Referring to Fig. compute the maximum force P that can be applied by the machine operator, If the shearing stress in the pin at B and the axial stress in the control rod at C are limited to 4000 psi and 5000 psi, respectively. The diameters are 0.25 inch for the pin, and 0.5 inch for the control rod. Assume single shear for the pin at B. Figure P-121 2 in 10 MATHno.oo 6 in 2 in

Referring to Fig. compute the maximum force P that can be applied by the machine operator, If the shearing stress in the pin at B and the axial stress in the control rod at C are limited to 4000 psi and 5000 psi, respectively. The diameters are 0.25 inch for the pin, and 0.5 inch for the control rod. Assume single shear for the pin at B. Figure P-121 2 in 10 MATHno.oo 6 in 2 in

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 73AP: Two thin rods, one made of steel and the other of aluminium, are joined end to end. Each rod is 2.0m...

See similar textbooks

Similar questions

Review the relationship between stress and strain. Can you find any similarities between the two quantities?
Check Your Understanding Explain why the concepts of Young’s modulus and shear modulus do not apply to fluids.
Alarge uniform cylindrical steel rod of density =7.8g/cm3 is 2.0 m long and has a diameter of 5.0 cm. the rod is fastened to a concrete floor with its long axis vertical.what is the normal stress in the rod at the cross-section located at (a)1.0 mfrom its lower end?(b)1.5 m from the lower end?
Two thin rods, one made of steel and the other of aluminium, are joined end to end. Each rod is 2.0m long and has cross-sectional area 9.1mm2 . If a 10,000N tensile force is applied at each end of the combination, find: (a) stress in each rod; (b) strain in each rod; and, (c) elongation of each rod.
Can compress stress be applied to a rubber band?
A 90-kg mountain climber bangs from a nylon rope and stretches it by 25.0 cm. If the rope was originally 30.0 m bog and its diameter is 1.0 cm, is Young’s modulus for the nylon?
Normal forces of magnitude 1.0106N are applied uniformly to a spherical surface enclosing a volume of a liquid. This causes the radius of the surface to decrease from 50.000 cm to 49.995 cm. What is the bulk modulus of the liquid?
The pressure dam early in problems section increases with depth. Therefore, there is net torque on the dam. Find be net torque.
If a hypothetical material has a negative bulk modulus, with happens when you squeeze a piece of it?
Check Your Understanding A 2.0-m-long wire stretches 1.0 mm when subjected to a load. What is the tensile strain in the wire?
One end of a vertical metallic wire of length 2.0m and diameter 1.0mm is attached to a ceiling, and the other end is attached to a 5.0N weight pan, as shown below. The position of the pointer before the pan is 4.000cm . Different weights are then added to the pan area, and the position of the pointer is recorded in the table shown. Plot stess versus strain for this wire, then the use the resulting curve to determine Young’s modulus and the proportionality limit of the metal. What metal is this most likely to be?
Check Your Understanding Find the compressive stress and strain at the base of Nelson’s column.