Rawal Lake in Pakistan is an artificial reservoir that provides the water needs for the cities of Rawalpindi and Islamabad. Korang River along with some other small streams coming from Margalla Hills have been set to form this artificial lake. Korang River is the outlet stream of Rawal Dam as shown in the picture. If during the monsoon season the Korang river flows into lake at 2RN/3 m/s and other streams at RN/3 m/s while the out flow from the dam into Korang river is RN/2 m/s. Using the catchment and other data of Rawal Lake what will be rise in lake level in 24 hours. Rawal Dam, Islamabad

Rawal Lake in Pakistan is an artificial reservoir that provides the water needs for the cities of Rawalpindi and Islamabad. Korang River along with some other small streams coming from Margalla Hills have been set to form this artificial lake. Korang River is the outlet stream of Rawal Dam as shown in the picture. If during the monsoon season the Korang river flows into lake at 2RN/3 m/s and other streams at RN/3 m/s while the out flow from the dam into Korang river is RN/2 m/s. Using the catchment and other data of Rawal Lake what will be rise in lake level in 24 hours. Rawal Dam, Islamabad

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 30 mi² reservoir is fed by two streams that carry an average discharge of 350,000 cfs and 20,000 cfs, respectively. Determine the amount of discharge leaving the reservoir for the case when the reservoir is filling up at the rate of 0.3 ft/hr.
A concrete spillway which is used to control a reservoir area of 4 hectares has a permanent crest elevation of 40 m. Determine the length of the spillway if water can be drawn from elevation 41.5 m to 40.5 m in 24 minutes. Use Francis formula. a. 24.05 m b. 18.05 m c. 16.41 m d. 19.23 m
Reservoir B in the figure receives 0.06 m^3/s of flow. Determine the flow in line AD.
During a storm event, the measured discharge of the river to a reservoir is 58 cu. m. per sec (cms). If the rate of increase of the level of the reservoir is 1.4x10-4 m/s, determine the rate of discharge (in cms) of the reservoir to the intake tower for the purpose of water supply? Assume average surface area of the reservoir is 10 Ha.
1. Find the flow rate out of reservoir A. 2. Find the flow rate towards reservoir C. 3. What is the elevation of reservoir C.
A flow of 10 cfs enters a 1-mi? vertical walled reservoir. Find the time required to raise the reservoir level by 6 in.
Three reservoirs A, B, and C are connected by pipeline 1, 2 and 3 respectively which merges at a junction X. The elevation of reservoir A is 350 m and that of B is 290m. The rate of flow from A is 1.5 m^3/s. (See the table) 1. Compute the rate of flow in reservoirs B and C. Pipes Diameter Length Friction factor “f” 1 825 mm 1500 m 0.0155 2 650 mm 450 m 0.0165 3 450 mm 1200 m 0.0175
The reservoir's water flow traverses a 15-meter-long spillway, lowering the water's height from 83 meters to 81.5 meters, with the crest elevation at 80 meters, in 30 minutes. Apply C = 1.84. A) What is the reservoir's area?B) How long does it take to extract water from an elevation of 83 m/80.2 m? C) After 20 minutes, what is the water's ultimate elevation?
Spillway 12.9 m. long releases flood run off from a reservoir 5 hectares in area. If the reservoir level drops from elevation 55 m to 54 m. in 2520 sec. Find the elevation of the crest of the spillway in meters. Use Francis formula. Assume constant reservoir surface area. a. 71.5 m b. 53.5 m c. 24.8 m d. 63.2 m
A rectangular channel 3.05 m wide carries 3.4 m3/s uniform flow of water at a depth of 0.6 m. Suppose that an obstruction such as a weir is placed across the channel with the height of 0.2 m above the bottom. (a) Does this weir cause a hydraulic jump upstream of the weir? Why or why not? (b) Calculate the flow depth above the weir, and just upstream of the weir. Classify the surface profile occur upstream of the weir. Sketch the resulting water-surface profile and energy line, showing the critical depth yc and normal depth yo.
Engineering fluid … The crest of a high, broad-crested weir has an elevation of 100 m. If the weir is 10 m long and the discharge of water over the weir is 25 m3 ⁄ s, what is the water-surface elevation in the reservoir upstream?
In a flume of rectangular cross-section 1.75 m wide, water flowing at a depth of 0.35 m jumps to a depth of 1.2 m.1. What is the unit flow?2. Determine the discharge on the flume