Referring to the figure below, with Rs = 0.82 kohms Determine Dc value of Ic, Ib and Ie Determine re . Find Avmid = Vo/Vi.

Q: piece of communication equipment has two stages of amplification with gains of 40 and 60 and two…

A: In this question we will find overall gain and input voltage....Power gain...

Q: 5-18. For a three-stage, double-tuned RF amplifier with an RF equal to 1000 kHz and a ce of coupling…

A: In this question three stage double tuned amplifier is given....We have to find out bandwidth for…

Q: O a. Light-emitting diode • b. none of these c. Zener diode • d. Back diode

A: Given statement  A blown-fuse visual indicator uses

Q: A capacitor is a device that: O A. Transforms electrical energy into heat energy O B. Stores energy…

A: We need to select correct option for capacitor

Q: 2. A full wave rectifier is used to convert 400 Hz ac tode Desi a full-wave rectifier power supply…

A:

Q: From the following figure, find the number of 10 lateral ties and tie wire if there are 36 columns…

A: The given figure is shown below:

Q: Q1- A universal motor with 120V,50 Hz,2 poles. runs at speed 7000 rpm and draws full load current…

A: The solution is given below

Q: A parallel plate capacitor with plate area of 5 cm and plate separation o 3 mm has a voltage 50 sin…

A: In this question parallel plate capacitor is given...We have to find out displacement current and…

Q: A logic gate has a triangular shoot through current of 8mA and switches in 2ns. How much inductance…

A: Given: A logic gate having triangular shoot through Current, ∆i=8 mA Time, ∆t=2 ns Noise voltage,…

Q: The cylindrical surface ρ = 8 cm contains the surface charge density, ρS = 5e−15|z| nC/m2. What is…

A: In this question cylindrical surface with surface charge density is given...We have to find out to

Q: A square bar carries a series of loads as shown. Compute the load (kN) and stress (MPa) in each…

A: Assume←→ +ve tensile→← -ve compressiveNow,∑ FH=0RA-90kN+40kN-100kNRA=150 kN  +ve tensile in…

Q: 1. Explain briefly in one(1) sentence how do we maximize the value of the armature current in a…

A: (1) When the load gets added to shunt wound DC motor the speed gets reduced and along with the speed…

Q: How can the error amplifier control the output voltage of a buck converter? Please explain.

A: Types of DC-DC Converters Buck Converter Boost converter Buck-Boost Converter Flyback Converter…

Q: Voltage sags due to short circuit and earth faults are the cause for the vast majority of equipment…

A: Power Quality Problems Voltage sag Voltage swell Voltage spike Voltage fluctuation Harmonics Long…

Q: A Short shunt compound generator delivers a load current of (16)A at 400V.  Armature resistance 0.08…

A:

Q: 1. Sketch V and determine Vdc Vrms- 100Y 4.7 12 54 k Si 本

A:

Q: Q/ Use The following circuit to design an oscillator of 5KHZ out The amplifier used in this…

A:

Q: A parallel RLC circuit has the following component values: R = 6.25 ohms, L = 500 mH, and C= 5 mF,…

A:

Q: Qu. Driye a formal the capacitance of infiunit lengh Coaxial cable and then find the Capacilance of…

A:

Q: Determine the value of capacitance, C in the circuit shown in Figure Q1(a), given the equivalent…

A:

Q: The Schottky diode is used a. in high-power circuits. • b. in circuits requiring negative…

A: This question belongs to analog electronics . It is based on the concept of schottky diode and zener…

Q: A 220V short-shunt compound generator has armature resistance, series field resistance and shunt…

A:

Q: A receiver outputs a 2 V signal with 320 mV noise. Calculate its SNR as a ratio (i.e., in linear…

A: Given data, A receiver has Output voltage, V0=2 V Noise voltage, Vn=320 mV

Q: For a specific application, the circuit shown in Fig. 2.140 was designed so that I, = 90 mA and that…

A:

Q: Given F(s) = 1/((s+1)(s+3)), the f(t) would be: O A. Exponentially decaying O B. None of the choices…

A:

Q: Q2: Calculate the reading that would be observed on a moving-iron ammeter when it is measuring the…

A: The solution is given below

Q: In a dc shunt motor, at 4 Amp the torque developed is 20 Nm. If the load current doubles, what is…

A: In this question we need to find a torque.

Q: If the voltage v, across the 2-N resistor in the circuit of Fig. 9.58 is 10 cos 2t V, obtain i̟.

A:

Q: Consider a series RC circuit as in Figure below for which R 2.2 MO, C=8.4 pF, and e=30.0 V. Find the…

A: Given circuit: R=2.2 MΩ=2.2×106 ΩC=8.4 μF=8.4×10-6 F

Q: What will be the voltage of point A with respect to B? A 15 V 10 0: 1) 6 A В ww

A:

Q: Draw the cascade connection of two amplifiers. Wri

A: the cascaded connection of two amplifiers are shown

Q: Find the power dissipated by 1-ohm resistor. 10 Ω ww 6 V 10 4Ω 8 V O 1.42 W O 1.06 W O 26.37 mW O…

A:

Q: Given the sinusoids v1(t) = 8cos (250t +15°) V and v2(t) = 6cos (250t – 45°) V, determine the time…

A: In this question we will find the time by which v2(t) is advanced or delayed with respect to…

Q: A logic gate switches in 5ns and has a triangular shoot through current with a peak value of 8mA.…

A: Given data, Time, dt=5 ns Current, i=8 mA Voltage, dV=150 mV

Q: What is the voltage across a capacitor after being charged from a 10 V DC source for a period of one…

A:

Q: Find Rth, Vth

A:

Q: 47. For the circuit of Figure 2.50, determine the voltages across each component. The source is a 2…

A: In this question we will find voltage across each component....

Q: What are the values of Vc and Ve from the circuit shown below. +IDV 3.3 kf2 B- 110 3.9 k2 O-12 V O…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: Solve for line currents. IaA, IbB, IcC.

A:

Q: what can be observed in series wherein resistors with the same ohmic value

A:

Q: Find the total real power dissipation in a balanced wye-delta system. Load impedance is 5kN270° and…

A: It is given that: Vp=320 VZ△=5∠70° KΩ=5×103 ∠70° Ω

Q: Find ww 12 2 Vỵ, Vc, lo Answer: 45e-0.251 V, 15e-0.251 V, -3.75e -0.251 A. Him

A: The solution is given below

Q: A hydroelectric power plant discharging water at the rate of 0.75 m³/sec and entering the turbine at…

A: a) The net effective head of the turbine is calculated as shown below:  hnet=Pρg+v22g+zz=2 mg=9.8…

Q: The current in a 20 mH inductor has the waveform shown in Figure Q1(c). Draw the waveform for the…

A: We need to find out voltage across inductor

Q: Question 5 and 6 are based on this diagram. R(s) E(s) 4 C(s) s(s + 3) 5. The block diagram has the…

A: We need to tell about feedback and we need to find out transfer function for given system

Q: During the transient analysis of an RL circuit, if the current through an inductor is 1.5 A at t =…

A: The current through the inductor cannot change instantaneously. So the current at t =0 sec will be…

Q: 6. Find a closed form for the generating function for the se- quence {a,}, where b) a, = 2" for n =…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Calculate the voltage drop developed across a d'Arsonval meter move- ment having an internal…

A:

Q: Ans[675 r.p.m; 1.45] .025 /phase and a rotor num? What proportion of 18 ans[562.5 r.p.m: 0.47] 9 9.

A:

Q: Please explain why the settling time of the error amplifier output takes longer when the Gain…

A: Settling time- It is define as the required time y the output in which it reach and be in a error…

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.