Answered: What is the full-load current of a…

What is the full-load current of a 230-volt, 3-phase, 125-horsepower synchronous motor when it is operated at an 80% power factor?

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter15: Residential Air-conditioning Control Systems

Section: Chapter Questions

Problem 10RQ

See similar textbooks

Related questions

Q: inverse laplace of (s/2+5/3)/(s^2+4s+6)

Q: Given a circuit below, calculate the admittance in millisiemens when R = 20 ohms, XL = 13 ohms, and…

A: In this question we need to find a admittance of the given circuit.

Q: 6.5 Determine the DTFT X(Q) for each of the following signals: (a) x[n] = 0.8l (b) x[n] = d[n +…

Q: on motor has a resistance of 0.012per hat must be the value of resistance per What is the percentage…

A: This is basic problem from induction motor

Q: A spectrum analyzer is used to measure the magnitude of a certain signal with respect to its…

Q: Using definition of inverse CTFT, find x(t) for the following X(2). a. X(N) = |X(N)|/X(N) with…

Q: the circuit below. Find the current (a) I, (b) lz. All Resistors are in ohms. 180 200 100 100 000 10…

A: We need to find out current for given circuit

Q: V, volts 12 3, metros <-5 12

A: We need to find electric field for given potential

Q: Determine Ip (in mA) for the network. 20 V Ip Ge Si 2.2 k2 6 4 V

Q: 1702 Volts Votts Figure 692

A: The solution is given below

Q: Three load units A, B and C are connected in parallel and take currents that are respectively 12, 10…

A: In this question, 3 loads are connected in parallel then find the total current IT ? If Three…

Q: Please show an illustration in detail and simplicity of Thevenin's Theorem

A: Thevenin's Theorem It states that with the help of single voltage source and series resistance we…

Q: E̶x̶p̶r̶e̶s̶s̶ ̶t̶h̶e̶ ̶f̶u̶n̶c̶t̶i̶o̶n̶ ̶F̶(̶A̶,̶ ̶B̶,̶ ̶C̶)̶ ̶=̶ ̶(̶A̶’̶ ̶+̶ ̶B̶)̶(̶B̶’̶ ̶+̶ ̶C̶)̶…

A: This has been solved using the properties of minterms.

Q: with a subtransient reactance of 0.1 pu, are connected through a line of reactance 0.1 pu on the…

A: The solution is given below

Q: solution. 1. Three resistors, 250, 45n, and 750, are connected in series, and a 0.51-A current…

A: We need to find resistance , power for given circuit

Q: For an H3E system with 80 percent modulation, what would be the i.) total transmitted power in W and…

Q: *30. Sketch v, for the network of Fig. 2.174 and determine the dc voltage available. + 100 V Ideal…

Q: A discrete-time periodic signal x[n] is real valued and has a fundamental period N = 5. The nonzero…

Q: an ac amplifi er using an op amp with coupling and by-pass capacitors, the output off set voltage…

A: In this question we will write output off set voltage in ac amplifier....

Q: A three-phase circuit has two parallel connected balanced loads. The first balanced delta load with…

A: The solution is given below

Q: Using mesh analysis solve for 11 12 13 14 5+j5 3-j3 3-j3 20V 25V/10) 1-j2

A: In this question, We need to calculate the mesh current in shown in the circuit using the mesh…

Q: II. SOLVE THE TOTAL CURRENT, Ir. (OHM'S LAW) SHOW THAT VRI + VR4 = 110 V. (VOLTAGE DIVIDER) IV.…

Q: 20 – 30. Fill out the table for the circuit diagram on the right. Show your solution on the space.…

A: We need to find out the current, voltage, resistance for given circuit

Q: A given periodical signal has O Exponenti Fourier Series O Trigonometric Fourier Series O All of…

A: Answer: ALL OF THEM Third option.

Q: Use CTFT properties and table to find time-domain or frequency-domain signal as required: a. Find…

A: As per our guidelines we are supposed to be answer the first question only. Kindly repost the other…

Q: Calculate the Vp-p with a given 4div vertical deflection reading, 0.5volts/div and 10 probe…

Q: 2e 2 e - O 8/ (s^2 + 6s +1) Os/(8s^2 + 6s +1) Os/(s^2 + 6s +1) O 1/(8s^2 + 6s +1)

Q: Find I (mA) unit if E1=10V, E2=-5.3V, R1=4.4kQ, and R2=1.5k2. (Answer should roundoff to 2 decimal…

Q: 16788 ohms. Express your answer up to two decimal places. ... V. 360 k2 12 kQ Round your answer to 2…

Q: I. SOLVE THE TOTAL RESISTANCE, R7. (SERIES-PARALLEL)

A: Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: i) Minimize the logic expression Y = BC + AC + AB using Boolean Algebra rules (Please show the…

Q: L{2 sin(t) cos(t)} s2+4 1 s2+4 s2+1

A: We need to find out Laplace transform of given signal

Q: What function of the phase angle is termed as the power factor in an RLC circuit? A. cosine B.…

A: This question belongs to electrical circuit theory . It is based on the concept of power factor of…

Q: A certain circuit is composed of two parallel resistors. the total resistance is 1403 ohms. One of…

A: The solution is given below

Q: In the adjustable-bandwidth circuit of Fig. 18-3, R, = 10 kl and R;, = 180 kN. If the 10o-2 resistor…

Q: an AM signal that has an equation: v(t) = {20 + 8sin(40 x 103t)}sin(30x 106t) V Determine the: (a)…

A: We need to analyse the given amplitude modulated signal

Q: Find all the right answers: Fourier Transform has following properties O Linearity time…

A: In this question, We need to choose the correct options What is Fourier transform property?

Q: A single-sideband signal contains 1 kW. how much power is at the carrier frequency? = _______? How…

Q: 6.47. A filamentary current of 1(A) passes down the z axis to z-5x 10m where it enters the portion…

A: Current density- It is define as the amount of the charge in per unit time which is directed to flow…

Q: 5-7. Determine the equivalent (total) resistance in the complex circuit below. Show your solution on…

A: In this question we need to find a equivalent resistance of the given circuit.

Q: Find the following signals FT (Hint: use FT pairs and FT propertise), Please write procedures (a)…

A: Fourier transform: This is a technique of converting the time domain signal into the frequency…

Q: A given wire has a length of 2 m and a cross-sectional area of 0.3 m2. If the resistance of the wire…

Q: (a) find the eddy current frequency of 50Hz (b) find the hysteresis loss in watt at a frequency of…

Q: If the current through x ohm resistance in the circuit is 5A, find the value of x. x ohm 12 ohm 135…

A: In this question we need to find a value of x.

Q: Solve the electric network. You may use any of the 3 solutions to SLE (Gauss Elim-REF, GJ-RREF, or…

Q: sine

A: We need to find out impedance for new frequency

Q: One input to an AM DSBFC modulator is an 800 kHz carrier with an amplitude of 40 vp. The second…

A: We need to analyse the amplitude modulated signal

Q: Calculate the equivalent capacitance, the equivalent charge, V1234, V67, and Q6.

Q: 8-15. Fill out the table for the circuit diagram at the right. Show your solution on the space.…

Q: 1. A cardiac defibrillator is used to shock a heart that is beating erratically. The capacitor is…

Question

All answers should be written in complete sentences. Calculations should be shown in detail, and Code
references should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC.

1. What is the full-load current of a 230-volt, 3-phase, 125-horsepower synchronous
motor when it is operated at an 80% power factor?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mathematical Modeling of Mechanical System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What is the full-load current of a 500-volt, DC, 20-horsepower motor?
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1.What is the full-load current of a 600-volt, 3-phase, 50-horsepower induction motor?
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What is the minimum conductor ampacity, overload protection, and dual-element fuserating for a circuit supplying a 560-volt, 3-phase, code J, 40°C, 125-horsepower motorwith a nameplate full-load current of 115 amperes?
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What is the minimum conductor size, overload protection, and inverse-time circuitbreaker rating for a circuit supplying a 230-volt, 3-phase, code A, 40°C, 75-horsepower synchronous motor operating at an 80% power factor with a nameplate full-load current of 185 amperes?
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What is the rated full-load current of a ¾-horsepower, 208-volt single-phase motor?
All answers should be written in complete sentences. Calculations should be shown in detail, and Codereferences should be cited when appropriate. Unless otherwise stated, all conductors are copper type THHN, and the supply is AC. 1. What are the minimum allowable ampacities of the phase conductors and the neutralconductor that are to supply a 2-phase, 3-wire, 230-volt, 30-horsepower motor?
Your Answers may be presented through Discussions, Drawings/Figures/Diagrams, Reference to NEC/PEC and Computations 6. What are the minimum allowable ampacities of the phase conductors and the neutral conductor that are to supply a 2-phase, 3-wire, 230-volt, 30-horsepower motor?
Your Answers may be presented through Discussions, Drawings/Figures/Diagrams, Reference to NEC/PEC and Computations. 8. What is the minimum conductor ampacity, overload protection, and dual-element fuse rating for a circuit supplying a 560-volt, 3-phase, code J, 40°C, 125-horsepower motor with a nameplate full-load current of 115 amperes?
Your Answers may be presented through Discussions, Drawings/Figures/Diagrams, Reference to NEC/PEC and Computations 9. What is the minimum conductor size, overload protection, and inverse-time circuitbreaker rating for a circuit supplying a 230-volt, 3-phase, code A, 40°C, 75-horsepower synchronous motor operating at an 80% power factor with a nameplate full-load current of 185 amperes?
A 25-HP, continuous-duty, three-phase squirrel-cage induction motor is connected to a 240-volt line. The conductors are run in conduit to the motor. The motor does not have a NEMA design code listed on the nameplate. The termination temperature rating of the devices is not known. Copper conductors with THWN insulation are to be used for the motor connection. What size conductors should be used?
A residential air-conditioning unit is installed in the attic. a. Is a lighting outlet required? __________ b. What Code section applies? __________ c. If a lighting outlet is required, how shall it be controlled? __________ d. What Code section applies? __________ e. Is a receptacle outlet required? __________ f. What Code section applies? __________
What is the minimum conductor ampacity, overload protection, and dual-element fuse rating for a circuit supplying a 560-volt, 3-phase, code J, 40°C, 125-horsepower motor with a nameplate full-load current of 115 amperes?