Question No.33 A single phase half bridge VSI has load R = 1.8 Q and DC source voltage 130 – 0 – 130 V. Find the power delivered to the load due to fundamental current.

Q: The Government decides to fix an automatic street light system for which light sensors are used. For…

A: Given,  Each street light (I. E output Y=1) is ON, if it receives positive output (I. E taken as…

Q: Find Ip in A (ampere) unit if E=11V, internal resistance Rp=41.4, and R=484N. (Answer should…

A: In this question,  We need to determine the current iD  if  E, RD  and R is given We know I= V/R

Q: solution. 1. Three resistors, 250, 45n, and 750, are connected in series, and a 0.51-A current…

A: We need to find resistance , power for given circuit

Q: 2 ΜΩ 1.4 ΜΩ 2 μΑ( 1.8 μΑ ( 3 ΜΩ 1) 4.1 μΑ 2.7 ΜΩ

A:

Q: 5) Choose the correct answer with the explain: a) The maximum power transferred to the load is…

A:

Q: What is the unit of the product of inductance and capacitance? A. second B. square of second C.…

A:

Q: A single-sideband signal contains 1 kW. how much power is at the carrier frequency? = _______? How…

A:

Q: SITUATIONAL ANALYSIS: Light bulb A is rated at 120V and 25W for household applications. Light bulb B…

A:

Q: A 200 V separately-excited dc motor has an armature resistance of 0.5 Ω. When the armature current…

A:

Q: Conductors A and B are connected in parallel. Their respective specific resistances are in the ratio…

A:

Q: Determine Vo for the circuit. - 5 V Vo Si 2.2 kN

A: The solution is given below  It's basic problem of diode only.  The Vo= -4.3 V

Q: 1. What are the minimum allowable ampacities of the phase conductors and the neutral conductor that…

A: Here given,V=230VP=30hpKnow that,1Hp=746WP=30×746=22380WCurrent,I=PV=22380230=97.3A

Q: A spectrum analyzer is used to measure the magnitude of a certain signal with respect to its…

A:

Q: Given the circuit below, find the new impedance if the frequency were halved. Round off to 4 decimal…

A:

Q: 5.4 Figure P5.4 illustrates a parallel T null circuit. Find the frequency , at which the V.0. R R…

A: Given the circuit, as shown below: We need to find the frequency ω0 at which the Vo→0.

Q: Please explain simply in detail, why Analog and Digital Electronics are important. Also please…

A: Electronic devices and their applications, are now a major part of our life. These embedded circuits…

Q: A certain circuit is composed of two parallel resistors. the total resistance is 1403 ohms. One of…

A: The solution is given below

Q: What is the full-load current of a 230-volt, 3-phase, 125-horsepower synchronous motor when it is…

A: The solution is given below

Q: Which of the following circuit elements is responsible for damping in an RLC series circuit? A.…

A: Oscillations of electrical energy are created between the electric field of capacitor and magnetic…

Q: identify the operation of the logic circuit shown. Write the name of the circuit in the space…

A:

Q: What is the approximate value of the total resistance. R2 RS R11 4 kOhm 4 kOhm 5 kOhm R128 kOhm R310…

A: In this question,  We need to calculate the equivalent resistance.  We know if two resistances R1…

Q: copper type THHN, and the supply is AC. 1. What is the full-load current of a 500-volt, DC,…

A: The solution is given below  This problem is from dc motor . Assuming there is no losses in motor.…

Q: During 50% modulation, what percentage of average output power is in the sideband?

A: We need to find sideband power

Q: Problem 01: A resistor of R= 80 ohm is connected in series with a capacitor of C = 50 µF with the…

A: We need to find impedance for series RC circuit

Q: 5-7. Determine the equivalent (total) resistance in the complex circuit below. Show your solution on…

A:

Q: 2. Show an example how you can construct a current sensor circuit for detecting a load current less…

A:

Q: Find the total current for the given network. 10 IT Ris z,s 25V- 12.5 312.5 312.5

A:

Q: Three signals of bandwidths 1 KHz, 3 KHz and 5 KHz. TDM is used and these signals are transmittec…

A: Three signals of bandwidths are 1 kHz, 3 kHz and 5 kHz. TDM is used and these signals are…

Q: 1. The signal power leaving a generator is 3 dBm. It is connectedto an amplifier by a cable 4 ft.…

A: We need to find out output power for given amplifier

Q: PART 1:Assume a high-pass filter with 80dB stop-band suppression and cutoff frequency of 100Hz. Now…

A: GIVEN: high pass filter               cut off frequency=100Hz              input signals…

Q: What is the total resistance. R2 R5 4kOhm 1kOhm R1 3kOhm R3 1kOhm R4 2kOhm R6 2kOhm

A:

Q: Suppose that you have a task of measuring the lengths of a bridge and a rivet and come up with 9999…

A:

Q: How do you calculate the effective resistance of a parallel circuit?  (Equation)

A: Consider the resistances that are connected in parallel are, R1,R2,R3..........,RN Consider the…

Q: A 5 kHz audio tone is used to modulate a 50 MHz carrier causing a frequency deviation of 20 kHz.…

A: Please find the detailed solution in below images

Q: 5. How many kWh of energy does a 550W toaster use in the morning if it is in operation for a total…

A: This problem is from electrical power generation

Q: 16-19. A 220-V household circuit that contains a 280-W refrigerator, a 1930-W air-conditioner, a…

A: In this question,  Check the connected fuse will melt or not if all equipment of the house hold are…

Q: 8-15. Fill out the table for the circuit diagram at the right. Show your solution on the space.…

A:

Q: Design a combinational circuit with the four inputs A,B.C, and D, and three outputs X, Y, and Z.…

A:

Q: A circuit composed of a 24-V battery and four resistors connected in a series connection, whose…

A: Current in series connection will be the same The voltage across the parallel connection will be the…

Q: 1. A capacitor is rated at x farad. If its minimum nominal tolerance value is 850uF, what is the…

A: As per guidelines we are supposed to answer only 1st Question so please upload others seperately..

Q: Each rivet has diameter of 12 mm and the thickness of each steel plate is 15 mi (a) Compute the…

A:

Q: Given two vectors Y = 5ax+ 7ay - 5az and S = 7ax - 10ay - 5az, find the angle between Y and Ś using…

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: 7. The bias voltage is set to +4.3 V. The output of the biased limiter shown will be clipped a.…

A:

Q: Determine the phase sequence of the set of voltages 200 cos(wt + 10°), vin = 200 cos(wt- 230°), ven…

A: In this question,  We need to determine the phase sequence of the given voltage waveform.  We are…

Q: B. Three capacitors 15 pF, 10µF, and 5µF are connected in parallel with a 10 v battery. Determine:…

A: In this question we have given 3 capacitors which connected in parallel....

Q: 7) Find gm, Zi, Zo, Av (0,617mS, 8.2MN, 1087N, 0.67) + 18V Ioss = 10mA Vi Vp =-3.6 V VssQ=-3.2V zi…

A: We need to find input, output impedance and voltage gain for given circuit

Q: Realize the given function with multilevel NOR gates. F=(W+Y)(X'+Z')(W'X'Y')

A: Given data: Boolean function  F=(W+Y)(X'+Z')(W'X'Y')

Q: Repeat problem 54 if a 22- resistor is added between VE2  and ground.

A: The required parameters can be calculated by using the DC analysis and AC analysis of the Darlington…

Q: A balanced abc-sequence Y-connected source with Van = A-connected balanced load (10+j2)Q per phase.…

A:

Q: Y Compute the admittance in millisiemens if R = 18 ohms XL = 23 ohms %3D Xc = 29 ohms all

A: This question belongs to circuit theory . It is based on the concept of calculation of admittance of…

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.