Q2/ A reservoir has a spillway structure with the following relationship Q = 37.5y² S = 1.5 * 106 y² Where S is storage of reservoir and Y is the height of water level. Rout the following inflow hydrograph assuming that the initial storage and out flow is equal to zero. Time, hr. 0 1 2 3 4 5 6 7 8 Flow, m³/sec 0 200 300 500 400 300 100 50 0

Q2/ A reservoir has a spillway structure with the following relationship Q = 37.5y² S = 1.5 * 106 y² Where S is storage of reservoir and Y is the height of water level. Rout the following inflow hydrograph assuming that the initial storage and out flow is equal to zero. Time, hr. 0 1 2 3 4 5 6 7 8 Flow, m³/sec 0 200 300 500 400 300 100 50 0

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Reservoir B in the figure receives 0.08 m3/s of flow. Properties of each pipe: Pipe # 1: Length = 1800 m., Diameter = 550 mm, f = 0.0204 Pipe # 2: Length = 600 m., Diameter = 250 mm, f = 0.0223 Pipe # 3: Length = 750 m., Diameter = 350 mm, f = 0.0226 Elevation A = 120 m. Elevation C = 60 m. Determine the following: 1. Flow in pipe 3. (Ans : 0.41259) 2. Headloss in pipe 2. (Ans : 7.243) 3. Elevation of Reservoir B. (Ans : 98.134) Show solution.
reservoir b in the figure receives 0.09 m^3/s of flow. Properties of each pipe: Pipe # 1: Length = 1800m, Diameter = 450 mm, f = 0.0204 Pipe # 2: Length = 650m, Diameter = 250 mm, f = 0.0177 Pipe # 3: Length = 700m, Diameter = 400 mm, f = 0.0226 Elevation A = 150 m. Elevation C = 60 m. Determine the following: 1. Flow in Pipe # 3 a. 0.50273 b. 0.51946 c. 0.46104 d. 0.41259 e. non of the above 2. headloss in Pipe # 2 a. 7.882 b. 8.660 c. 7.178 d. 7.243 e. none of the above 3. elevation of reservoir B a. 98.134 b. 81. 431 c. 84.370 d. 87.875 e. none of the above
Given is the flow of a channel of large width b under a sluice gate. Let V1 = 0.75 m/s and V2 = 4 m/s. Estimate (a) y2, (b) Fr2, and (c) q, the flow rate per unit width Choices: y2 = 0.150 m, Fr2 = 2.5, q = 0.600 y2 = 0.188 m, Fr2 = 2.95, q = 0.752 y2 = 0.125 m, Fr2 = 2.20, q = 0.650 y2 = 0.182 m, Fr2 = 3.0, q = 0.726 None of the Choices
A rectangular canal 2.24 m wide and 1.12 m deep has a full capacity of 8 m3/s. Assuming n = 0.0152 what is the slop of thechannel bed?0.005090.000810.002830.00182
A reservoir 15m deep has a rectangular weir with a length of 1.9m situated at its short side. When observed from above, the reservoir is shaped like a rectangle whose dimensions are 13m x 29m. If the overflow above the crest was intiially 1.9, how much time (mins) does it take to discharge 288,798 liters or water. Assume a weir factor of 0.64.
Three reservoirs are connected by individual pipes to junction O as shown on the figure below. Find the elevation of reservoir C in order that the discharge in pipe AO from reservoir A is 0.15 cubic meter per second. Use Darcy-Weisbach formula with f = 0.02. Draw the final hydraulic gradient line (HGL). Reservoir Discharge, Q (m^3/s) Diam., D (cm) Length, L (km) WS elev. (m) A 0.15 (out) 35 1.40 145 B ? 25 0.90 125 C ? 30 1.60 ?
Find the discharge through a trapezoidal channel of 8 m wide and side slopes of 1 horizontal to 3 vertical. The depth of flow is 2.4 m and Chezy’s constant C = 55. The slope of bed of the channel is 1 in 4000
SITUATION 10: Water is flowing at a depth of 1.5 m in a 3 m wide rectangular channel having n=0.013 and s=0.009.30. What is the stage of flow? a. supercritical b. turbulent c. laminar d. subcritical31. Determine the critical slope. a. 0.0324 b. 0.00423c. 0.00324 d. 0.042332. Determine the critical depth. a. 0.58 m b. 2.86 m c. 3.04 m d. 0.94 m
Question-05:A trapezoidal notch having bottom width of 1.0 m is installed in a 2.0 m X 2.0 m rectangular channel. Solve fordischarge through the notch in cubic meter per minute if the depth of water flowing in the notch is 1.5 m. Takethe coefficient of discharge for the notch as 0.64.
Water flows in a wide channel at Fr=4.5 and y1 = 2.40 m. If the flow undergoes a hydraulic jump, calculate: y2
Calculate the discharge of water for an open channel from the following data: (i) a rectangular cross section (bottom width = 6 m, and flow depth = 4 m); (ii) Manning's n = 0.016; (iv) channel bottom slope = 20 cm per 500 m channel length.
A hydraulic jump forms in a 3-m wide rectangular channel that carries a discharge of 10 cms. The depth downstream of the jump is measured to be 2.5 m. What is the percentage of energy lost in the jump? a. 33.07% b. 44.58% c. 55.42% d. 66.93%