 200GPa, A = 3.0 mm² andthe coefficient of linear expansion is 0.0000116 m/°C.b. A line was recorded as 2000.00 meters long. It is measured with a 0.65 kg standard tape30.00m long at 20°C under a 50N pull supported at both ends. During the measurementthe temperature was 5°C and the tape was suspended under a 75N pull. The line wasinclined on a 3% grade. What is the true inclined distance? E = 200GPa, A = 3.0 mm² andthe coefficient of linear expansion is 0.0000116 m/°C.
Note: a = 4.5 m b = 33.0 kN/m c = 13 kN
SHOW COMPLETE SOLUTION PLS VALUES: X = 853 Y = 53 A = 1
Q#1: A profile levelling is carried out and consecutive readings were observed on staff rod along a chain line at common interval of 10 meter which are listed below in table. First reading is taken on bench mark of 105.615 meter reduce level. Station Points Chainage (m) Staff Readings (m) Remarks BS IS FS 1 00 3.005 BM 2 10 2.285 3 20 1.560 4 30 1.785 5 40 2.105 6 50 2.875 3.105 CP 1 X 53.35 3.465 7 60 3.955 8 70 3.120 9 80 3.015 10 90 2.580 11 100 1.955 CP 2 Determine the reduce levels of all points using both line of collimation and rise and fall method. (Present your answer in table form).
show complete solution and fbd Given: F = 908 N θ = 24° μs = 0.33 find pmin and pmax
A line of level is run from B.M.I (elevation=106.40m) to B.M. 2 elevation=110.50m). The lield observations were recorded as given below:
Answer only C and D. note: a = 4.5 m b = 33 kN/m c = 13 kN
Select one: a. 3.76 in b. 4.83 in c. 5.21 in d. 3.52 in
Determine: Use 3 decimals a) The width of the base b) The value of cut at station B if it has an area of 16.82 sq.m. b) The Volume of A and B with prismoidal correction (use end area method)
With the same problem, compute the length of the last subchord. ANS = 11.87m
For the attached problem if D50 =0.8 mm, findthe N60 values at each depth. Use Eq attached with Kulhawyand Mayne values for a and c.