Answered: Rating of Fuse for the rated current of…

Engineering

Electrical Engineering

Rating of Fuse for the rated current of 7A is a. 7A b. 10.5A C. 3.5A d. 14A

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter14: Power Distribution

Section: Chapter Questions

Problem 14.5P

See similar textbooks

Related questions

Q: 1- What is Breakdown voltage?

Q: 1. When is the counter EMF at a minimum?

Q: What will happen to the fan if the rating of the fuse is 4A? Explain How does the resistance…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: In stranded conductor of 6 layers what will be the total number of individual wir ) 75

A: It is given that: Stranded conductor of 6 layers.

Q: Difference between circuit breaker and fuse...

A: Fuse- Fuse is used for the safety purpose of home equipment. It operates the over-current protection…

Q: Type of fuses and their discription

A: Solve the problem

Q: The current rating of the fuse is always less than its minimum fusing current O True False

A: We know that fusing factor shoulde be less than one. And fusing factor can be defined as the ratio…

Q: iii) full load rot

Q: What Is the opposite of redistance

A: Resistance R The property which is oppose flow of charge carriers( electrons ) .the element is…

Q: With neat diagram explain the principle of operation of Induction type energy meter.

Q: Draw the block diagram and clearly explain the operation of gas power station.

A: To explain gas power station

Q: Difference between circuit breaker and fuse.

A: Fuse: In the event that an electrical circuit's current has become too high, a fuse acts as an…

Q: Q.2 How many types of filament in tungsten filament lamp? & What are they?

A: Tungsten filament lamp : The lamp which have tungsten filament which give light after heating .…

Q: The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators.…

A: The solution can be achieved as follows.

Q: Differentiate the mechanism of electrical breakdown thet occurs in liquid and solid insulation.

Q: The positive sequence current is Times the current in neutral wire

A: A balanced three-phase system with the same phase sequence as the original sequence is called as the…

Q: Three types of electric devices A, B, and C are connected in series across a 115-volt ac source, and…

A: In thid question we will find given device types with given information...

Q: What are the working principle of air blast circuit breaker

Q: 10. A bare conductor can withstand higher levels of current than an insulated conductor of the same…

A: Note: As per our policy we can solve only one question at once, please reupload the remaining as a…

Q: Where must Type S fuses be installed? a. In all Edison-base fuseholders b. In all standard-base…

A: S Fuse be installed in all Edison base fuse holders. Because each fuse size has a separate base and…

Q: The resistance of the conductor increases with increase of Temper Select one: O True O False

A: There are three types of material, namely Conductor Semiconductor Insulator

Q: Define ohms law

A: According to the question we have to define ohm's law.

Q: 1. What is the function of Circuit Breaker? List different types of circuit breaker for High Voltage…

A: Circuit breakers:- Circuit breakers are mechanical (or automatic now a days) devices designed to…

Q: a brief reflection on ELECTRICAL MEASUREMENT UNITS

A: Measurement is the act of finding an unknown physical quantity by using a standard quantity. The…

Q: 3. The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators.…

A: Using given data we will find voltage across the other unit. bus bar voltage=3×total voltage across…

Q: How would you describ the flow of Alternating Circuit (AC) and Direct Current?

A: In direct current (DC), the electric charge (current) only flows in one direction and it is…

Q: What ampacity must all branch-circuit conductors used for wiring a ceiling outlet box be de-rated…

A: Dear student as per our guidelines we are supposed to solve only one question .kindly repost other…

Q: The incandescent bulbs rated respectively as P, and P, for operation at a specified mains voltage…

A: let the resistance of bulb P1 -is R1 and the resistance of bulb P2 is R2

Q: The minimum value of current at which the fuse element melts is called

A: The explanation is as follows.

Q: Determine each of the indicated currents. If the circuit has a 15-A fuse as shown, is the current…

Q: O FireWire

Q: For a voltage regulator circuit, the no load and full load voltages are 2500 V and 2122 V…

Q: three type of electric device A, B, and C are connected in series across a 115 volt AC source, and…

A: We will write three voltages in phasor form. We will use fact that source voltage is the phasor sum…

Q: Explain briefly the Lightning Strike Structural Procedures and what the external aircraft components…

A: The lightning flash originates with the formation of electrical charge in theair or, more commonly,…

Q: 1. Discuss the arcing phenomenon in a circuit breaker.

Q: c) DEFINE THE DUTIES OF RB1 AND RB2 RESISTORS.

A: Given circuit is Voltage Divider Bias Circuit.

Q: Discuss the arcing phenomenon in a circuit breaker

A: Arcing phenomenon in a circuit breaker

Q: 14 Which type of Insulator is used in Substations to support connections for High Voltage…

A: Which type of insulator is used in substations to support connections for High voltage switchgears,…

Q: write 4 points on working of nuclear power station

Q: Short note on PV operated lightning and water pump

A: photovoltaic lighting- photovoltaic lighting, or PV-powered lighting, is lighting that is at…

Q: A fuse use in electrical power system has.............. time current characteristics.

A: A Brief About Fuse:- Fuse is a device that breaks the circuit by melting itself when excessive…

Q: Explain briefly the Lightning Strike Structural Procedures and what the external components most…

A: It is asking to explain the Lightning Strike Structural Procedures. We will explain the lightning…

Q: . The three bus-bar conductors in an outdoor sub-station are supplied by units of post insulators.…

A: The solution can be achieved as follows.

Q: Three types of electric device A,B, and C are connected in series across a 115-volt a-c source, and…

Q: Mention the difference between Zener and avalanche breakdown.

A: Breakdown takes place in reverse biased p-n junction diodes. During break down, the value of the…

Q: Circuit breaker usually operate under A) after D. C. component has ceased B) transient state of…

A: Circuit breaker:- It is an electrical device which used as a switch for safety purposes. It protects…

Q: 4 Difference between circuit breaker and fuse...

A: Circuit Breaker Definition: A Circuit Breaker is a switching device which also offer protection…

Q: three type of electric device A, B, and C are connected in series across a 115 volt AC source, and…

A: In this question we need to find a voltage of device A , B , C

Q: 09. Which of the following are the passive elements?

A: Here both resistor and bulb are passive elements because they are not capable of delivering…

Q: Which type of Insulator is used in Substations to support connections for High Voltage Switchgears,…

A: Suspension type insulator is used for high voltage above 33KV .

Question

Rating of Fuse for the rated current of 7A
is
a. 7A
b. 10.5A
C. 3.5A
d. 14A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter and Scattering Parameter (S-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a 120/208V WYE configuration what is the voltage difference between any 'un-grounded to grounded' and 'un-grounded to grounding'?
The annual load duration curve of a power supply system may be considered as straight line from 40 MW to 8 MW. The load factor of the system is ?
Describe the concept of power system harmonics and their impact on the quality of electrical supply.
what is the Analysis of 3 Phase star connected circuit? please write introduction
please write introduction about Analysis of 3 Phase star connected circuit Note:please write details by words
A transmission line of 50 ohm characteristic impedance is terminated with a load of 200 ohm resistance. What will be the value of the minimum impedance measured on the line?
a. What is the unit load per ft2 for the general lighting load of a residence? ____ b. What are the demand factors for the general lighting load in dwellings? ____
The following problems refer to grounding requirements. Give the source of yourresponses. 1. What is the minimum size copper grounding electrode conductor for a service withthree sets of parallel 350 kcmil conductors (three conductors per phase)?
One advantages of load balancing is that each phase conductor carries the ? current value
A balanced 3-phase, 4-wire 400V system with a missing star to neutral connection, supplies a star connected load of Za (phase A), Zb Ω (phase B) and Zc Ω (phase C). Q: If the star to neutral voltage i.e. Vsn , is 132.7V reference, What is the voltage magnitude of Vas ?
Explain the concept of power quality and the impact of voltage sags, harmonics, and other issues on electrical equipment.
The feeder demand load for four 14 kW residential ranges is _____? [Reference Table 220.55 and Note 2]