R₁=56 20v A) RTOTAL = B) I TOTAL = CV-TOTAL = R67 E) V3 11 R3-20 R₂=55 R5=45 R6 = 3 R₁-252 R7 = 3

Q: What is the steady-state error to a unit-step input R(s) R(s) + 6 C(s) s+3 Select one: O a. ess =…

A: Given, The system is Unit step input, Rs=1s

Q: Find the following parameters if B-120 for this transistor C. VCE d. VE RB 680kQ VCC 15V LRC 2.2kQ…

A: We need to find out the current and voltage for given circuit

Q: The switching period depends on the duration time Ton/T if the duty cycle D (0.25,0.50, 0.75) finds…

A: Given: D=0.25,0.5,0.75VS=32VR=6Ω

Q: When an op-amp is used as a comparator (as in the air-conditioning controller example), it must…

A: Op - Amp stands for operational Amplifier it is device through which we amplify signals and also…

Q: Find the following parameters iflg = 15.2 μA and Ve 12 V for this transistor. a. lc b. B C. VCE d.…

A:

Q: DATE: power 1 the voltage across given circuit is 75 +jsov. What is the supplied to the circuit if…

A: The power is the product of voltage and current. The maximum amplitude of voltage and current should…

Q: Find the input and output resistan and the Voltag gain Vcc=lov ≤ Rc=1kn RF-100k Rs=lokn 033MF m 12…

A: The given circuit diagram is shown below, Since the value of beta is not given. Considering β=100

Q: Qy A Transistor dissipates 50w in ambient temperature of fo, The thermal visistance are 8jc=0 · 5…

A: Pavg= Average rate of heat generated of a transistorTJ= Junction TemperatureTC= Case…

Q: An inductive impedance takes 11.5 A from a 115 V, 60 Hz ac supply. If the reactance of the inductive…

A:

Q: Three impedances, Zan = 20+j0, Zbn = 16+j12, Zcn = 5-j15 ohms, are connected in wye across a 230V…

A:

Q: Calculate the R.M.S value of the current waveform shown in figure below. 6 45 7 8 9 10 11 12 t i(t)…

A:

Q: 2. Draw unregulated dc voltage circuit using bridge rectifier circuit with a smoothing capacitor.…

A: Here we discuss about an unregulated power supply.

Q: Given an Emitter-Stabilized Bias Common Emitter amplifier with the following data: Vcc = 12 V, Ic =…

A: Given an Emitter - stabilized bias common emitter amplifier  4) to find the value of collector…

Q: 4. What will be the expected ohmic range of a resistor with a rating of 4000 Ω ± 10%? Group of…

A: Given data : Resistor rating=4000 Ω ± 10%

Q: Find the overall T-parameters of the following network.

A: Given circuit is a type of series connection of two port network. We can add Z parameters of each…

Q: Determine the approximate value of lp of Figure 522. VDD 17V 1.8kQ V, = 9.8V O 3.67 MA 4 mA 7 mA…

A: In this question,  We need to choose the correct options What is drain current?

Q: Find the impedance of a series RLC circuit if the inductive reactance, capacitive reactance and…

A:

Q: Find the magnitude of the impedance of a series RLC circuit if the inductive reactance, capacitive…

A:

Q: _______ action eliminates the offset described above by moving the controller output at a rate…

A: This is the  question related to the understanding of controller and it's various techniques.There…

Q: Q1: Using a 50 nF capacitor in the parallel RLC bandpass filter with a quality factor of 5 and a…

A:

Q: One branch A of a parallel circuit consists of a 50-uF capacitor. The other branch B consists of a…

A: It is given that: C=50μFRL=30ΩL=0.2HR=140Ω

Q: Calculate the equivalent noise temperature of a receiver with a noise figure of 1.5 dB.

A:

Q: R₁=5₂ 201 A) RTOTAL = B) I TOTAL = VTOTAL = R67 = E) V₂ R3-22 R₂=55 R5=45 R6 = 3 R4=25 M R7 = 3

A:

Q: A very long wire generates a magnetic field of 0.0070 × 104 T at a distance of 3.0 mm. What is the…

A:

Q: A series R-L-C circuit has the following voltages across its elements: V₁ = 43.3 V, V₁ = 40 V and Vc…

A:

Q: Q2. Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. Re LOKO RB Vcc Bpc = 50 www 20…

A:

Q: What will be the sign convention of the voltage if the current passes through the negative terminal…

A: Sign convention of the voltage source:

Q: Za= 10 ohms Zb = -j5 ohms Zc = 4+j4 ohms Zd= 6-j8 ohms Ze = 5 ohms Ea = 10 angle 0 Eb = 5 angle 0 10…

A:

Q: Q1. Given the fixed bias circuit with VCC = 12V, RB = 240 KS2, RC = 2.2 k2 and ß = 75. Determine the…

A: The given circuit is a dc fixed bias circuit. So for dc analysis all the capacitor gets open…

Q: 04: One branch A of a parallel circuit consists of a 50-uF capacitor. The other branch B consists of…

A:

Q: For the circuit of Fig. below, calculate the phase and line currents. 3012 173/9: V 30 12 173/120 V…

A: The given circuit can be redrawn and the current in the branch can be parameterized as shown.

Q: In a hybrid computer, the digital signals generated by a computer are sent via a modem, which…

A: Modem is a device used to convert the incoming digital signals to outgoing analog signals. ADC…

Q: A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input signal…

A: Given  A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input…

Q: An inductive impedance Z₁ is connected in series with a 5 ohm resistance. When 50 V at 60 Hz is…

A:

Q: 1 A circuit element draws 10A when connected to a 240V line. The time (in sec) required to consume…

A: Given: Current drawn by circuit element, I=10 A Supply, VS=240 V Energy consumed, E=12 kJ

Q: Design non-inverting amplifier circuit using op-Amp get Av= 10 ?

A:

Q: Q5: Choose the correct answer (solve in details if needed). 1. A resistor in a circuit has a value…

A: As per the guidelines of bartleby we supposed to answer first three MCQ question for solution of…

Q: Determine I1 and I2 and I3  using Kirchhoffs law

A:

Q: The power flowing in a three-phase, three-wire balanced load system is measured by the two-wattmeter…

A: Given Data, The reading on wattmeter A =5kW The reading on wattmeter B = -1kW

Q: 2.2) Drive the Boolean equations for the following relay ladder logics (a) SWI SW3 SW4 (120) | ²₂0]…

A: (a) The given relay ladder logic is shown below: The Boolean expression for the output Y20 can be…

Q: Q2.Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. Rc LOKO Vcc RB www Bpc = 50 10 V…

A:

Q: 2 The total charge entering a terminal is given by q=10(1-e') mC. The current at t = 1.609 sec is…

A: Given, Total charge entering a terminal q=101-e-t mC Time, t=1.609 s

Q: 1. The de emitter current IE is: A. 2.62 mA 2. The ac resistance re is: A. 8.67 2 B. 9.9222 3. The…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: In a balanced three-phase Y-Y system, the source is an abc sequence of voltages and Van = 148∠8°…

A:

Q: A diode conducts

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is…

Q: Question 23 of 60 Which of the following describe/s the phasor diagram shown. i 15° 60⁰° Select the…

A:

Q: The impedances Z₁ = 6 + j8, z₂ = 8 −jk, and z3 = 10 + j0ohms measured at 50Hz from three branches of…

A: this is a parallel circuit so first calculate the total admittance Y=1/(6+j8)+1/(8-j6)+1/(10+j0) =…

Q: ✓ 2 A G C₁ = C₂ = C3 = 2mF C4 C₁ = Cs = G6 = 4MF GG VAB = 10V CTOTAL- QTOTAL VTOTAL Q₁ = E) √34 = E…

A:

Q: 2.Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. R LOKO

A:

Q: In an n-type semiconductor material, the net flow of charge will be the flow of Blank 1. Blank 1 Add…

A: 1) n-type semiconductor material  2) if more impurities are added in the semiconductors, then their…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.