R5 R6 6. 82 R7 11 R8 RLoad 7A 202 242 5.

Q: 3. The Si transistor has ß= 50 and negligible leakage current. Let VCC =18 V, VEE = 4V; Rg =2002 , a...

A:

Q: For a communication system, if 1. The power of the noise is 986 2. The SNR (as a ratio) is 8 3. The ...

A: The answer of both question is given below. I assume upper question as Q1 and lower question as Q2. ...

Q: Consider three information signals. If the bandwidth of the first one is 89, the bandwidth of the se...

A:

Q: A sample of pure Ge, has (2 mm) length, (1 mm) width, and (0.5 mm) thickness, the intrinsic resistiv...

A: We need to find required voltage for given current and resistance

Q: The voltage applied to a series RLC circuit is v = 200 sin 200t volts and the resulting current is i...

A:

Q: 1. You use power meter at a receiver with no signal measure a received noise power level of -110 dBm...

A:

Q: R1 R3 1 122 10Ω R2 R4 V1 RLoad 242 24V 4 2.

A:

Q: How can I make a regulated power supply with 1N4750A zener diode and 2N3904 transistor using this va...

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used nowaday...

Q: An armature has a resistance of 0.2 N at 150°C

A: Given-Resistance =0.2 ohm    at T=150°C Copper loss= 600 Watts at T=55°C Temperature coefficient, α ...

Q: If a fault occurs in connections C5 (stuck-at-1) for the following logic circuit, the appropriate fa...

A: The above figure shows a logic circuit in which many gates are interconnected together. At C5 fault ...

Q: : For the current waveform that shown in Figure belo w Find:- 1). Average value 2). R.M.S value 3). ...

A:

Q: Q4: Using Mesh analysis, find the currents loop in the circuit shown below: 7.5 kN R4 R1 9.1 k2 E, 3...

A:

Q: A three-stage amplifier has an input stage with noise ratio (NR)= 5 and power gain (PG) = 50. Stages...

A: Please refer the attached images for the complete answer..

Q: Problem 2: Given this network of capacitors: C2 C1 4 uF 1 uF C3 3 uF A- C4 2 uF C5 2 uf Assuming the...

A:

Q: single phase motor is rated 5hp, 75% pf lag,220V. What is the approximate size of capacitor is neces...

A: In this question we will find size of capacitor for power factor improvement....

Q: 20 kN )5 mA 33.6 kN_ vag5 kN 0.8 μF

A: We need to find unknown constant for given time constant and voltage across resistor for given circu...

Q: -3 A 3Ω -8 A -25 A Reference node (b) IFIGURE 4.4 (a) A four-node circuit. (b) Redrawn circuit with ...

A:

Q: 24 0- all tle 22 2H 3F Vi(t) %3D

A:

Q: The collector current Ic (see the circuit below) is:

A: The following circuit diagram is given:

Q: ま= %3D エ+ リ= [1 0]ェ %3D [-6]

A: SOLUTION- Ans- A = 0142 C = 10 L = L1L2  A-LC = 0142-L1L210               =   0142-L10L20           ...

Q: 2. Calculate the overall noise figure referred to the input of a mixer stage that has a noise figure...

A: Given,The noise figure of the input signal is,NF1 = 15dBThe noise figure of the amplifier is,NF2 = 6...

Q: てこりら V244vュ-4vgこ2 てひて 0=ャーを+ 0 सचो: पौ म てにれーてー少く ー ーりて 十+-V3 42 V-V2

A: Node Analysis- It is a method of considering an electrical circuit to find the unknown voltage, curr...

Q: What is the output and output and state equations that describe this * ?clocked sequential circuit

A:

Q: The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A, respective...

A: Alternator voltage  V = 300 v Alternator current  I = 20 A Voltage leads the current by an angle ¢ =...

Q: For an unmodulated carrier voltage of 15 Vp and a +2 V change in the amplitude of the envelope, dete...

A:

Q: How much BW would be required to transmit a DS-1 signal (1.544Mbps) using a four level code? (a) Ass...

A:

Q: Q5: Find I and Vs in the circuit of Fig. if the current through the 3-Q resistor is 2 A.

A:

Q: Example: If the analog signal to be quantized is a sinusoidal waveform, that is x(t) = Asin(2 x 103n...

A:

Q: 5. Avoltage having frequency of 50 Hz and expressed by V = 200 +j100 is applied to a circuit consist...

A: Current: It is the time rate of the change of the charges and its unit is ampere.

Q: find the value of I for the circuit

A:

Q: 1- A source emf of 5 V supplies a current of 3A for 10 minutes, the enery is provided in this time (...

A: The solution is given below 

Q: . Acoil having an impedance of (8 + j6) Nis connected across a 200-V supply. Express the current in ...

A:

Q: 3. What is the instantaneous peak voltage at 250° on a 6 V peak sine wave?

A:

Q: Briefly discuss the 10 electrical hazards in the laboratory and give the corresponding the preventiv...

A:

Q: For the following magnetic core with an air gap and dimensions as shown in the figure. The depth of ...

A:

Q: B) Write a PYTHON script to enter a value of S (between 1 and 3) for (60) entered values of X then f...

A: ALGORITHM: 1. Start2. Read 60 numbers and store them in X3. Read S value4. If S==1, initialize sum t...

Q: Determine the Laplace transform of f(t) shown in the figure

A: In this question,  We need to determine the Laplace transform of the given signals.  We are solving ...

Q: 2. Three impedances (2 + j4), (3 - j5) and (1 – j3) are connected in paralel. The combination is con...

A:

Q: hich Luenberger gain matrix would place observer poles at [-8,-16] for the system

A: It is given that: -8.-16x=1042x+51u˙y=10x

Q: A load of 20 + j35 Q is connected across a 220 V source. Determine the power factor. Ans: Choos

A:

Q: Q4: Using Mesh analysis, find the currents loop in the circuit shown below: 7.5 kN R4 R1 9.1 k E," 3...

A:

Q: Three uniform sheets of charge are located in free space as follows: 2µC/m² at x = -3, -5µC/m? at x ...

A: We need to find electric field at given point due given charge distribution

Q: Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply, c...

A:

Q: List two examples and explain the reasons regarding to the behavior of power electronics device belo...

A: Based on their ON and OFF condition of the Power Electronics devices it can be categorizes in three ...

Q: If the armature of an 8-pole machine were wound with a simplex wave winding, find the number of para...

A:

Q: The gain of a 5 stage network successively increases by 10 and the equivalent input resistance of ea...

A: Given information: In a five stage network the gain increases successively by 10. Gain of first stag...

Q: A parrallel resonant R= 5Kr, L=8mH, C=60UF Determine: The resonant Feeguency The band wid th Circuit...

A: The resonance is the point at which the response of the circuit will be maximum. At resonance the im...

Q: 10. A transformer on no-load takes 1.5 A at a power factor of 0.2 lagging when its primary is connec...

A: In this question,  No load current is given.  Io = 1.5A at the 0.2Power factor Secondary current Is ...

Q: 3. An impedance of (10 + j15) N is connected in parallel with an impedance of (6 -j8)N The total cur...

A: In this question we need to find a total Power of the given circuit.

Q: (a) The current flows through a 1mH inductor is given by i(t) = 20cos 100t mA Find the expression fo...

A:

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.