I just need help with the third one, please. The question is... (c) How long does it take the current in the circuit to reach 80 % of its final (long time) value? RConsider an RL circuit as shown in the Figure with V = 5 V, L = 10 mH, and R = 2000 2. After the switch has been left open for a long time, the switchis closed at t = 0.+(a) What is the current the instant after the switch is closed?VSubmit AnswerIncorrect. Tries 1/8 Previous Tries(b) What is the current a very long time after the switch is closed?2.50x10-3 AComputer's answer now shown above. You are correct.Your receipt no. is 163-2450 ePrevious Tries(c) How long does it take the current in the circuit to reach 80 % of its final (long time) value?Submit AnswerTries 0/8ll

V = 5 volts L = 10 mH = 0.01 H R = 2000 ohm

R Consider an RL circuit as shown in the Figure with V = 5 V, L = 10 mH, and R = 2000 Q. After the switch has been left open for a long time, the switch is closed at t = 0. + (a) What is the current the instant after the switch is closed? Submit Answer Incorrect. Tries 1/8 Previous Tries (b) What is the current a very long time after the switch is closed? 2.50x103 A Computer's answer now shown above. You are correct. Previous Tries Your receipt no. is 163-2450 e (c) How long does it take the current in the circuit to reach 80 % of its final (long time) value? Submit Answer Tries 0/8 ll

R Consider an RL circuit as shown in the Figure with V = 5 V, L = 10 mH, and R = 2000 Q. After the switch has been left open for a long time, the switch is closed at t = 0. + (a) What is the current the instant after the switch is closed? Submit Answer Incorrect. Tries 1/8 Previous Tries (b) What is the current a very long time after the switch is closed? 2.50x103 A Computer's answer now shown above. You are correct. Previous Tries Your receipt no. is 163-2450 e (c) How long does it take the current in the circuit to reach 80 % of its final (long time) value? Submit Answer Tries 0/8 ll

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 58P: Consider the circuit shown below. Find l1, l2and l3when (a) the switch S is first closed, (b) after...

See similar textbooks

Similar questions

A 120-V, series-wound motor has a field resistance of 80 and an armature resistance of 10. When it is operating at full speed, a back emf of 75 V is generated, (a) What is the initial current drawn by the motor? When the motor is operating at full speed, where are (b) the current drawn by the motor, (c) the power output of the source, [ d) the power output of the motor, and (e) the power dissipated in the two resistances?
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
How long after switch S1 is thrown does it take the current in the circuit shown to reach half its maximum value? Express your answer in terms of the time constant of the circuit.
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
Check Your Understanding (a) Calculate the self-inductance of a solenoid that is tightly wound with wire of diameter 0.10 cm, has a cross-sectional area of 0.90 cm2, and is 40 cm long. (b) If the current through the solenoid decreases uniformly from 10 to 0 A in 0.10 s, what is the emf induced between the ends of the solenoid?
Consider the circuit shown below. Find l1, l2and l3when (a) the switch S is first closed, (b) after the currents have reached steady-state values, and (c) at the instant the switch is reopened (after being closed for a long time).
What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose outer radius is 4.00 mm?
Check Your Understanding (a) If the current in the circuit of in Figure 14.12(b) increases to 909 of its final value after 5.0 s, what is the inductive time constant? (b) If R=20 , what is the value of the self-inductance? (c) If the 20 resistor is replaced with a 100 resister, what is the time taken for the current to reach 90% of its final value?
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
The square loop in FigureP20.62 is made of wires with atotal series resistance of 10.0 Ω.It is placed in a uniform 0.100-Tmagnetic field directed perpendicularinto the plane ofthe paper. The loop, which ishinged at each corner, is pulledas shown until the separationbetween points A and B is 3.00 m. If this process takes 0.100 s,what is the average current generated in the loop? What is thedirection of the current?
In the circuit below, the switch has been in the open position for a long time. At t=0, the switch is turned on. If the current at time t=1.1 ms reaches 75% of its maximum value, R=25 Ω, and ℰ=15 V, find:the maximum value of the current, Imax= A.the time constant τ= ms,the inductance L= mH.If the switch is open again, after what time, the current will reach 25% of its value?t1/4= ms.